fog light bulb TOYOTA PRIUS 2001 Service Repair Manual

BE±8
± BODY ELECTRICALTROUBLESHOOTING
1675 Author: Date:
2001 PRIUS (RM778U) Shift position indicator light does not light up.
1. ECM
2. Shift Position Sensor
3. HV ECU
4. Meter Circuit Plate
5. Wire Harness±
HT±54
±
BE±39
±
CRUISE indicator light does not light up.
1. Bulb
2. HV ECU
3. Meter Circuit Plate
4. Wire Harness±
±
BE±39
±
DEFOGGER SYSTEM
This system uses the multiplex communication system, so check diagnosis system of the multiplex commu-
nication system before you proceed with troubleshooting.
SymptomSuspect AreaSee page
Rear window defogger does not operate.
1. DEF M±Fuse
2. Defogger Relay
3. Defogger Switch (in A/C Amplifier)
4. Defogger Wire
5. Wire Harness
6. Body ECU
7. Noise Filter
8. A/C ECUBE±12
BE±49
DI±864
BE±49
±
DI±678
±
DI±864
Mirror heater does not operate.
1. M±HTR Fuse (Passenger SIde J/B)
2. Mirror Heater Relay
3. Mirror Heater
4. Wire HarnessBE±12
BE±49
BE±49
±
POWER WINDOW CONTROL SYSTEM
This system uses the multiplex communication system, so check diagnosis system of the multiplex commu-
nication system before you proceed with troubleshooting.
SymptomSuspect AreaSee page
Power window dose not operate.
1. ECU B Fuse
2. GAUGE Fuse
3. Power Main Relay
4. Ignition Switch
5. Power Window Master Switch
6. Body ECU
7. Wire HarnessBE±12
BE±12
BE±56
BE±17
BE±56
DI±678
±
Only the driver's window does not operate.
1. Power Window Master Switch
2. Power Window Switch
3. Power Window Motor
4. Wire HarnessBE±56
BE±56
BE±56
±
ºWindow lock functionº does not operate.Power Window Master SwitchBE±56
Illumination does not light up.Power Window Master SwitchBE±56

BE1D5±03
I17792
8 71
I17793
I01200
2 1
35
2 5
1 3
± BODY ELECTRICALDEFOGGER SYSTEM
BE±49
2001 PRIUS (RM778U)
INSPECTION
1. INSPECT DEFOGGER TIMER OPERATION
(a) Connect the positive (+) lead from the battery to terminal
1, 8 and negative (±) lead to terminal 7.
(b) Connect the positive (+) lead from the battery to terminal
5 through a 3.4 W test bulb.
(c) Turn the defogger switch ON and check that the indicator
light and test bulb light up for 12 for 18 minutes, then the
indicator light and test bulb lights go out.
If operation is not as specified, inspect the A/C amplifier.
2. INSPECT DEFOGGER SWITCH CIRCUIT
Connector disconnected:
Disconnect the connector from the switch and inspect the con-
nector on wire harness side, as shown in the chart.
Tester connectionConditionSpecified condition
1 ± GroundIgnition switch LOCK or ACCNo voltage
1 ± GroundIgnition switch ONBattery positive voltage
7 ± GroundConstantContinuity
8 ± GroundConstantBattery positive voltage
If the circuit is not as specified, replace the switch.
3. INSPECT DEFOGGER RELAY CONTINUITY
ConditionTester connectionSpecified condition
Constant1 ± 2Continuity
Apply B+ between
terminals 1 and 2.3 ± 5Continuity
If continuity is not as specified, replace the relay.