heater TOYOTA TERCEL 1985 Repair Manual

8R.14BRAKE SYSTEM - Brake Booster
REMOVAL OF BRAKE BOOSTER
levis
II
dCI
130 (9, 131f=s(lr=' I
5
llJ
3-Way Unionl
(ft-lb, N.m):Tightening torque
0 : Non-reusable part
Brake Fluid Level Warning
Switch Connector
Brake Booster
BRAKE BOOSTER
1. REMOVE MASTER CYLINDER (See page Bn-gl
2. DISCONNECT VACUUM HOSE FROM BRAKE
BOOSTER
3. REMOVE DISTRIBUTOR CAP
4. REPEAT PROCEDURE FOR EACH WHEEL
5. REMOVE HEATER AIR DUCT
6. DISCONNECT PEDAL RETURN SPRING FROM
BRAKE PEDAL
7. DISCONNECT PUSH ROD CLEVIS FROM BRAKE
PEDAL
Remove the clip and clevis pin.
8. REMOVE BRAKE BOOSTER
Remove the four nuts, and pull out the brake booster.

BRAKE SYSTEM - Brake Booster8R.15
INSTALLATION OF BRAKE BOOSTER
(See page BR-l41
1. ADJUST LENGTH OF BOOSTER PUSH ROD
(a) Set SST on the master cylinder with the gasket and
lower the pin until its tip slightly touches the piston.
ssr 09737-00010
(d Tum SST upside down, and set it on the booster.
ssT 09737-OOO10
(c) Check that there is no clearance between the booster
push rod and pin head of SST.
Clearance: O mm (0 in.l
(d) Adjust the booster push rod length untilthe push rod
lightly touches the pin head.
2. INSTALL BRAKE BOOSTER
Torque: 130 kg-cm (9 ft-lb, 13 N'ml
3. INSTALL MASTER CYLINDER (See page BR-131
4. CONNECT VACUUM HOSE TO BRAKE BOOSTER
5. CONNECT PUSH ROD CLEVIS TO BRAKE PEDAL
Install the clevis pin and clip.
6. CONNECT PEDAL RETURN SPRING TO PEDAL
SPRING
INSTALL HEATER AIR DUCT
INSTALL LOWER FINISH PANEL
INSTALL IIA CAP
FILL BRAKE RESERVOIR WITH BRAKE FLUID
AND BLEED BRAKE SYSTEM (See page BR-71
CHECK BRAKE PEDAL (See page BR-61
PERFORM OPERATIONAL CHECK (See page BR-71
7.
8.
9.
10.
11.
12.