seats TOYOTA VENZA 2010 Accessories, Audio & Navigation (in English)

128-8673b
6 of 48
NOTICE
Do not use any solvents or cleaning materials when
cleaning the LCD display. Do not use any abrasive cleaners,
they may scratch the screen. Use only a lightly dampened
lint free cloth to wipe the screen if it is dirty.
- IV -
NOTICE
Moisture in the air will condense in the DVD player under
extremely humid conditions or when moving from a
cold place to a warm one. Moisture condensation may
cause damage to the DVD and/or player. If moisture
condensation occurs, do not insert a CD or DVD into the
player. If one is already in the player, remove it. Turn the
DVD player ON to dry the moisture before inserting a DVD.
This could take an hour or more.
NOTICE
The use of a cellular phone inside or near the vehicle may
cause noise or audio interference from the speakers of the
system, which you are listening to. However, this does not
indicate a malfunction.
NOTICE
When the vehicle is parked in direct sunlight or in an
extremely cold place for a long period of time, wait until
the cabin temperature of the vehicle is at a comfortable
temperature before operating the system.
NOTICE
Do not operate video games or video equipment if the
power cords and/or cables are broken, split or damaged.
Carefully place cords and/or cables where they will not be
stepped on or interfere with the operation of seats and/
or compartments. Disconnect video games and video
equipment power cords and/or cables when not in use.
Do not allow the auxiliary input jack to get wet or dirty. Do
not clean any part of the DVD player/screen with benzene,
paint thinner or any other solvent.
NOTICE
Exercise care to prevent dirt and foreign objects from
entering the DVD player compartment. Be especially
careful not to spill liquids of any kind onto the media
controls or into the system. If liquid is accidentally spilled
onto the system, immediately turn the system OFF and
consult a qualifi ed service technician.

128-8673b
21 of 48
- 11 -
Fold Flat Feature1. To use the headphones, place one ear piece in each hand,
rotate the ear pieces 90 degrees to the fully open position.
2. For storage, rotate both of the ear pieces 90 degrees to the
fold fl at position.
To Operate the HeadphonesHeadphones are intended for use by rear seat passengers only
and will not operate in the front seats. When sitting in front of
the passenger side monitor, move the channel select switch to
the “1” position. When sitting in front of the driver side monitor,
move the channel select switch to the “2” position.
1. Press the Power button on the right hand earpiece to turn
the headphones ON. The power indicator will illuminate red.
2. Adjust the volume level with the volume control on the
right-hand ear piece to its lowest setting before putting the
headphones on your head.
3. Press the Power button again to turn the headphones OFF.
Note: The IR transmitter must be in the ON mode. Turn
the IR transmitter ON using the Remote Control or
the touch screen. See “Remote Control Functional
Description, Item 18” on page 8 or refer to the “IRT
(Infrared Transmitter)” section on page 28.
Figure 4. Fold Flat Feature