warning YAMAHA CYGNUS 125 2006 User Guide

■ ■■ ■
■Adjust mixing ratio1.Open the rubber cover which locates
under seat. 1. Remove the crankcase cover.
2. Take out the filter to clean.
■ ■■ ■
■Crankcase filterMAINTENANCE
WARNING

Use the specified solvent to clean
the parts, never use petrol or sol-
vent with low flash point which willcause fire or explosion.CAUTION:

Do not twist the filter element toavoid of damages.
3. Apply suitable engine oil (SAE 10W-
30) to the filter element after drying.
4.Install the filter element, crankcase
cover and kick-starter back.CAUTION:

To avoid fast wearing of the parts
in belt chamber, you should main-
tain the filter element in the belt
chamber as per time and mileagelisted in the Consumer Manual.2.Adjust the screw.
NOTE:
The mixing ratio pre-set should beoperated by local agency.
7-6
mixing ratio
adjustment
screw

Front brake (drum brake)
1.Hold the brake lever, check whether
the wear indicator 1 reaches wear
margin 2.
2.If the indicator points to the wear
margin, ask your agency to replace the
brake block.
WARNING

1.Use the specified brake fluid,
otherwise, the rubber seal ring will
distort and cause leakage, thus ren-
der brake failure.
2.Refuel the same model of brake
fluid. Mix different brake fluid will
cause hazard chemical reaction
and render brake failure.
3.Avoid water going into the main
cylinder when refueling, it will de-
crease the boiling point of the brakeMAINTENANCE■ ■■ ■
■Check front/rear brakeFront brake (dish brake)
Hold the front brake lever, if the wear
indicator of brake block touches the
brake disc, ask your agency to replace
the brake block.
Brake fluid: YAHAMA brake fluid
DOT #3 or DOT #4. fluid and arise air bind.
4.The brake fluid will erode the
varnish surface and plastic
components, clean the fluid imme-
diately if splashed.
5.If you cannot refuel the brake fluid
to the standard level, seek assis-
tance from your agency.Rear brake
1.Hold the brake lever, check whether
the wear indicator reaches wear margin.
1. wear indicator 2. wear margin2.If the indicator points to the wear
margin, ask your agency to replace the
brake block.
7-8
wear indicator
brake disc
1
2
21

MAINTENANCE
■ ■■ ■
■Check front forkThe motorcycle shall be securely
supported when being checked, so
that it would not fall over.1.Visual examination
Check the inner tubes for scratches,
damages or oil leakage.
2.Action examination
Pull the motorcycle to a flat place.
a.Hold the handlebar and keep the
motorcycle upright, grasp the front and
rear brake lever to avoid slipping when
checking.
b.Actuate the handlebar up and right
for several times to check the action
of front fork.
CAUTION:

If you find any damage, oil leakage
or malfunction, ask your agency tocheck it.■ ■■ ■
■Check steering systemWorn or loose steering bearings may
cause danger. Place a stand under the
engine to raise the front wheel off
ground. Hold the lower ends of the
front fork and move them forward and
backward. If any free play can be felt,
ask your agency to check it.
WARNING

Make sure that the motorcycle
stands steadily when checking thesteering system to avoid hazard.Fuse specification: 15A
■ ■■ ■
■Replace fuse1.Remove the cover of accumulator.
2.Remove the negative terminal (-) and
positive terminal (+), then you can
take out the fuse.
3.Replace the blown fuse.CAUTION:

Do not use fuses of a higher amper-
age rating than recommended to
avoid extensive damages to the elec-
trical system, which may result infire.
WARNING
7-9

MAINTENANCE2.Remove the negative terminal (-) and
positive terminal (+), and you can take
off the battery.
3.Clean the connector.
Use steel brush to clean the rust and
dirt on the connector, after coating thin
grease to the connector, assemble the
parts reversely.CAUTION:

1.The accumulator equipped is free
of maintenance (do not need to add
water), you have to use the sealed
charger (constant voltage/current
value or constant voltage value)
Electrolyte is poisonous and dan-
gerous and will cause severe burn
injury. It contains strong acid;
avoid any contact with skin, eyes
or clothing. In case of contact, the
procedure is as per following:
External: Flush with water. Internal:
Drink large amount of boiled water
or milk, and drink milk of magnesia,
eggs mixture or vegetable oil, and
promptly consult for medical atten-
tion immediately.
Eyes: Flush with water for 15 min-
utes and seek prompt medical
attention. Batteries may produce
explosive gases. Therefore, keep
fire source (sparks, flames,
cigarettes, etc.) away from batter-
ies and provide sufficient ventila-
tion when charging or using the
battery in an enclosed space. Take
care of your eyes while working
around the battery.
Anyway, keep children away frombattery.
■ ■■ ■
■Accumulator·Disassembly of the accumulator
1.Remove the battery cover.
CAUTION:

1 11 1
1 Never attempt to remove the cov-
ers on the accumulator.
2 22 2
2 If the motorcycle will not be used
for more than 15 days, you should
charge the battery before riding.
3 33 3
3 If the motorcycle is always ser-
viced in low speed and short
distance, and will be started
frequently, you should check the
battery regularly and charge it ifnecessary. specified for the accumulator,
otherwise, it will shorten the service
lift of accumulator.
2.Before using the battery for the
first time, you should charge it for
about 1-2 hours to extend the ser-vice life.
WARNING
7-10
accumulator
connector