VOLVO XC90 TWIN ENGINE 2018 Owners Manual

LOADING, STORAGE AND PASSENGER COMPARTMENT
* Option/accessory.589
Load anchoring eyelets
The fold-out eyelets in the cargo compartment
can be used to secure objects with straps, a net,
etc.
WARNING Hard, sharp and/or heavy objects in or pro-
truding from the vehicle can cause injury in
the event of hard braking.
Always secure large and heavy objects with a
seat belt or cargo retaining straps.
Related information
•
Loading recommendations (p. 586)
• Weights (p. 659) Installing and removing the cargo
compartment cover*
The cover can be rolled out to conceal objects
in the cargo compartment.
Installing the cargo compartment
cover 3 Press the end piece on one side of the cover
into the retaining bracket in the side panel of
the cargo compartment.
Then put the other end piece in the recess in
the side panel on the opposite side. Push the end piece down on both sides, one
at a time.
>

When a click is heard and the red marks
on each end piece are no longer visible,
the cover is in place. Check that it is
secure.
Removing the cargo compartment
cover
In retracted position:
1. Press the button on one of the cover's ends and lift out that end.
For 7-seat models - remove the third row
seat belt latches from the hooks above the
side panels.
2. Carefully lift the cover up and out. > The other end will release automaticallyand the cover can then be lifted out of the
cargo compartment.
Related information
• Operating the cargo compartment cover*
(p. 590)
• Loading recommendations (p. 586)
3
In the XC90 Excellence, the cargo compartment cover is permanently fixed\
and cannot be taken out or put in.

LOADING, STORAGE AND PASSENGER COMPARTMENT
* Option/accessory.
590 Operating the cargo compartment
cover*
The cover can be used in two positions: fully
open to completely cover the cargo compart-
ment or partially retracted to make it easier to
reach further into the cargo compartment.
Fully open7-seat models
1. Hang the third-row seat belt latches in the
hooks provided in the side panels. Grasp the handle and pull the cover out and
above the side panels in the cargo compart-
ment. Pull the cover to its end position.
With the cover completely open (covering the
cargo compartment), press the attaching
pins at the end of the cover into the grooves
on the side panels and release the cover
slightly while pressing the handle lightly
downward to hook the pins into the grooves.
>

The cover will be secured in the fully open
position. 5-seat models Grasp the handle and pull the cover out and
above the side panels in the cargo compart-
ment. Pull the cover to its end position.
With the cover completely open (covering the
cargo compartment), press the attaching
pins at the end of the cover into the grooves
on the side panels and release the cover
slightly while pressing the handle lightly
downward to hook the pins into the grooves.
>

The cover will be secured in the fully open
position.

LOADING, STORAGE AND PASSENGER COMPARTMENT
* Option/accessory.591
Loading modeFrom the fully retracted position - grasp the
handle and pull the cover up and over the
side panels in the cargo compartment. Pull to
the end position and press the attaching pins
at the end of the cover into the grooves in
the side panels of the vehicle. (If the cover is
already fully open, see next section.)
From the fully open position - grasp the han-
dle and press the cover's attaching pins
down into the grooves in the side panels and
then release.
>

Retract the cover until it stops in the parti-
ally retracted position. If your hands are full: In the fully open position, push the cover's
handle slightly upward with e.g. your elbow.
>
The cover will retract until it stops in
the partially retracted position.
To fully open the cover from the partially retrac-
ted position:
1.

Grasp the handle and pull the cover out as
far as possible.
2. Let the cover retract slightly and press the handle slightly downward.
> The cover will be secured in the fully openposition.
CAUTION Do not place objects on top of the cargo
compartment cover.
WARNING In 7-seat models - never have a cargo com-
partment cover mounted when there are pas-
sengers in the rear seats. This could lead to
serious injury in the event of a collision.
Retracting the cover
1. From the fully opened position:
Lift the cover's handle and pull it rearward to
release the cover's attaching pins from the
grooves. Let the cover retract.
From the partially retracted position:
Grasp the handle and pull the cover out of
the groves to the fully open position. Lift the
handle and pull it rearward to release the
cover's attaching pins from the grooves. Let
the cover retract.
2. Let the cover retract with its attaching pins above the side panels until it stops in the
fully retracted position.
Related information
• Installing and removing the cargo compart-
ment cover* (p. 589)

LOADING, STORAGE AND PASSENGER COMPARTMENT
* Option/accessory.
592 Installing and removing the steel
cargo grid*
The steel cargo grid prevents loads or pets in
the cargo compartment from being thrown for-
ward into the passenger compartment. For safety reasons, the steel grid must always be
installed and secured correctly.
WARNING
Under no circumstances may a person be in
the cargo compartment when the vehicle is
moving. Heavy braking or a collision could
lead to serious injury.
The steel grid consists of the grid itself and two
separate mounting brackets. Each of the mount- ing brackets has a screw cover and two plastic
sleeves for the grid.
WARNING The steel cargo grid may only be used in the
rear position described here. The ceiling
attachment points behind the front seats are
not intended to anchor the steel grid.
WARNING
For safety reasons, the third-row seats
4
must
be folded down when the steel cargo grid is
mounted in the vehicle.
CAUTION The steel cargo grid and the cargo compart-
ment cover cannot be mounted at the same
time.
Installation1. Fold down the rear seats and lift in the steel
grid through one of the rear doors or the tail-
gate. The curved (convex) side of the grid
should face toward the cargo compartment
and the hooks on each side of the grid
should face upward. The mounting brackets
and plastic sleeves are not needed in this
step. 2. Press one of the grid's hooks into the larger
hole in the ceiling attachment point (1).
Grasp the grid near the hook and pull/push it
into the smaller hole (2).
>

The hook is now secured in the attach-
ment point.
3. Repeat step 2 above to secure the other hook in the attachment point on the opposite
side.
WARNING Make sure the cargo grid's hooks are securely
attached in the ceiling attachment points to
help ensure the grid does not come loose.
4
7-seat models only.

LOADING, STORAGE AND PASSENGER COMPARTMENT
}}
* Option/accessory. 5934. Attach the mounting bracket's hook through
the cargo anchoring eyelet near the floor of
the cargo compartment and insert the threa-
ded section of the bracket through the grid's
lower attachment hole (1).
Slide the plastic sleeve onto the threaded
section of the mounting bracket with the
sleeve's flange turned upward and press it
down through the hole. Screw the screw
cover into place until its underside is approxi-
mately 5 mm from the grid (2).
5.

Repeat step 4 for the opposite side.
6. Center the grid and then tighten both mount- ing brackets, moving back and forth between
them until the grid is securely in place.
Removing the coverRemove the steel grid by performing the above
steps in reverse order.
It can be a good idea to remove the mounting
brackets before removing the plastic sleeves
from the holes in the grid.
Related information
• Loading recommendations (p. 586)
• Load anchoring eyelets (p. 589) Installing and removing the cargo
net*
The cargo net helps prevent objects in the cargo
compartment from entering the passenger com-
partment in the event of a sudden stop or hard
braking. The cargo net is attached at four points. For safety reasons, the cargo net must always be
mounted and secured according to the following
description.
The net is made of strong nylon weave and can
be attached in two different locations in the vehi-
cle:
• Rear mounting - behind the second row of
seats.
• Front mounting - behind the front seats.

||LOADING, STORAGE AND PASSENGER COMPARTMENT
594
WARNING
Objects in the cargo compartment must
always be securely anchored, even with a cor-
rectly installed cargo net.
Installing the cargo net
WARNING
All of the cargo net's upper consoles, hooks
and straps must be securely mounted and
attached before the net is used.
Never use the net if it is damaged.
NOTE
With front mounting, the cargo net is most
easily installed via a rear door.
1. Fold out the cargo net and make sure that
the upper rod folds out and locks into posi-
tion.
2.

Insert one of the net's hooks into the front or
rear ceiling mounting point with the strap
lock facing you. 3. Insert the other upper hook into the ceiling
mounting point on the opposite side. The
telescopic spring-loaded hooks make mount-
ing easier.
Make sure that the net's hooks are pushed
forward as far as possible into their respec-
tive mounting points. 4. Rear mounting: With the cargo net hooked
into the rear ceiling mounting points, attach
the net's straps into the front floor eyelets in
the cargo compartment. Rear mounting.
Front mounting: With the cargo net mounted
in the front ceiling mounting points, hook the
straps into the outer eyelets on the front seat
rails behind the seats. Attaching the net is
easier if the seat backrests are upright and
the seats are moved slightly forward.

LOADING, STORAGE AND PASSENGER COMPARTMENT
595Front mounting.
Move the seat or backrest only until it
touches the net. Moving it with too much
force or applying too much pressure to the
net could lead to damage.
CAUTION If a seat or backrest is pressed with too much
force back against the cargo net, the net and
its ceiling brackets could be damaged.
5. Pull the straps until the cargo net is taut.
Removing the cargo netThe cargo net can be easily removed and folded
up.
1. Loosen the cargo net by pressing the button
on the strap locks on each side and pulling
to allow some slack.
2. Press in the catches and release both of the strap hooks.
3. Unhook the upper hooks and remove the net from the ceiling mounting points.
4. Press the red button on the rod so that it can be folded. Fold and roll up the net. Store the
net in its case.
Related information
• Loading recommendations (p. 586)
• Load anchoring eyelets (p. 589)

M A I N T E N A N C E A N D S E R V I C E

MAINTENANCE AND SERVICE
598Volvo's service program
To keep the vehicle as safe and reliable as pos-
sible, follow the Volvo service schedule speci-
fied in the Warranty and Maintenance Records
Information booklet.
Volvo recommends having an authorized Volvo
workshop perform service and maintenance.
Volvo workshops have the staff, service literature
and special tools to guarantee the highest quality
of service.
CAUTION To ensure the Volvo warranty is not invalida-
ted, check and follow the Service and War-
ranty Booklet.
Service and repairsService the vehicle regularly. Follow Volvo's rec-
ommended service intervals.
Detailed inspection and repairs may only be per-
formed by an authorized workshop.
WARNING
Do not make any repairs on this vehicle your-
self. Electrical cables and/or components that
have come loose may only be corrected by an
authorized workshop – an authorized Volvo
workshop is recommended.
IntroductionThe maintenance services contain several checks
that require special instruments and tools and
therefore must be performed by a qualified tech-
nician. To keep your Volvo in top condition, spec-
ify time-tested and proven Genuine Volvo Parts
and Accessories.
The Federal Clean Air Act - U.S.
The Federal Clean Air Act requires vehicle manu-
facturers to furnish written instructions to the ulti-
mate purchaser to assure the proper servicing
and function of the components that control
emissions. These services, which are listed in the
"Warranty and Service Records Information"
booklet, are not covered by the warranty. You will
be required to pay for labor and material used.
Maintenance
Your Volvo passed several major inspections
before it was delivered to you, in accordance with
Volvo specifications. The maintenance proce-
dures outlined in the Warranty and Service
Records Information booklet, many of which will
positively affect your vehicle's emissions, should
be performed as indicated. It is recommended
that receipts for vehicle emission maintenance be
retained in case questions arise concerning
maintenance. Inspection and maintenance should
also be performed anytime a malfunction is
observed or suspected.
Applicable warranties - U.S./Canada
In accordance with applicable U.S. and Canadian
regulations, the following list of warranties is pro-
vided.
• New Vehicle Limited Warranty
• Parts and Accessories Limited Warranty
• Corrosion Protection Limited Warranty
• Seat Belt and Supplemental Restraint Sys-
tems Limited Warranty
• Emission Design and Defect Warranty
• Emission Performance Warranty
These are federal warranties. Other warranties
are provided as required by state/provincial law.
Refer to your separate Warranty and Service
Records Information booklet for detailed informa-
tion concerning each of the warranties.