check engine TOYOTA PRIUS C 2019 Owners Manual (in English)
[x] Cancel search | Manufacturer: TOYOTA, Model Year: 2019, Model line: PRIUS C, Model: TOYOTA PRIUS C 2019Pages: 48, PDF Size: 5.82 MB
Page 7 of 48

5
Headlight low/high
beam indicator
Turn signal indicator
Immobilizer system indicator
READY indicator
Electric power steering system warning1
Eco Mode indicator
EV Drive Mode indicator
EV drive indicator
Pre-Collision System (PCS) warning1,2
Master warning1,2
Malfunction/Check Engine indicator1
Low tire pressure warning1
Low outside temperature indicator
Low fuel level warning
Lane Departure Alert (LDA) indicator
Parking brake warning
Vehicle Stability Control
(VSC) OFF indicator1
Shift position indicator
Slip indicator/Hill-start Assist Control
indicator
1,3
OVERVIEW
FEATURES & OPERATIONS
TOYOTA SAFETY SENSE
SAFETY & EMERGENCY FEATURES
1
If the indicator does not turn off within a few seconds of starting the \
Hybrid system, there may be a
malfunction. Have the vehicle inspected by your Toyota dealer.
2 If the indicator flashes, there may be a malfunction. Refer to the Owner\
’s Manual.3 If the indicator flashes, it indicates that the system is operating.4 If equipped.
49125b_MY19_Prius_c_QRG_V2_ML_0713.indd 57/20/18 8:33 PM
Page 9 of 48

7
Smart Key system (if equipped)
NOTE: The smart key must be carried to enable the start function. With the
Park position selected and the brake pedal depressed, push the “POWER”
switch.
Fuel tank door release & cap
Accessory – Some electrical components can be used.
On - All electrical components can be used.
Off - All systems OFF. Emergency flashers can be used.
POWER ON
POWER ON
Without depressing the brake pedal, pressing the “POWER” switch wi\
ll change the
operation mode in succession from:
Store
OVERVIEW
FEATURES & OPERATIONS
TOYOTA SAFETY SENSE
SAFETY & EMERGENCY FEATURES
Turn to open
Pull
START FUNCTION
POWER (WITHOUT STARTING HYBRID SYSTEM)
NOTE: Tighten until one click is heard. If the cap is not locked or tightened,
Check Engine “
” indicator may illuminate.
49125b_MY19_Prius_c_QRG_V2_ML_0713.indd 77/20/18 8:33 PM
Page 29 of 48

27
OVERVIEW
FEATURES & OPERATIONS
TOYOTA SAFETY SENSE
SAFETY & EMERGENCY FEATURES
DISABLING PRE-COLLISION SYSTEM (PCS)
To disable the system
Press the PCS switch for 3 seconds or more.
The
will turn on and a message will be displayed on the
Multi-Information Display (MID).
To enable the system
Press the PCS switch again. The system is enabled.
Note: PCS is enabled each time the engine switch is turned to Ignition O\
n.
The system can be disabled/enabled and the alert timing of the system ca\
n be
changed. (Alert timing only, brake operation remains the same).
Refer to a Toyota Owner’s Manual for additional information on PCS w/\
PD
operation, settings adjustments, limitations, and precautions before att\
empting to
use it.
Lane Departure Alert (LDA)
LDA in TSS-C uses an in-vehicle camera designed to detect visible white \
and yellow
lane markers in front of the vehicle and the vehicle’s position on th\
e road. If the system
determines that the vehicle is starting to unintentionally deviate from \
its lane, the system
alerts the driver with an audio and visual alert. When the alerts occur,\
the driver must
check the surrounding road situation and carefully operate the steering \
wheel to move
the vehicle back to the center part of their lane.
LDA is designed to function at speeds of approximately 32 MPH or higher \
on relatively
straight roadways.
49125b_MY19_Prius_c_QRG_V2_ML_0713.indd 277/20/18 8:33 PM