ECU VOLVO XC90 TWIN ENGINE HYBRID 2017 Workshop Manual

WHEELS AND TIRES
498
Using the tire sealing system

Overview
Electrical wire
Hose
Air release valve
Protective hose cover
Speed limit sticker (on the rear side of thecompressor)
Bottle holder (orange cover)
Air pressure gauge
Bottle with sealing compound
On/Off switch
Connecting
1. Activate the vehicle's hazard warning flashersif the tire sealing system is to be used in anarea with traffic.
If the flat tire was caused by a nail, etc., donot remove it from the tire. It will help to sealthe hole.
2.Peel off the speed limit sticker and affix it tothe windshield so that it is clearly visible tothe driver. The vehicle should not be drivenfaster than 50 mph (80 km/h) while using atire that has been temporarily repaired withthe tire sealing system.
3.Ensure that the on/off switch is in position 0and take out the electrical wire and hose.

NOTE
Do not break the seal on the bottle. Thisoccurs automatically when the bottle isscrewed into the holder.

WARNING
Contact with the sealing compound maycause skin irritation. If contact occurs, washthe affected area immediately with soap andwater.
4.Unscrew the orange cover over the bottleholder on the compressor and unscrew thecap on the bottle of sealing compound.
5. Screw the bottle into the bottle holder as faras possible.

WARNING
The bottle is equipped with a catch to keep itsecurely in place and help prevent sealingcompound leakage. Once in place, the bottlecannot be unscrewed. This must be done by atrained and qualified Volvo service technician.

MAINTENANCE AND SERVICING
545
With the wipers in the service position, foldout the wiper arm from the windshield. Pressthe button on the wiper blade attachmentand pull the wiper blade straight out, parallelwith the wiper arm.
Slide in the new wiper blade until it clicksinto place.
Check that the blade is securely in place.
4.Press the wipers back against the wind-shield.
The windshield wiper blades are different lengths

NOTE
The windshield wiper blades are differentlengths. The blade on the driver

MAINTENANCE AND SERVICING
549

CAUTION
When using an automatic car wash in whichthe vehicle has to be able to roll freely, theauto-hold brake function must be deactivated.If this is not done, the brakes will automati-cally be applied when the vehicle is stationary.
To deactivate this function:
1.Drive the vehicle into the car wash
2. Turn off the auto-hold function using thecontrol on the center console
3. Turn off the parking brake's automaticfunction in the center display's Top view
(tap Settings, tap My CarElectricParking Brake and deselect AutoActivate Parking Brake)
4.Put the gear selector in N
5.Switch off the ignition by turning the startknob to STOP and holding it in this posi-tion for at least 4 seconds
The vehicle will then be able to roll freely.
CAUTION
•Before driving into an automatic carwash, turn off the optional rain sensor toavoid damaging the windshield wipers.
•Make sure that side view mirrors, auxiliarylamps, etc, are secure, and that anyantenna(s) are retracted or removed. Oth-erwise there is risk of the machine dis-lodging them.
•Chromed wheels: Clean chrome-platedwheels using the same detergents usedfor the body of the vehicle. Aggressivewheel-cleaning agents can permanentlystain chrome-plated wheels.

WARNING
•When the vehicle is driven immediatelyafter being washed, apply the brakes,including the parking brake, several timesin order to remove any moisture from thebrake linings.
•Engine cleaning agents should not beused when the engine is warm. This con-stitutes a fire risk.

Exterior components
Volvo recommends the use of special cleaningproducts, available at your Volvo retailer, forcleaning colored plastic, rubber, or ornamentalcomponents such as chromed strips on the exte-
rior of your vehicle. The instructions for usingthese products should be followed carefully. Sol-vents or stain removers should not be used.
CAUTION
•Avoid waxing or polishing plastic or rub-ber components
•Polishing chromed strips can wear awayor damage the surface
•Polishes containing abrasive substancesshould not be used

Related information
•Paint damage (p. 553)
•Corrosion protection (p. 552)
•Polishing and waxing (p. 554)
•Windshield wipers in the service position(p. 543)

MAINTENANCE AND SERVICING
* Option/accessory, for more information, see Introduction.551
2. Finish by rubbing the wheel with absorbentpaper or a towel.
Type 3 (dry soil or dust)
1. Remove the soil/dust with a soft brush.
2. Same procedure as for type I stains.

CAUTION
Sharp objects, such as rings, could damagethe leather on the steering wheel.

Leather panels *
Leather should be allowed to breath. Never coverthe upper side of the dashboard or door panelswith a plastic protector. Ask your Volvo retailerabout Leather Care Kit 951 0251 and LeatherSoftener 943 7429.

Spots on interior plastic, metal, or wood
surfaces
Cleaning interior plastic components should bedone with a moist microfiber cloth. Consult yourVolvo retailer.
CAUTION
•Do not use cleaning agents with highalcohol content such as washer fluid toclean instrument panel glass.
•Never spray cleaning agents or waterdirectly onto components with electricalbuttons or controls. Clean components ofthis type by applying the cleaning agent/water sparingly to a cloth and wiping thecomponents so that no liquid penetratesinto these components.

Cleaning the seat belts
Clean only with lukewarm water and a mild soapsolution.

Cleaning floor mats
The floor mats should be vacuumed or brushedclean regularly, especially during winter whenthey should be taken out for drying. Spots on tex-tile mats can be removed with a mild detergent.For best protection in winter, Volvo recommendsthe use of Volvo rubber floor mats. Consult yourVolvo retailer.
WARNING
•Never use more than one floor mat at atime on the driver's floor. Before driving,remove the original mat from the driver'sseat floor before using any other type offloor mat. Any mat used in this positionshould be securely and properly anchoredin the attaching pins. An extra mat on thedriver's floor can cause the acceleratorand/or brake pedal to catch. Check thatthe movement of these pedals is notimpeded.
•Volvo's floor mats are specially manufac-tured for your car. They must be firmlysecured in the clips on the floor so thatthey cannot slide and become trappedunder the pedals on the driver's side.

Related information
•Cleaning the center display (p. 552)

INDEX
578
Registering child restraints 83
Remote key 238, 240, 248
immobilizer 234
linking to a driver profile 183
range 240
replacing the battery 235
restricted (red) key 240
Remote updates 507
Replacing bulbs 530
Replacing fuses 517, 518, 523, 527
Reporting safety defects 63
Roadside Assistance 14
Road sign information (RSI) 346, 348
Rollover Protection System (ROPS) 267
Roll Stability Control (RSC) 267
Run-off mitigation 355, 357
S
Safety, occupant62
Safety defects, reporting63
Safety locks, child257
Safety mode79
Seat
adjusting the passenger's seat from the
driver's seat169
Seat belt
reminder70
Seat belts
Automatic locking retractor/Emergency
locking retractor 83
buckling 67
pretensioners 66, 67
reminder 70
securing child restraint systems 84, 86, 89
unbuckling 67
use during pregnancy 64
using 66
Seats
rear 175
Sensus 22
Service
connected service booking 508
Settings view
categories 116
resetting 119
system settings 118
Shiftlock
override 424
Side door mirrors 108
Side impact airbags 77
Sirius Satellite radio
Travel link 443
SiriusXM® Satellite radio
traffic information439, 440, 442
Snow chains485
Snow tires485
Sound settings
media463
ringtones454
Sound settings, audio system 433, 463
Specifications
bulbs536
Speed camera alert346
Speed limiter267, 269, 273
automatic269, 271
deactivating/reactivating272
starting/activating268
Spin control263
Stability system263
sport mode264
Start and lock system
type designations259
Starting and driving376
Starting the engine402
Starting the vehicle
after a crash (crash mode) 79, 80
Start inhibitor (immobilizer)234
Steel grid in cargo area225