Strut bolts TOYOTA TERCEL 1996 Service Repair Manual

Z14321
A242L A/T
P20255
Lift
P20167
P20161
P20245
A/T only
- ENGINE MECHANICALENGINE UNIT
EM-61
1996 TERCEL (RM440U)
(j) A242L A/T:
Remove the bolt and disconnect the ground strap.
(k) Remove the 5 bolts and LH engine mounting bracket.
(l) Lift the engine out of the vehicle slowly and carefully.
HINT:
Clear the battery carrier support while lowering the transaxle.
(m) Place the engine with the transaxle onto the stand.
23. w/PS:
REMOVE PS PUMP ADJUSTING STRUT
Remove the 2 bolts and PS pump adjusting strut.
24. w/A/C:
REMOVE A/C COMPRESSOR MOUNTING BRACKET
Remove the 4 bolts and compressor mounting bracket.
25. A/T only:
REMOVE TORQUE CONVERTER CLUTCH MOUNT-
ING BOLTS
(a) Remove the engine rear end plate hole cover.
(b) Turn the crankshaft to gain access to each bolt.
(c) Hold the crankshaft pulley bolt with a wrench.
(d) Remove the 6 bolts.
26. REMOVE STARTER (See page ST-3 and ST-16)
27. SEPARATE ENGINE AND TRANSAXLE

EM1OI-01
P20245
A/T only
P20161
P20167
P20256
Lower EM-62
- ENGINE MECHANICALENGINE UNIT
1996 TERCEL (RM440U)
INSTALLATION
1. ASSEMBLE ENGINE AND TRANSAXLE
M/T: (See page MX-4)
A132L A/T: (See page AX-26)
A242L A/T: (See page AX-30)
2. INSTALL STARTER
(See page ST-14 and ST-30)
3. A/T only:
INSTALL TORQUE CONVERTER CLUTCH MOUNTING
BOLTS
(a) First, install the gray bolt and then 5 bolts.
(b) Tighten the bolts evenly.
Torque: 27 N´m (280 kgf´cm, 20 ft´lbf)
(c) Install the engine rear end plate hole cover.
4. w/A/C:
INSTALL A/C COMPRESSOR MOUNTING BRACKET
Install the compressor mounting bracket with the 4 bolts.
Torque: 27 N´m (280 kgf´cm, 20 ft´lbf)
5. w/PS:
INSTALL PS PUMP ADJUSTING STRUT
Install the PS pump adjusting strut with the 2 bolts.
Torque: 21 N´m (210 kgf´cm, 15 ft´lbf)
6. INSTALL ENGINE AND TRANSAXLE ASSEMBLY IN
VEHICLE
(a) Attach the engine sling device to the engine hangers.
(b) Lower the engine into the engine compartment.
(c) Tilt the transaxle downward, lower the engine and clear
the LH engine mounting.
NOTICE:
Be careful not to hit the PS gear housing, park/neutral posi-
tion switch and throttle position switch.