child seat TOYOTA YARIS 2005 1.G Owner's Manual

442005 ECHO HATCHBACK from Jul. ’04Prod. (OM52624U)
SU13232a
4. To remove the convertible seat, pressthe buckle release button and allow the
belt to retract completely. The belt will
move freely again and be ready to
work for an adult or older child passen-
ger.
SU13227e
(C) BOOSTER SEAT INSTALLATION
A booster seat must be used in for-
ward −facing position only.
SU13052
Move seat
fully back
CAUTION

A for war d −facing child restraint sys-
tem should be allowed to be
installed on the front passenger
seat only when it is unavoidable.
Always move the seat as far back
as possible, because the front pas-
senger airbag could inflate with
considerable speed and force.
Otherwise, the child may be killed
or seriously injured.
04 05.28

452005 ECHO HATCHBACK from Jul. ’04Prod. (OM52624U)
SU13233c
1. Sit the child on a booster seat. Runthe lap and shoulder belt through or
around the booster seat and across the
child following the instructions provided
by its manufacturer and insert the tab
into the buckle taking care not to twist
the belt.
Make sure the shoulder belt is correctly
across the child’s shoulder and that the
lap belt is positioned as low as possible
on the child’s hips. See “Seat belts” for
details.
CAUTION

Always make sure the shoulder belt
is positioned across the center of
child’s shoulder. The belt should be
kept away from child’s neck, but
not falling off child’s shoulder.
Otherwise, the child may be killed
or seriously injured in case of sud-
den braking or a collision.

Both high −positioned lap belts and
loose −fitting belts could cause
death or serious injuries due to
sliding under the lap belt during a
collision or other unintended event.
Keep the lap belt positioned as low
on a child’s hips as possible.

For child’s safety, do not place the
shoulder belt under child’s arm.

After inserting the tab, make sure
the tab and buckle are locked and
that the lap and shoulder portions
of the belt are not twisted.

Do not insert coins, clips, etc. in
the buckle as this may prevent your
child from properly latching the tab
and buckle.

If the seat belt does not function
normally, it cannot protect your
child from death or serious injury.
Contact your Toyota dealer immedi-
ately. Do not install the child re-
straint system on the seat until the
seat belt is fixed.
04 05.28

462005 ECHO HATCHBACK from Jul. ’04Prod. (OM52624U)
SU13232
2. To remove the child restraint system,press the buckle release button and
allow the belt to retract.
—U sin g a to p st rap
SU13242a
Follow the procedure below for a child
restraint system that use of a top strap
to secure the system. Follow all the
installation instructions provided by its
manufacturer.
SU13246a
Anchor brackets
Symbol
Use the anchor bracket behind the rear
seat to attach the top strap.
Anchor brackets are installed for outside
rear seating position.
This symbol indicates the location of user
ready anchor brackets.
04 05.28

472005 ECHO HATCHBACK from Jul. ’04Prod. (OM52624U)
SU13245
TO USE THE ANCHOR BRACKET:1. Remove the head restraint.
SU13247a
2. Open the anchor bracket cover with the symbol mark shown in the il-
lustration.
SU13243a
3. Securely fasten the child restraintsystem with the seat belt.
Latch the hook onto the anchor
bracket and tighten the top strap.
For instructions to install the child re-
straint system, see “Child restraint” on
page 35 in this Section.
04 05.28

482005 ECHO HATCHBACK from Jul. ’04Prod. (OM52624U)
CAUTION

Make sure the top strap is securely
latched, and check that the child
restraint system is secure by push-
ing and pulling it in different direc-
tions.
Follow all the installation instructions
provided by its manufacturer.
SU13244a
4. Replace the head restraint.
Be sure to close the cover when the an-
chor bracket is not in use.
SU13228c
The lower anchorages for the child re-
straint system interfaced with the
FMVSS225 or CMVSS210.2 specification
are installed in the rear seat.
The anchorages are installed in the gap
between the seat cushion and seatback of
both outside rear seats.
Child restraint system interfaced with the
FMVSS213 or CMVSS213 specification
can be fixed with these anchorages. In
this case, it is not necessary to fix the
child restraint system with a seat belt on
the vehicle.
04 05.28
—Installation with child
restraint lower anchorages

502005 ECHO HATCHBACK from Jul. ’04Prod. (OM52624U)
SU13230c
Type B (anchor position indicated by
tags)
The symbol on a child restraint system
indicates the presence of a lower connec-
tor system.
CHILD RESTRAINT SYSTEM
INSTALLATION
Ty p e A —1. Widen the gap between the seat cushion and seatback slightly and
confirm the position of the lower an-
chorages below the button or tag in
the seatback.
2. Latch the hooks of lower straps onto the anchorages and tighten the lower
straps.
Ty p e B —
1. Widen the gap between the seat cushion and seatback slightly and
confirm the position on the lower
anchorages below the button or tag
in the seatback.
2. Latch the buckles onto the anchor- ages.
If your child restraint system has a top
strap, it should be anchored. (For the
installation of the top strap, see “—Using
a top strap” on page 46 in this Section.) For installation details, refer to the instruc-
tion manual equipped with each product.
CAUTION

When using the lower anchorages
for the child restraint system, be
sure that there are no irregular ob-
jects around the anchorages or that
the seat belt is not caught.

Push and pull the child restraint
system in different directions to be
sure it is secure. Follow all the
installation instructions provided by
its manufacturer.

Do not put a child restraint system
on the rear seat if it interferes with
the lock mechanism of the front
seats. Otherwise, the child or front
seat occupant(s) may be killed or
seriously injured in case of sudden
braking or a collision.
04 05.28