engine YAMAHA DT125R 2000 Service Manual

7-2
MOTORCYCLE CARE AND STORAGE
1
2
3
4
5
67
8
9 8 8
Improper cleaning can damage
windshields, cowlings, panels
and other plastic parts. Use
only a soft, clean cloth or
sponge with mild detergent
and water to clean plastic.
8 8
Do not use any harsh chemical
products on plastic parts. Be
sure to avoid using cloths or
sponges which have been in
contact with strong or abra-
sive cleaning products, sol-
vent or thinner, fuel (gasoline),
rust removers or inhibitors,
brake fluid, antifreeze or elec-
trolyte.8 8
Do not use high-pressure
washers or steam-jet cleaners
since they cause water seep-
age and deterioration in the
following areas: seals (of
wheel bearings, swingarm
bearings, forks and brakes),
electric components (cou-
plers, connectors, instru-
ments, switches and lights),
breather hoses and vents.
8 8
For motorcycles equipped
with a windshield: Do not use
strong cleaners or hard
sponges as they will cause
dulling or scratching. Some
cleaning compounds for plas-
tic may leave scratches on the
windshield. Test the product
on a small hidden part of the
windshield to make sure they
do not leave any marks. If the
windshield is scratched, use a
quality plastic polishing com-
pound after washing.
After riding in the rain, near the seaor on salt-sprayed roadsSince sea salt or salt sprayed on the
roads in the winter are extremely cor-
rosive in combination with water,
carry out the following steps after
each ride in the rain, near the sea or
on salt-sprayed roads. (Salt sprayed
in the winter may remain on the roads
well into spring.)
1.Clean your motorcycle with cold
water and soap after the engine
has cooled down.
ECA00012
cCDo not use warm water since it
increases the corrosive action of
the salt.2.Be sure to apply a corrosion pro-
tection spray on all (even
chrome- and nickel-plated) metal
surfaces to prevent corrosion.
3MB-9-E7 12/27/00 2:52 PM Page 79

7-4
MOTORCYCLE CARE AND STORAGE
1
2
3
4
5
67
8
9
StorageShort-term
Always store your motorcycle in a
cool, dry place and, if necessary, pro-
tect it against dust with a porous
cover.
ECA00014
cC8
8
Storing the motorcycle in a
poorly ventilated room or cov-
ering it with a tarp while it is
still wet will allow water and
humidity to seep in and cause
rust.
8 8
To prevent corrosion, avoid
damp cellars, stables (because
of the presence of ammonia)
and areas where strong chemi-
cals are stored.
Long-term
Before storing your motorcycle for
several months:
1.Follow all the instructions in the
ÒCareÓ section of this chapter.
2.Drain the carburetor float cham-
ber by loosening the drain bolt;
this will prevent fuel deposits
from building up. Pour the
drained fuel into the fuel tank.
3.Only for motorcycles equipped
with a fuel cock which has an
ÒOFFÓ position: Turn the fuel
cock to ÒOFFÓ.
4.Fill up the fuel tank and add fuel
stabilizer (if available) to prevent
the fuel tank from rusting and the
fuel from deteriorating.
5.Perform the following steps to
protect the cylinder, piston rings,
etc. from corrosion.a.Remove the spark plug cap and
spark plug.
b.Pour a teaspoonful of engine oil
into the spark plug bore.
c.Install the spark plug cap onto
the spark plug and place the
spark plug on the cylinder head
so that the electrodes are
grounded. (This will limit spark-
ing during the next step.)
d.Turn the engine over several
times with the starter. (This will
coat the cylinder wall with oil.)
e.Remove the spark plug cap from
the spark plug, install the spark
plug and then the spark plug
cap.
EWA00003
wWhen turning the engine over, be
sure to ground the spark plug elec-
trodes to prevent damage or injury
from sparking.
3MB-9-E7 12/27/00 2:52 PM Page 81

8-1
1
2
3
4
5
6
78
9
EAU01038
SPECIFICATIONS
Specifications
ModelDT125R
Dimensions
Overall length2,170 mm
2,235 mm (N, S, SF, CH, A only)
Overall width830 mm
Overall height1,255 mm
Seat height885 mm
Wheel base1,415 mm
Ground clearance315 mm
Minimum turning radius2,100 mm
Basic weight (with oil and
full fuel tank)127 kg
129 kg (CH, A only)
Engine
Engine typeLiquid-cooled 2-stroke
Cylinder arrangementForward-inclined single
cylinder
Displacement124 cm
3
Bore ´Stroke56.0 ´50.7 mm Compression ratio6.7:1
Starting systemKick starter
Lubrication systemSeparate lubrication
(Yamaha autolube)
Engine oil (2-cycle)
Type2 stroke engine oil
Capacity
Total amount1.2 L
Transmission oil
TypeSAE 10W30 type SE motor oil
Capacity
Periodic oil change0.75 L
Total amount0.8 L
Radiator capacity
(Including all routes)0.92 L
Air filterWet type element
Fuel
TypeRegular unleaded gasoline
Fuel tank capacity10 L
Reserve amount1.8 L
3MB-9-E7 12/27/00 2:52 PM Page 83