bulb TOYOTA tC 2013 Owners Manual (in English)
[x] Cancel search | Manufacturer: TOYOTA, Model Year: 2013, Model line: tC, Model: TOYOTA tC 2013Pages: 484, PDF Size: 9.1 MB
Page 4 of 484

TABLE OF CONTENTSIndex
4
tC_OM_OM21042U_(U)
4-1. Maintenance and careCleaning and protecting the
vehicle exterior ................. 272
Cleaning and protecting the
vehicle interior .................. 276
4-2. Maintenance Maintenance
requirements .................... 279
General maintenance ......... 282
Emission inspection and
maintenance (I/M)
programs .......................... 286
4-3. Do-it-yourself maintenance Do-it-yourself service
precautions ...................... 287
Hood................................... 292
Positioning a floor jack ....... 294
Engine compartment .......... 296
Tires ................................... 312
Tire inflation pressure......... 323
Wheels ............................... 327
Wireless remote control/
electronic key battery ....... 330
Checking and replacing
fuses ................................ 334
Light bulbs .......................... 345 5-1. Essential information
Emergency flashers ............ 356
If your vehicle needs to be
towed ................................ 357
If you think something is wrong ................................ 365
Fuel pump shut off
system .............................. 366
5-2. Steps to take in an emergency If a warning light turns on
or a warning buzzer
sounds... .......................... 367
If you have a flat tire ........... 385
If the engine will not start .... 400
If the shift lever cannot be
shifted from P (automatic
transmission) .................... 403
If you lose your keys ........... 404
If the electronic key does
not operate properly ......... 405
If the vehicle battery is discharged ........................ 409
If your vehicle overheats..... 413
If the vehicle becomes stuck ................................. 416
If your vehicle has to
be stopped in an
emergency ........................ 418
4Maintenance and care5When trouble arises
Page 185 of 484

185
2-1. Driving procedures
2
When driving
tC_OM_OM21042U_(U)
Tur n signal lever
■Turn signals can be operated when
Vehicles without a smart key system
The engine switch is in the “ON” position.
Vehicles with a smart key system
The “ENGINE START STOP” switch is in IGNITION ON mode.
■ If the indicator flashes faster than usual
Check that a light bulb in the front or rear turn signal lights has not burned
out.
The turn signal lever can be used to show the following intentions of
the driver:
Right turn
Left turn
Lane change to the right
(push and hold the lever
partway)
The right hand signal will flash
until you release the lever.
Lane change to the left
(push and hold the lever
partway)
The left hand signal will flash
until you release the lever.
Page 271 of 484

Maintenance and care4
271
tC_OM_OM21042U_(U)
4-1. Maintenance and careCleaning and protecting
the vehicle exterior......... 272
Cleaning and protecting
the vehicle interior.......... 276 4-2. Maintenance
Maintenance
requirements .................. 279
General maintenance....... 282
Emission inspection and
maintenance (I/M)
programs ........................ 286
4-3. Do-it-yourself maintenance Do-it-yourself service
precautions .................... 287
Hood ................................ 292
Positioning a floor jack ..... 294
Engine compartment ........ 296
Tires ................................. 312
Tire inflation pressure ...... 323
Wheels ............................. 327
Wireless remote control/
electronic key battery ..... 330
Checking and replacing
fuses .............................. 334
Light bulbs........................ 345
Page 289 of 484

289
4-3. Do-it-yourself maintenance
4
Maintenance and care
tC_OM_OM21042U_(U)
ItemsParts and tools
Light bulbs
(P. 345)
• Bulb with same number and watt-
age rating as original
• Flathead screwdriver
Radiator and condenser
( P. 303)
Tire inflation pressure ( P. 323)• Tire pressure gauge
• Compressed air source
Washer fluid (P. 310)
• Water or washer fluid containing
antifreeze (for winter use)
• Funnel (used only for adding water or washer fluid)
Page 344 of 484

344 4-3. Do-it-yourself maintenance
tC_OM_OM21042U_(U)
■After a fuse is replaced
● If the lights do not turn on even after the fuse has been replaced, a bulb
may need replacement. (P. 345)
● If the replaced fuse blows again, have the vehicle inspected by your
Scion dealer.
■ If there is an overload in the circuits
The fuses are designed to blow, protecting the wiring harness from damage.
CAUTION
■To prevent system breakdowns and vehicle fire
Observe the following precautions.
Failing to do so may cause damage, and possibly a fire or injury.
● Never use a fuse of a higher amperage rating than that indicated, or use
any other object in place of a fuse.
● Always use a genuine Scion fuse or equivalent.
Never replace a fuse with a wire, even as a temporary fix.
This can cause extensive damage or even fire.
● Do not modify the fuse or the fuse box.
NOTICE
■Before replacing fuses
Have the cause of electrical overload determined and repaired by your Scion
dealer, as soon as possible.
Page 345 of 484

345
4-3. Do-it-yourself maintenance
4
Maintenance and care
tC_OM_OM21042U_(U)
Light bulbs
You may replace the following bulbs yourself. The difficulty level of
replacement varies depending on the bulb. If necessary bulb
replacement seems difficult to perf orm, contact your Scion dealer.
For more information about replacing other light bulbs, contact your
Scion dealer.
■ Preparing for light bulb replacement
Check the wattage of the light bulb to be replaced. ( P. 432)
■ Front bulb locations
Front turn signal lights
Headlight low beam
Daytime running
lights (Canada only)
and headlight
high beam
Parking and front side
marker lights
Page 346 of 484

346 4-3. Do-it-yourself maintenance
tC_OM_OM21042U_(U)
■Rear bulb locations
Stop/tail and rear
side marker lights
Rear turn signal lights Back-up lightsLicense plate lights
Page 347 of 484

347
4-3. Do-it-yourself maintenance
4
Maintenance and care
tC_OM_OM21042U_(U)
Replacing light bulbs
■ Headlight low beams
Turn the bulb base counterclock-
wise.
Unplug the bulb while depress-
ing the lock release.
STEP 1
ITO43P165
STEP 2
Page 348 of 484

348 4-3. Do-it-yourself maintenance
tC_OM_OM21042U_(U)
■Daytime running lights (Canada only) and headlight high
beam
Turn the bulb base counterclock-
wise.
Unplug the bulb while depress-
ing the lock release.
STEP 1
ITO43P163
STEP 2
Page 349 of 484

349
4-3. Do-it-yourself maintenance
4
Maintenance and care
tC_OM_OM21042U_(U)
■
Front turn signal lights
Turn the bulb base counterclock-
wise.
Remove the light bulb.
STEP 1
STEP 2