cruise control TOYOTA RAV4 2006 Service Service Manual

CRUISE CONTROL – CRUISE CONTROL SYSTEMCC–37
CC
INSPECTION PROCEDURE
(a) Disconnect the E13 DLC3 connector.
(b) Disconnect the A9 ECM connector.
(c) Measure the resistance of the wire harness side
connectors.
Standard resistance
NG
OK
1CHECK WIRE HARNESS (DLC3 - ECM AND BODY GROUND)
E125994E01
Tester Connection Specified Condition
E13-13 (TC) - A9-27 (TC) Below 1
E13-4 (CG) - Body ground
REPAIR OR REPLACE HARNESS AND
CONNECTOR
REPLACE ECM

CRUISE CONTROL – CRUISE CONTROL MAIN SWITCHCC–37
CC
INSTALLATION
1. INSTALL CRUISE CONTROL MAIN SWITCH
(a) Install the switch with the 2 screws.
Torque: 1.7 to 3.0 N*m (17.34 to 30.60 kgf*cm,
15.04 to 26.55 in.*lbf)
(b) Connect the connector.
2. INSTALL STEERING PAD ASSEMBLY (See page RS-
336)
3. CONNECT CABLE TO NEGATIVE BATTERY
TERMINAL
4. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light (see page RS-37).
B127290E08