light VOLVO XC90 2007 Manual Online
[x] Cancel search | Manufacturer: VOLVO, Model Year: 2007, Model line: XC90, Model: VOLVO XC90 2007Pages: 268, PDF Size: 8.57 MB
Page 206 of 268

2007 Volvo XC90
Replacing high/low beams/turn signal/parking light bulbs
The entire lamp housing must be lifted out when replacing these bulbs.
To lift out the lamp housing:
- Switch off the ignition.
- Open the hood.
- Pull up the retaining pins (see the illustration above).
- Lift out the lamp housing.
WARNING!
Active Bi-Xenon headlights (option) - due to the high voltage used by \
these headlights, these bulbs
should only be replaced by an authorized Volvo service technician.
pg. 195 Maintenance
Replacing bulbs
file:///K|/ownersdocs/2007/2007_XC90/07xc90_09.htm (20 of 37)12/30/200\
6 5:53:50 PM
Page 207 of 268

2007 Volvo XC90
Location of the bulbs in the headlight housing
- Low beam headlight/Active Bi-Xenon headlight (option)
- High beam headlight
- Turn signal
- Parking light
- Side marker light
Replacing the low beam bulb
(Halogen headlights)
- Remove the plastic cover over the bulb (1) by turning it countercloc\
kwise.
- Pull the connector from the lamp housing (2).
- Loosen the bulb's retaining spring by first moving it to the right and\
then moving it out of the way.
- Pull out the bulb from the holder.
- Insert the new bulb (without touching the glass) in the holder.
- Move the retaining spring up and push it slightly to the left until it\
seats properly.
- Press the bulb holder into place on the headlight housing.
- Reinstall the plastic cap. The letters "HAUT" on the cap must be upwar\
d.
file:///K|/ownersdocs/2007/2007_XC90/07xc90_09.htm (21 of 37)12/30/200\
6 5:53:50 PM
Page 208 of 268

2007 Volvo XC90
pg. 196 Maintenance
Replacing bulbs
Replacing the high beam bulb
(Halogen headlights)
- Remove the rubber cover (1) by pulling it off.
- Pull the connector from the lamp housing (2).
- Loosen the bulb's retaining spring by first moving it to the right and\
then moving it out of the way.
- Pull out the bulb from the holder.
- Insert the new bulb (without touching the glass) in the holder.
- Move the retaining spring up and push it slightly to the left until it\
seats properly.
- Press the bulb holder into place on the headlight housing.
- Press the rubber cover into place.
Replacing the high beam bulb
(Active Bi-Xenon headlights)
file:///K|/ownersdocs/2007/2007_XC90/07xc90_09.htm (22 of 37)12/30/200\
6 5:53:50 PM
Page 209 of 268

2007 Volvo XC90
- Remove the rubber cover over the bulb (1) by pulling it off.
- Turn the bulb holder counterclockwise and pull it out of the headlight\
housing.
- Remove the connector from the bulb unit (2) by pressing the lock tab\
out and pulling.
- Connect the connector to the new bulb unit until it clicks into place.\
- Press a new bulb unit into the headlight housing and turn it clockwise\
into place.
- Reinstall the plastic cover.
pg. 197 Maintenance
Replacing bulbs
Replacing the parking light/side marker light bulbs
- Turn the lamp holder approximately 1/4 turn counterclockwise and pull \
it out of the headlight housing.
- Pull the bulb straight out.
- Align the guide lugs on the side of the base of the new bulb in the gr\
ooves in the holder and press it
into place.
- Press the lamp holder into the place in the headlight housing and turn\
it approximately 1/4 turn
clockwise.
file:///K|/ownersdocs/2007/2007_XC90/07xc90_09.htm (23 of 37)12/30/200\
6 5:53:50 PM
Page 210 of 268

2007 Volvo XC90
Replacing the turn signal bulb
- Turn the lamp holder approximately 1/4 turn counterclockwise and pull \
it out of the headlight housing.
- Press in the bulb slightly and pull it out of the holder.
- Align the guide lugs on the side of the base of the new bulb in the gr\
ooves in the holder. Press it in and
turn it slightly clockwise.
- Press the lamp holder into the place in the headlight housing and turn\
it approximately 1/4 turn
clockwise.
Front fog lights
Avoid touching the glass on the bulb
with your fingers.
- Switch off the ignition.
- Turn the bulb holder slightly counterclockwise to release it.
- Replace the bulb. The shape of the foot of the bulb corresponds to the\
shape of the bulb holder.
- Reinstall the bulb holder by turning it slightly clockwise. The side o\
f the holder marked "TOP" should
face upward.
pg. 198 Maintenance
Replacing bulbs
file:///K|/ownersdocs/2007/2007_XC90/07xc90_09.htm (24 of 37)12/30/200\
6 5:53:50 PM
Page 211 of 268

2007 Volvo XC90
Location of tail light bulbs
1. Parking light
2. Turn signal
3. Back-up light
4. Parking light
5. Brake light
NOTE: If the message indicating a burned out bulb remains in the information \
display after a bulb has
been replaced, consult an authorized Volvo retailer or workshop.
Replacing bulbs in the tail light cluster
- Switch off all lights and turn ignition key to position 0.
- Fold down the lower section of the tailgate, and fold up the rear sect\
ion of the cargo area floor.
- If the vehicle is equipped with the optional grocery bag holder, detac\
h the holder's bands.
- Remove the corner panel (A in the illustration above).
- Open the cover (B) in the side panel by pulling the tab (C) upward\
/outward.
- Loosen the bolts (D).
- Pull the entire tail light housing straight out.
- Disconnect the wiring.
file:///K|/ownersdocs/2007/2007_XC90/07xc90_09.htm (25 of 37)12/30/200\
6 5:53:50 PM
Page 212 of 268

2007 Volvo XC90
- Place the tail light housing on a soft cloth to avoid scratching the l\
ens.
- Turn the lamp holder(s) counterclockwise and pull out.
- Turn signal, back-up light, brake light bulbs: Turn the bulb countercl\
ockwise and remove it.
- Parking light bulbs: Pull the bulb straight out.
- Insert a new bulb.
- Place the lamp holder in the groove and turn clockwise.
- Press wiring back into place.
- Align the tail light housing with the holes for the retaining bolts an\
d press it into place.
- Tighten the retaining bolts.
- Reinsert the side and corner panels.
pg. 199 Maintenance
Replacing bulbs
Rear fog light
- Switch off the ignition.
- Carefully insert a small screwdriver (see illustration above).
- Pry out the lamp housing.
- Turn the bulb holder counterclockwise and remove it.
- Turn the bulb counterclockwise and remove it.
- Insert a new bulb and press the lamp housing back into place.
file:///K|/ownersdocs/2007/2007_XC90/07xc90_09.htm (26 of 37)12/30/200\
6 5:53:50 PM
Page 213 of 268

2007 Volvo XC90
Door step courtesy lights
The door step courtesy lights are located under the dashboard on the dri\
ver's and passenger's sides. To
replace a bulb:
- Carefully insert a screwdriver and pry out the lens.
- Replace the defective bulb.
- Reinstall the lens.
Cargo compartment light
- Carefully insert a screwdriver and pry out the lens.
- Pry out the bulb and replace it.
- Press the lens back into place.
pg. 200 Maintenance
Replacing bulbs
file:///K|/ownersdocs/2007/2007_XC90/07xc90_09.htm (27 of 37)12/30/200\
6 5:53:50 PM
Page 214 of 268

2007 Volvo XC90
Vanity mirror lights
- Carefully insert a screwdriver and pry out the lens.
- Pry out the bulb and replace it.
- Carefully press the lower edge of lens onto the four tabs and press th\
e upper edge of the lens into place.
License plate lights
- Switch off the ignition.
- Loosen the screws with a Torx screwdriver.
- Turn the bulb holder counterclockwise and pull it out.
- Pull out the defective bulb and insert a new one.
- Reinsert the bulb holder into the housing and turn it clockwise.
- Reinstall the housing and screw it into place.
NOTE: Other bulbs may be difficult for you to replace yourself. Let an author\
ized Volvo retailer
replace these bulbs if necessary.
pg. 201 Maintenance
file:///K|/ownersdocs/2007/2007_XC90/07xc90_09.htm (28 of 37)12/30/200\
6 5:53:50 PM
Page 216 of 268

2007 Volvo XC90
Fuses
Fuses in the engine compartment
When replacing fuses, be sure to replace a blown fuse with a new one of \
the same color and amperage
(written on the fuse). No. Amperage
1. ABS 30
2. ABS 30
3. Headlight washers 35
4. -
5. Auxiliary lights (option) 20
6. Starter motor relay 35
7. Windshield wipers 25
8. Fuel pump 15
9. Transmission control module (V8 and 6- cyl.) 15
10. Ignition coils, engine control module 20
11. Throttle pedal sensor, A/C compressor, e-box fan 10
12. Engine control module, fuel injectors, mass airflow sensor 15
13. Throttle control (V8), Intake manifold actuator (6-cyl.) 10
14. Heated oxygen sensor. 20
15. Crankcase ventilation, solenoid valves, A/C connection, leakage diag\
nostics, engine
control module (V8, 6-cyl.), mass airflow sensor (V8) 15
16. Driver's side low beam headlight 20
17. Passenger's side low beam headlight 20
file:///K|/ownersdocs/2007/2007_XC90/07xc90_09.htm (30 of 37)12/30/200\
6 5:53:51 PM