lock VOLVO C70 CONVERTIBLE 2007 Owner´s Manual

2007 Volvo C70
132 06 Starting and driving
Automatic transmission
Shift gate positions
Depress the button on the front of the gear selector knob to move the se\
lector between the R, N, D, and P
positions.
The gear selector can be moved freely between the Geartronic (manual sh\
ifting) and Drive (D) positions
while driving.
Gear selector positions
P - Park
Select the P position when starting or parking. In P, the transmission is mechanically blocked (Shiftlock).
Always apply the parking brake when parking.
CAUTION
The car must be stationary when selecting position
P.
file:///K|/delme/2007_C70/07c70_06.htm (16 of 18)12/22/2006 9:15:48 PM\

2007 Volvo C70
R - Reverse
The car must be stationary when shifting to position R.
N - Neutral
N is the neutral position. The engine can be started, but no gear is sele\
cted. Apply the parking brake when
the car is stationary with the gear selector in N.
133 06 Starting and driving
Automatic transmission
NOTE
If the gear selector is in the Neutral position and the car has been at \
a standstill for at least 3 seconds
(regardless of whether the engine is running or not), the gear selecto\
r will be locked in Neutral.
In order to move the gear selector to another position:
1. Turn the ignition key to position II (if the engine is not already r\
unning).
2. Depress the brake pedal.
3. Move the gear selector to the desired position.
D - Drive
D is the normal driving position. The Drive position offers 6 forward gea\
rs.The car automatically shifts
between the various forward gears, based on the level of acceleration an\
d speed. The car must be at a
file:///K|/delme/2007_C70/07c70_06.htm (17 of 18)12/22/2006 9:15:48 PM\

2007 Volvo C70
CAUTION
l Check local regulations regarding the use of snow chains before installi\
ng.
l Always follow the chain manufacturer's installation instructions careful\
ly. Install chains as tightly as
possible and retighten periodically.
l Never exceed the chain manufacturer's specified maximum speed limit. (U\
nder no circumstances
should you exceed 31 mph (50 km/h).
l Avoid bumps, holes or sharp turns when driving with snow chains.
l The handling of the vehicle can be adversely affected when driving with \
chains. Avoid fast or sharp
turns as well as locked wheel braking.
Snow tires, studded tires
Tires for winter use:
l Owners who live in or regularly commute through areas with sustained per\
iods of snow or icy driving
conditions are strongly advised to fit suitable winter tires to help ret\
ain the highest degree of traction.
l It is important to install winter tires on all four wheels to help retai\
n traction during cornering, braking,
and accelerating. Failure to do so could reduce traction to an unsafe le\
vel or adversely affect handling.
l Do not mix tires of different design as this could also negatively affec\
t overall tire road grip.
l Winter tires wear more quickly on dry roads in warm weather. They should\
be removed when the
winter driving season has ended.
l Studded tires should be run-in 300-600 miles (500-1000 km) during whic\
h the car should be driven as
smoothly as possible to give the studs the opportunity to seat properly \
in the tires. The tires should have
the same rotational direction throughout their entire lifetime.
NOTE
Please consult state or provincial regulations restricting the use of st\
udded winter tires before installing
such tires.
165 07 Wheels and tires
Wheel nuts
Wheel nuts
file:///K|/delme/2007_C70/07c70_07.htm (15 of 30)12/22/2006 9:15:51 PM\

2007 Volvo C70
There are two different types of wheel nut, depending on whether the whe\
els are steel or aluminum.
Steel rims - low nut
Steel rims are normally secured using the low type of nut, although stee\
l rims may also use the high type.
WARNING
Never use the short type of nut for aluminium wheels. This could cause t\
he wheel to come
loose.
Aluminum wheels - high nut
Only the high type of nut can be used for aluminum wheels. This is consi\
derably different from other
types of nut because it has a rotating conical thrust washer.
NOTE
This nut can also be used on steel
wheels.
Lockable wheel nut
If steel wheels with lockable wheel nuts are used in combination with wh\
eel covers, the lockable wheel
nut must be fitted to the stud nearest the air valve. The wheel cover ca\
nnot otherwise be installed on the
wheel.
166 07 Wheels and tires
file:///K|/delme/2007_C70/07c70_07.htm (16 of 30)12/22/2006 9:15:51 PM\

2007 Volvo C70
On cars with a spare wheel, the jack and lug wrench are secured in a foa\
m plastic block placed in the
center of the wheel.
CAUTION
The car must not be driven with wheels of different dimensions or with a\
spare tire other than the one
that came with the car. The use of different size wheels can seriously d\
amage your car's transmission.
The retaining straps securing the spare wheel is attached to two eyelets\
in the floor of the spare wheel's
storage compartment.
WARNING
Current legislation prohibits the use of the "Temporary Spare" tire othe\
r than as a temporary
replacement for a punctured tire. It must be replaced as soon as possibl\
e by a standard tire. Road holding
and handling may be affected with the "Temporary Spare" in use. Do not e\
xceed 50 mph (80 km/h). Do
not drive farther than 50 miles (80 km) on a temporary spare tire.
168 07 Wheels and tires
Changing a wheel
Changing a wheel
Accessing the spare wheel
1. Open the hatch in the floor of the trunk.
2. Release the retaining straps and lift out the spare wheel in its stor\
age bag.
3. Open the zipper on the storage bag and lift out the spare wheel.
The wheel that was replaced by the temporary spare tire can then be plac\
ed in the storage bag.
file:///K|/delme/2007_C70/07c70_07.htm (19 of 30)12/22/2006 9:15:51 PM\

2007 Volvo C70
Before raising the car
1. Engage the parking brake.
2. Put the gear selector in Park (P).
3. Block the wheels that are on the ground with wooden blocks or large s\
tones.
4. Remove the wheel cap (where applicable) using the lug wrench in the\
tool bag.
5. With the car still on the ground, use the lug wrench to loosen the wh\
eel nuts 1/2 - 1 turn by exerting
downward pressure. Turn the nuts counterclockwise to loosen.
file:///K|/delme/2007_C70/07c70_07.htm (20 of 30)12/22/2006 9:15:51 PM\

2007 Volvo C70
169 07 Wheels and tires
Changing a wheel
Positioning the jack1
There are two jack attachment points on each side of the car.
6. Position the jack correctly in the attachment (see illustration abov\
e) and crank while simultaneously
guiding the base of the jack to the ground. The base of the jack must be\
flat on a level, firm, non-slippery
surface.
7. Before raising the car, check that the jack is still correctly positi\
oned in the attachment.
1Not included on models equipped with the tire sealing system.
WARNING
l The jack must correctly engage the jack attachment.
l Be sure the jack is on a firm, level, non-slippery surface.
l Never allow any part of your body to be extended under a car supported b\
y a jack.
l Use the jack intended for the car when changing a tire. For any other jo\
b, use stands to support the
car.
l Apply the parking brake and put the gear selector in the Park (P) position.
l Block the wheels standing on the ground, use rigid wooden blocks or larg\
e stones.
l The jack should be kept well-greased.
Removing the wheel
file:///K|/delme/2007_C70/07c70_07.htm (21 of 30)12/22/2006 9:15:51 PM\

2007 Volvo C70
1. Unscrew the two screws (2) on the orange casing.
2. Remove the speed limit sticker (4) and the expiration date decal (\
1).
3. Release the safety catch (5) and remove the casing (3) from the s\
ealing system unit.
4. Press down the button (8) while twisting the container (6) and re\
taining bracket (9) clockwise
approximately 2/ 3 of a turn and remove them.
5. To remove the hose (10), first press it into housing and then pull \
it out from the opposite side.
6. Wipe away any remaining sealing compound, or scrape it off if it has \
already hardened.
7. Insert a new air hose and check that it is properly seated.
8. Unscrew the cap from the new sealing compound container and check tha\
t the seal (7) is intact and
undamaged.
9. Screw the container (6) firmly into the bracket (9).
10.Mount the bracket on the housing and twist it counterclockwise until \
it clicks into place.
11.Reinsert the casing (3). Check that it is correctly in place and ti\
ghten the screws (2), and press the
safety catch (5) into position.
12.Affix the speed limit decal (4) and a new expiration date decal (1\
).
The empty container and used hose can be discarded as normal refuse, or \
recycled. Consult local
regulations.
Replacing the container after its expiration date has passed
1. Unscrew the two screws (2) on the orange casing.
2. Remove the speed limit sticker (4) and the expiration date decal (\
1).
3. Release the safety catch (5) and remove the casing (3) from the s\
ealing system unit.
4. Unscrew and remove the container.
5. Unscrew the cap from the new sealing compound container and check tha\
t the seal (7) is intact and
file:///K|/delme/2007_C70/07c70_07.htm (29 of 30)12/22/2006 9:15:51 PM\

2007 Volvo C70
permanently damaged.
l A detergent can be used to facilitate the softening of dirt and oil.
l A water-soluble grease solvent may be used in cases of sticky dirt. Howe\
ver, use a wash place
equipped with a drainage separator.
l Dry the car with a clean chamois and remember to clean the drain holes i\
n the doors and rocker panels.
l Tar spots can be removed with kerosene or tar remover after the car has \
been washed.
l A stiff-bristle brush and lukewarm soapy water can be used to clean the \
wiper blades. Frequent
cleaning improves visibility considerably.
l Wash off the dirt from the underside (wheel housings, fenders, etc).
l In areas of high industrial fallout, more frequent washing is recommende\
d.
l After cleaning the engine, the spark plug wells should be inspected for \
water and blown dry if
necessary.
Exterior plastic components
Cleaning exterior plastic components should be done with a cleaning agen\
t specially designed for this
purpose. Solvents or stain removers should not be used. Consult your Vol\
vo retailer.
NOTE
When washing the car, remember to remove dirt from the drain holes in th\
e doors and
sills.
CAUTION
l During high pressure washing, the spray mouthpiece must never be closer \
to the vehicle than 13" (30
cm). Do not spray into the locks.
l When washing or steam cleaning the engine, avoid spraying water or steam\
directly on the electrical
components or toward the rear side of the engine.
l Chromed wheels: Clean chrome-plated wheels using the same detergents use\
d for the body of the
vehicle. Aggressive wheel-cleaning agents can permanently stain chrome-p\
lated wheels.
Automatic washing - simple and quick
We do NOT recommend washing your car in an automatic wash during the fir\
st six months (because the
paint will not have hardened sufficiently).
An automatic wash is a simple and quick way to clean your car, but it is\
worth remembering that it may
not be as thorough as when you yourself go over the car with sponge and \
water.
Keeping the underbody clean is most important, especially in the winter.\
Some automatic
file:///K|/delme/2007_C70/07c70_08.htm (2 of 7)12/22/2006 9:15:52 PM

2007 Volvo C70
l Maintain your vehicle in accordance with your vehicle's maintenance sche\
dule.
189 09 Maintenance and servicing
Hood
Opening the hood
To open the hood:
1. Pull the lever located under the left side of the dash to release the\
hood lock.
2. Lift the hood slightly.
3. Press up the release control located under the front edge of the hood\
(at the center) up to the right, and
lift the hood.
WARNING
Check that the hood locks engage properly when
closed.
190 09 Maintenance and servicing
Engine compartment
file:///K|/delme/2007_C70/07c70_09.htm (5 of 36)12/22/2006 9:15:54 PM