coolant capacity YAMAHA DT125R 2000 Owners Manual

6-13
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9
EAU01808
Cooling system1.Remove panel D. (See page 6-9
for panel removal and installation
procedures.)
2.Check the coolant level in the
reservoir tank when the engine is
cold as the coolant level will vary
with engine temperature. The
coolant level should be between
the maximum and minimum
marks.
3.If the level is low, add coolant or
distilled water to raise it to the
specified level.4.Install the panel.
EC000080
cCHard water or salt water is harmful
to the engine. You may use dis-
tilled water if you canÕt get soft
water.NOTE:
If water is added, have a Yamaha
dealer check the antifreeze content of
the coolant as soon as possible.If your motorcycle overheats, see
page 6-41 for details.
2
1
1.Maximum level mark
2.Minimum level mark
EAU03101
Changing the coolant1.Put the motorcycle on a level
place.
2.Remove cowling C and panel D.
(See page 6-8 ~ 6-9 for cowling
and panel removal and installa-
tion procedures.)
3.Remove the radiator cap stopper
bolt and the radiator cap.
12
1.Stopper bolt
2.Radiator cap
Reservoir tank capacity:
0.35 L
3MB-9-E7 12/27/00 2:52 PM Page 49

6-14
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
98.Install the reservoir tank hose.
9.Pour the recommended coolant
into the radiator until it is full.
Recommended antifreeze:
High quality ethylene glycol
antifreeze containing
corrosion inhibitors for
aluminum engines.
Antifreeze and water mixing ratio:
1:1
Total amount:
1.05 L
Reservoir tank capacity:
0.35 L
4.Place a container under the
engine and remove the coolant
drain bolt.5.Disconnect the reservoir tank
hose on the reservoir tank side
and drain the coolant from the
reservoir tank.
6.After draining the coolant, thor-
oughly flush the cooling system
with clean tap water.
7.Replace the coolant drain bolt
washer if it is damaged and tight-
en the coolant drain bolt to the
specified torque.
1
13
2
1.Drain bolt1.Reservoir tank hose
2.Maximum level mark
3.Minimum level mark
Tightening torque:
Coolant drain bolt:
10 Nm (1.0 m
0kg)
3MB-9-E7 12/27/00 2:52 PM Page 50