lock VOLKSWAGEN JETTA 1998 Owners Manual
[x] Cancel search | Manufacturer: VOLKSWAGEN, Model Year: 1998, Model line: JETTA, Model: VOLKSWAGEN JETTA 1998Pages: 339, PDF Size: 2.35 MB
Page 224 of 339

Downloaded from www.Manualslib.com manuals search engine 01-216
V.A.G 1551 print-out
Possible cause
Repair
01279
Longitudinal
acceleration sensor -
G251-
1)
Electrical malfunction
in current circuit
Voltage supply less than 5
Volt - Read measured value block
Page 01
-240 Display group number
006
Open circuit, short to
positive or ground in the
wiring - Check wiring and connections
using wiring diagram
- Perform electrical check Page
01-288
Longitudinal acceleration
sensor -G251- faulty
Repair Manual, Brake System,
Repair Group 45 - Replace longitudinal acceleration
sensor -G251-
- Perform a zero compensation:
- Introduce basic setting Page
01-264 Display group number 069
1) 4MOTION vehicles only
Стр. 58из 129 On Board Diagnostic (OBD), performing
Page 225 of 339

Downloaded from www.Manualslib.com manuals search engine 01-217
V.A.G 1551 print-
out Possible cause
Repair
01279
Longitudinal
acceleration sensor -
G251-
1)
Implausible signal
- Read measured value block
Page 01
-240 Display group
number 006
The installation position of the
longitudinal acceleration sensor
-G251- is not OK - Check installation position of
longitudinal acceleration sensor
-G251-
Open circuit, short to positive or
ground in the wiring - Check wiring and connections
using wiring diagram
- Perform electrical check
Page 01
-288
Longitudinal acceleration sensor
-G251- faulty
Repair Manual, Brake
System, Repair Group 45 - Replace longitudinal
acceleration sensor -G251-
- Perform a zero compensation:
- Introduce basic setting
Page 01
-264 Display group
number 069
1) 4MOTION vehicles only
Стр. 59из 129 On Board Diagnostic (OBD), performing
Page 226 of 339

Downloaded from www.Manualslib.com manuals search engine 01-218
V.A.G 1551 print-out
Possible cause
Repair
01279
Longitudinal acceleration
sensor -G251-
1)
No, or incorrect, basic
setting/adaptation
Longitudinal acceleration
sensor -G251- sends no, or
incorrect, setting values - Read measured value block
Page 01
-264 Display
group number 069
01312
Drive train data bus
faulty
2)
- Read measured value block
Page 01-240 Display
group number 125
Open circuit, short to positive
or ground in data bus wiring - Check wiring and
connections of data bus
wiring using wiring diagram
- Perform electrical check
Page 01
-288
1) 4MOTION vehicles only
2) This DTC occurs only together with DTC "Steering angle sensor -G85-, No communication".
Стр. 60из 129 On Board Diagnostic (OBD), performing
Page 227 of 339

Downloaded from www.Manualslib.com manuals search engine 01-219
V.A.G 1551 print-out
Possible cause
Repair
01314
Engine control module
No
signal/communication
- Read measured value block
Page 01
-240 Display group
number 125
Open circuit, short to
positive or Ground in data
bus wiring - Check wiring and connections of
data bus wiring using wiring
diagram
or:
- Perform electrical check Page
01-288
Check DTC memory
DTC entry in engine
control module
Repair Manual, Engine
Mechanical, Repair Group 01 - Check engine control module
DTC memory:
Стр. 61из 129 On Board Diagnostic (OBD), performing
Page 228 of 339

Downloaded from www.Manualslib.com manuals search engine 01-220
V.A.G 1551 print-out
Possible cause
Repair
01315
Transmission control module
1)
No signal/communication
- Read measured value
block Page 01
-240
Display group number 125
Open circuit, short to
positive or ground in data
bus wiring - Check wiring and
connections of data bus
wiring using wiring diagram
- Perform electrical check
Page 01
-288
01317
Control module with indicator
unit in instrument panel insert -
J285-
Control module with
indicator unit in instrument
panel insert -J285-
incorrectly coded
Repair Manual, Electrical
Equipment, Repair Group 01 - Check coding for Control
module with indicator unit in
instrument panel insert -
J285-
1) Vehicles with automatic transmission only.
Стр. 62из 129 On Board Diagnostic (OBD), performing
Page 229 of 339

Downloaded from www.Manualslib.com manuals search engine 01-221
V.A.G 1551 print-out
Possible cause
Repair
01324
All-Wheel Drive Control
Module -J492-
1)
No communication
- Read measured value block
Page 01-240 Display group
number 125
Open circuit, short to
positive or ground in data
bus wiring - Check wiring and connectors of
data bus wiring using wiring
diagram
- Perform electrical check Page
01-288
1) 4MOTION vehicles only
Стр. 63из 129 On Board Diagnostic (OBD), performing
Page 231 of 339

Downloaded from www.Manualslib.com manuals search engine 01-223
V.A.G 1551 print-
out Possible cause
Repair
01423
Sensor for
transverse
acceleration -G200-
Implausible signal
1)
- Read measured value block
Page 01
-240 Display group number
004
Installation of sensor for
transverse acceleration -
G200- is not OK. - Check installation of sensor for
transverse acceleration -G200-
Open circuit, short to
positive or Ground in the
wiring - Check wiring and connections using
wiring diagram
- Perform electrical check Page
01-288
Sensor for transverse
acceleration -G200- faulty
Repair Manual, Brake System,
Repair Group 45; Removing and
installing parts of ESP system - Replace sensor for transverse
acceleration-G200-
- Perform a zero compensation:
Basic setting was not
correctly performed in the
past - Initiate basic setting Page 01-264
Display group number 063
1) For ABS/EDL/ASR/ESP and ABS/EDL/ASR/ESP 4MOTION
Стр. 65из 129 On Board Diagnostic (OBD), performing
Page 233 of 339

Downloaded from www.Manualslib.com manuals search engine 01-225
V.A.G 1551 print-
out Possible cause
Repair
01435
Sender 1 for
brake booster -
G201-
Implausible
signal
1)
- Read measured value block Page 01
-
240 Display group number 005
Open circuit, short to
positive or ground in
the wiring - Check wiring and connections using wiring
diagram
- Perform electrical check Page 01
-288
Brake light switch
improperly adjusted
Brake light switch
faulty Repair Manual, Brake System, Repair Group 46; Brake pedal - Assembly overview;
Adjusting brake light switch - Adjust brake light switch
Sender 1 for brake
booster-G201- faulty
Repair Manual, Brake System, Repair
Group 45; Removing and installing parts of
ESP system - Replace sender 1 for brake booster -G201-
:
- Perform a zero compensation:
- Initiate basic setting Page 01
-264
Display group number 066
1) For ABS/EDL/ASR/ESP and ABS/EDL/ASR/ESP 4MOTION
Стр. 67из 129 On Board Diagnostic (OBD), performing
Page 236 of 339

Downloaded from www.Manualslib.com manuals search engine 01-228
V.A.G 1551 print-
out Possible cause
Repair
01542
Sender for rotation
rate -G202-
Implausible signal
1)
- Read measured value block
Page 01
-240 Display group number
004
Installation of sender for
rotation rate -G202- is not
OK. - Check installation of sender for
rotation rate -G202-
Open circuit, short to positive
or Ground in the wiring - Check wiring and connections using
wiring diagram
- Perform electrical check Page
01-288
Sender for rotation rate -
G202- faulty
Repair Manual, Brake System,
Repair Group 45 - Replace sender for rotation rate -
G202-
1) For ABS/EDL/ASR/ESP and ABS/EDL/ASR/ESP 4MOTION
Стр. 70из 129 On Board Diagnostic (OBD), performing
Page 248 of 339

Downloaded from www.Manualslib.com manuals search engine 01-240
Measured value block, reading
Note:
All functions that have been carried out so far
with V.A.G 1551 can now also be carried out with
the tester VAS 5051.
The control module can transfer a considerable
amount of test data. This test data delivers
information on the operational condition of the
system and/or sensors connected to it. In many
cases the transferred test data supports
troubleshooting and repair. The test data has
been summarized into single display groups
because all the information cannot be evaluated
at the same time. The information can be
selected via display group numbers.
Safety precautions
WARNING!
If the use of test and information devices
during a test drive is necessary, observe the
following:
You must always secure testing and
measuring equipment on the rear seat.
When vehicle is being driven, a second
technician must operate this equipment.
Стр. 82из 129 On Board Diagnostic (OBD), performing