warning TOYOTA tC 2012 Accessories, Audio & Navigation (in English)

Page 1 SCION SECURITY SYSTEM
TABLE OF CONTENTS
To better understand the features and functions of this security system, \
please read this
Owner’s Guide completely prior to use.
DESCRIPTION PAGE
INTRODUCTION 2
BRIEF DESCRIPTION – SCION SECURITY FEATURES 3, 4
OPERATION
ARMING THE SECURITY (except PASSIVE ARMING) 5
DISARMING THE SECURITY (except PASSIVE DISARMING) 6
PASSIVE (AUTOMATIC) ARMING & DISARMING 7
AUTOMATIC REARMING 8
ALARM INFORMATION
ALARM TRIGGERS 9
ALARM DESCRIPTIONS 10
STOPPING AN ALARM 10
GLASS BREAKAGE SENSOR INFORMATION
GLASS BREAKAGE SENSOR CHECK PROCEDURE 11
PROGRAMMING
PASSIVE (AUTOMATIC) ARMING AND ENTRY DELAY 12
(Not applicable to vehicles with Smart System. Please
consult your Scion Dealer for programming information)
WARNING and CAUTION INFORMATION 13

Page 11 SCION SECURITY SYSTEM
GLASS BREAKAGE SENSOR INFORMATION
The Scion Security provides protection for your vehicle above and beyond\
entry point
monitoring–it “listens” for the noise made by tapping on, or br\
eaking of glass. Using a
microphone designed specifically for this task, the GLASS BREAKAGE SENSOR is
capable of ignoring other noises, which helps to prevent “false alarm\
s” from occurring.
GLASS BREAKAGE SENSOR CHECK PROCEDURE
When the Scion Security was installed in your vehicle, care was taken to\
adjust the
sensitivity level of the GLASS BREAKAGE SENSOR. You may observe how it works
following the procedure listed below.
ARM the system.
1.
Press the lock button on the remote control or lock the doors
with the key.
(Remember, the system will not ARM if any door, the trunk or
hatch is open.)


Wait until the STATUS MONITOR’S LED starts flashing. The
2.
LED will flash 30 seconds after the last door, the trunk or
hatch is closed.
* for some vehicles the LED will turn off instead of flashing after the 30 seconds.

With the tip of a key, tap the center of the driver’s door
3.
window. Tap the glass with light to moderate force.
WARNING: Do not hit the glass with excessive force, especially in cold weather, or you may crack or break it.
A WARN AWAY ALARM should be TRIGGERED. If the
ALARM is not TRIGGERED, make sure you performed the
procedure correctly and try again. If you find that the system
did not perform as expected, contact your Scion dealer for
more information.
DISARM the system to stop the WARN AWAY ALARM. Press
4.
the unlock button
SCION
SECURITY

Page 13 SCION SECURITY SYSTEM
Warning
This product is applicable only to vehicles with 12V DC, negative ground\
ing
•
specifications. Do not use in vehicles with 24V specifications. Otherwis\
e, damage
to the unit or a fire may result.
Never attempt to disassemble or modify the product. Otherwise, an accide\
nt, fire
•
or electric shock may result.
When replacing fuses, be sure to use fuses with the same specified capac\
ity
•
(amperage.) Otherwise, damage to the unit or vehicle, fire or electric\
shock may
result.
If an abnormal condition occurs, such as liquids spilling onto the produ\
ct, or the
•
product emitting smoke or strange odors, stop using it immediately and c\
onsult
the dealer from whom you purchased the product. Continued use of the pro\
duct
before corrective actions are taken may result in an accident, injury or\
fire.
Never pull the plastic bag over your head. Otherwise, a serious injury o\
r death
•
from suffocation may occur.

Caution
Do not use this product for applications other than in-vehicle use. Othe\
rwise, an
•
electric shock or injury may result.
Do not allow children to play with the remote controls. Otherwise, the d\
oors may
•
be locked or unlocked, the security system armed or disarmed, or an alar\
m
triggered unintentionally.
If this product is dropped or its case is damaged, disconnect the power \
supply
•
lead and contact the dealer from whom you purchased it to obtain service\
.
Otherwise, a fire or electric shock may result.
All features may not be applicable to all vehicle models.
•
Content is subject to change without notice.
•