turn signal bulb TOYOTA RAV4 1996 Service Repair Manual

1999-2000 ACCESSORIES & EQUIPMENT
Instrument Panels - Trucks
DESCRIPTION & OPERATION
GAUGES
Standard instrument clusters contain fuel and temperature gauges with telltale warning lights. Some optional
instrument panels are equipped with a tachometer, oil pressure gauge and voltmeter. Gauge internal operating
components use either a 2-terminal bimetallic strip type or a 3-terminal coil type. The 2-terminal type gauges
are generally used on clusters without tachometers.
SWITCHES
All models contain hazard warning switch on instrument panel. All models use a combination switch for
headlight, turn signal, wiper/washer, and cruise control switches. Combination switch is mounted on steering
column. For testing and/or removal and installation procedures for combination switch components, see
appropriate STEERING COLUMN SWITCHES article.
COMPONENT TESTS
A/T OIL TEMPERATURE SWITCH
RAV4
1. Turn ignition switch to OFF position. Disconnect A/T oil temperature switch 1-pin connector. Switch is
located on side of transaxle, near park/neutral position switch. Remove A/T oil temperature switch. Place
probe end of switch and thermometer in a container of water.
2. Connect an ohmmeter between switch terminal and switch body. Heat water and check for continuity.
With temperature at 284-302°F (140-150°C), continuity should exist. If continuity does not exist, replace
switch.
A/T OIL TEMPERATURE WARNING LIGHT
RAV4
Disconnect A/T oil temperature switch connector. Switch is located on side of transaxle, near park/neutral
position switch. Using a jumper wire, connect switch connector terminal to ground. Turn ignition switch to ON
position. A/T oil temperature warning light should be on. If warning light is off, check bulb and wiring harness.
Repair as necessary. WARNING:Deactivate air bag system before performing any service operation. See
AIR BAG RESTRAINT SYSTEMS article. DO NOT apply electrical power to
any component on steering column without first deactivating air bag
system. Air bag may deploy.

1999 Toyota RAV4
1999-2000 ACCESSORIES & EQUIPMENT Instrument Panels - Trucks

1999 Toyota RAV4
1999-2000 ACCESSORIES & EQUIPMENT Instrument Panels - Trucks
Microsoft
Sunday, November 22, 2009 10:54:09 AMPage 1 © 2005 Mitchell Repair Information Company, LLC.
Microsoft
Sunday, November 22, 2009 10:54:14 AMPage 1 © 2005 Mitchell Repair Information Company, LLC.

TURN SIGNAL FLASHER
Except Land Cruiser & Tundra
Remove turn signal flasher. See TURN SIGNAL FLASHER LOCATION table. At turn signal flasher
terminals, connect positive battery lead to terminal No. 2. See Fig. 7
. Connect negative battery lead to terminal
No. 3. Connect 2 turn signal bulbs in parallel between terminal No. 1 and negative battery terminal. Replace
turn signal flasher if bulbs do not flash 60-120 times per minute.
TURN SIGNAL FLASHER LOCATION
Fig. 7: Testing Turn Signal Flasher (Except Land Cruiser & Tundra)

Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
(1)For switch terminal locations, see Fig. 1 .
NOTE: Testing for Tundra is not available.
ApplicationLocation
Land CruiserBehind Dash Panel, Left Of Steering Column
RAV4Behind Left Kick Panel In Relay Block No. 5
Sienna, Tacoma, Tundra & 4RunnerDriver-Side Junction Block No. 1

1999 Toyota RAV4
1999 ACCESSORIES & EQUIPMENT Steering Column Switches - Trucks
Microsoft
Sunday, November 22, 2009 10:56:55 AMPage 8 © 2005 Mitchell Repair Information Company, LLC.