oil capacity TOYOTA T100 1996 Factory Service Manual

Downloaded from www.Manualslib.com manuals search engine PP0GK−01
PP−36
− PREPARATIONLUBRICATION (3RZ−FE)
1996 TOYOTA T100 (RM449U)
LUBRICANT
ItemCapacityClassification
Engine oil
Dry fill
Drain and refill
w/ Oil filter change
w/o Oil filter change
6.0 liters (6.3 US qts, 5.3 lmp. qts)
5.3 liters (5.6 US qts, 4.7 lmp. qts)
5.0 liters (5.3 US qts, 4.4 lmp. qts)
API grade SH, Energy−Conserving II multigrade
engine oil or ILSAC multigrade engine oil and
recommended viscosity oil, with SAE 5W−30
being preferred engine oil

Downloaded from www.Manualslib.com manuals search engine PP01U−07
− PREPARATIONLUBRICATION (5VZ−FE)
PP−41
1996 TOYOTA T100 (RM449U)
LUBRICANT
ItemCapacityClassification
Engine oil
2WD
Dry fill
Drain and refill
w/ Oil filter change
w/o Oil filter change
4WD
Dry fill
Drain and refill
w/ Oil filter change
w/o Oil filter change
5.9 liters (6.2 US qts, 5.2 lmp. qts)
5.2 liters (5.5 US qts, 4.6 lmp. qts)
5.2 liters (5.5 US qts, 4.6 lmp. qts)
4.9 liters (5.2 US qts, 4.3 lmp. qts)
5.5 liters (5.8 US qts, 4.8 lmp. qts)
4.7 liters (5.0 US qts, 4.1 lmp. qts)
4.4 liters (4.7 US qts, 3.9 lmp. qts)
API grade SH, Energy−Conserving II multigrade
engine oil or ILSAC multigrade engine oil and
recommended viscosity oil, with SAE 5W−30
being preferred engine oil

Downloaded from www.Manualslib.com manuals search engine PP0ET−01
− PREPARATIONMANUAL TRANSMISSION (R150, R150F)
PP−67
1996 TOYOTA T100 (RM449U)
LUBRICANT
ItemCapacityClassification
Manual transmission oil2WD:
4WD:2.6 liters (2.7 US qts, 2.3 Imp. qts)
2.2 liters (2.3 US qts, 1.9 Imp. qts)API GL−4 or GL−5
SAE 75W−90

Downloaded from www.Manualslib.com manuals search engine PP0BH−01
− PREPARATIONMANUAL TRANSMISSION (W59)
PP−73
1996 TOYOTA T100 (RM449U)
LUBRICANT
ItemCapacityClassification
Manual transmission oil2.6 liters (2.7 US qts, 2.3 Imp. qts)API GL−4 or GL−5
SAE 75W−90

Downloaded from www.Manualslib.com manuals search engine PP0G3−01
PP−84
− PREPARATIONTRANSFER
1996 TOYOTA T100 (RM449U)
LUBRICANT
ItemCapacityClassification
Transfer oil1.1 liters (1.2 US qts, 1.0 lmp.qts)API GL−4 or GL−5
SAE 75W−90

Downloaded from www.Manualslib.com manuals search engine PP0F8−02
PP−96
− PREPARATIONSUSPENSION AND AXLE
1996 TOYOTA T100 (RM449U)
LUBRICANT
ItemCapacityClassification
Drive shaft
Outboard joint grease176 − 186 g (6.21 − 6.56 oz.)
Inboard joint grease270 − 280 g (9.52 − 9.88 oz.)
Front differential1.86 liters (1.97 US qts, 1.64 lmp.qts)Hypoid gear oil API GL−5
75W−90
Rear differential2.35 liter (2.22 US qts, 2.67 lmp.qts)
Hypoid gear oil API GL−5
Above − 18 °C (0°F)
SAE 90
Below − 18 °C (0°F)
SAE 80W − 90 or 80W

Downloaded from www.Manualslib.com manuals search engine PP0E5−07
− PREPARATIONAIR CONDITIONING
PP−125
1996 TOYOTA T100 (RM449U)
LUBRICANT
ItemCapacityClassification
Compressor oil−ND−OIL 8 or equivalent
When replacing receiver10 cc (0.34 fl.oz.)
When replacing condenser40 cc (1.4 fl. oz.)
When replacing evaporator40 cc (1.4 fl. oz.)
When replacing compressor140 cc (4.8 fl. oz.)

Downloaded from www.Manualslib.com manuals search engine DI0UD−01
A00783
DLC3
EGR Gas Temp. Sensor*
A/C Amplifier
Circuit Opening Replay
ECM
Throttle Position Sensor
IAC Valve
Igniter
Mass Air
Flow MeterHeated Oxygen Sensor (Bank 1 Sensor 1)
Combination Meter
Heated Oxygen
Sensor (Bank 1
Sensor 2)
Park/Neutral
Position Switch
Fuel Pump
Ignition Switch
VSV for EGR*
Stop Light Switch
VSV for Vapor Pressure Sensor
VSV for EVAP
EFI Main Relay
(Marking : EFI)
DLC1 Knock Sensor 2 Knock Sensor 1Injector Ignition Coil Injector
Camshaft
Position Sensor
Engine Coolant
Temp. Sensor
Crankshaft Position
Sensor
*: Only for 2WD models with a load capacity of 0.5 ton and regular cab.
− DIAGNOSTICSENGINE (5VZ−FE)
DI−143
1996 TOYOTA T100 (RM449U)
PARTS LOCATION

Downloaded from www.Manualslib.com manuals search engine AT1347
AT6683
AT3417
OK if hot
Add if hot
AT4252
0 − 1 mm (0 − 0.04 in.)
Q03104No.1 Gear Shifting Rod
− DIAGNOSTICSAUTOMATIC TRANSMISSION
DI−271
1996 TOYOTA T100 (RM449U)
If the level is at the low side, add new fluid.
Fluid type: ATF DEXRON®II
NOTICE:
Do not overfill.
(b) Check the fluid condition.
If the fluid smells burnt or is black, replace it.
(c) Replace the ATF.
(1) Remove the drain plug and drain the fluid.
(2) Reinstall the drain plug securely.
(3) With the engine OFF, add new fluid through the oil
filler pipe.
Fluid type: ATF DEXRON®II
Capacity:
A340E: 1.6 liters (1.7 US qts, 1.4 Imp. qts)
A340F: 2.0 liters (2.1 US qts, 1.8 Imp. qts)
(4) Start the engine and shift the shift lever into all posi-
tions from P to L position and then shift into P posi-
tion.
(5) With the engine idling, check the fluid level. Add
fluid up to the COOL level on the dipstick.
(6) Check the fluid level at the normal operating tem-
perature, 70 − 80°C (158 − 176°F), and add as nec-
essary.
NOTICE:
Do not overfill.
(d) Check the fluid leaks.
Check for leaks in the transmission.
If there are leaks, it is necessary to repair or replace O−
rings, FIPGs, oil seals, plugs or other parts.
(e) INSPECT AND ADJUST THROTTLE CABLE
(1) Check that the accelerator pedal is fully released.
(2) Check that the inner cable is not slack.
(3) Measure the distance between the outer cable end
and stopper on the cable.
Standard distance: 0 − 1 mm (0 − 0.04 in.)
If the distance is not standard, adjust the cable by the adjusting
nuts.
(f) Inspect and adjust the shift lever position.
When shifting the shift lever from the N position to other
positions, check that the lever can be shifted smoothly
and accurately to each position and that the position indi-
cator is not aligned with the correct position.
If the indicator is not aligned with the correct position, carry out
the following adjustment procedures.
(1) Remove the nut on the No.1 gear shifting rod.
(2) Push the No.1 gear shifting rod fully downward.

Downloaded from www.Manualslib.com manuals search engine LU−4
− LUBRICATION (3RZ−FE)OIL AND FILTER
1996 TOYOTA T100 (RM449U)
3. REFILL WITH ENGINE OIL
(a) Clean and install the oil drain plug with a new gasket.
Torque:25 N·m (250 kgf·cm, 18 ft·lbf)
(b) Fill with fresh engine oil.
Oil capacity
Drain and refill
w/ Oil filter change
5.3 liters (5.6 US qts, 4.7 lmp. qts)
w/o Oil filter change
5.0 liters (5.3 US qts, 4.4 lmp. qts)
Dry fill
6.0 liters (6.3 US qts, 5.3 lmp. qts)
(c) Reinstall the oil filler cap.
4. START ENGINE AND CHECK FOR LEAKS
5. RECHECK ENGINE OIL LEVEL