fuel tank removal TOYOTA T100 1996 Factory Service Manual

Downloaded from www.Manualslib.com manuals search engine SF0AI−02
B02579
− MFI (3RZ−FE)FUEL PUMP
MF−9
1996 TOYOTA T100 (RM449U)
REMOVAL
CAUTION:
Do not smoke or work near an open flame when working on
the fuel pump.
1. REMOVE FUEL TANK
(See page MF−23)
2. REMOVE FUEL PUMP BRACKET ASSEMBLY FROM
FUEL TANK
(a) Disconnect the fuel pump connector from the clamp.
(b) Remove the 7 bolts.
Torque: 3.9 N·m ( 40 kgf·cm, 35 in.·lbf)
(c) Pull out the pump bracket assembly.
(d) Remove the gasket from the pump bracket.
HINT:
At the time assembly please refer to the following items.
Install the fuel pump bracket with a new gasket.

Downloaded from www.Manualslib.com manuals search engine SF0BV−02
P22396
− SFI (5VZ−FE)FUEL PUMP
SF−9
1996 TOYOTA T100 (RM449U)
REMOVAL
CAUTION:
Do not smoke or work near an open flame when working on
the fuel pump.
1. REMOVE FUEL TANK
HINT:
Check for fuel leakage.
2. REMOVE FUEL PUMP BRACKET ASSEMBLY FROM
FUEL TANK
(a) Disconnect the fuel pump connector from the clamp.
(b) Remove the 7 bolts.
Torque: 3.9 N·m (40 kgf·cm, 35 in.·lbf)
(c) Pull out the pump bracket assembly.
(d) Remove the gasket from the pump bracket.
HINT:
Install a new gasket to the pump bracket.

Downloaded from www.Manualslib.com manuals search engine BR0A6−01
R12233
BR−68
− BRAKEREAR SPEED SENSOR
1996 TOYOTA T100 (RM449U)
REMOVAL
1. DISCONNECT SPEED SENSOR CONNECTOR
2. REMOVE SPEED SENSOR
(a) Remove the clamp bolt, the clamp nut and the 5 clips
holding the sensor wire harness from the axle and the fuel
tank.
HINT:
When installing the rear sensor wire harness, never use
the removed resin clips, which are service parts.
When replacing clips, set up new resin clips at the same
angle of the removed resin clips.
When removing a resin clip, take care so that the remov-
ing tool is not caught on the grommet or wire.
Torque: 13 N·m (130 kgf·cm, 9 ft·lbf)
(b) Remove the speed sensor from the axle carrier.
Torque: 8.0 N·m (82 kgf·cm, 71 in.·lbf)