check engine light YAMAHA GP1300R 2007 Owners Manual

Features and functions
27
The bow eye is used to attach a rope to the
watercraft when transporting, mooring, or
towing it in an emergency.
EJU36020Stern rope holes
The stern rope holes are located at the stern
of the watercraft.
The stern rope holes are used to attach a rope
to the watercraft when transporting or moor-
ing it.
EJU31370Yamaha Engine Management System
(YEMS)
This model is equipped with an integrated,
computerized management system that con-
trols and adjusts ignition timing, fuel injection,
engine diagnostics, and the off-throttle steer-
ing (OTS) system.
EJU31420Multifunction information center
This meter contains the following functions for
help and convenience in operating the water-
craft.
CAUTION:
ECJ00060

Do not run the engine over 4000 r/min
when checking the operation of the
meter on land without supplying water,
otherwise the engine could overheat
and the catalytic converter could be se-
riously damaged.

Use the specified resistor-type spark
plugs and caps, otherwise the meter
may function erratically.
NOTE:

When the engine is started, all displays light
up for a few seconds, the buzzer sounds
twice, and then the meter starts to operate
normally.
1Bow eye
1Stern rope hole
1Tachometer
2Speedometer
3Hour meter/voltmeter
4Fuel level meter
5“WARNING” light
6Fuel level warning indicator
7Oil level warning indicator
8Engine overheat warning indicator
9Exhaust temperature warning indicator
10Check engine warning indicator
11Select button
UF1G74E0.book Page 27 Monday, July 31, 2006 10:10 AM

Features and functions
29
The meter shows the hours of engine opera-
tion that have elapsed since the watercraft
was new.
Voltmeter
The voltmeter is provided to display the volt-
age of the battery.
The voltmeter displays 12 volts or more when
the battery voltage is within specification.
If the voltage displayed is low, return to shore
and, if necessary, have a Yamaha dealer
check the charging system and the battery.
EJU31560Fuel level warning indicator
If the fuel remaining in the fuel tank drops to
about 13 L (3.4 US gal, 2.9 Imp gal), the low-
est two fuel level segments, the fuel level
warning indicator, and the “WARNING” light
begin to blink. The buzzer also starts sound-
ing intermittently.
If this occurs, refill the fuel tank as soon as
possible.
The warning signals will be cleared when the
engine is restarted after the fuel tank is re-
filled.
EJU31570Oil level warning indicator
If the oil remaining in the oil tank drops to
about 1.7 L (0.45 US gal, 0.37 Imp gal) or the
oil filter is clogged, the oil level warning indica-
tor and the “WARNING” light begin to blink.The buzzer also starts sounding intermittent-
ly.
If this occurs, refill the oil tank as soon as pos-
sible.
The warning signals will be cleared when the
engine is restarted after the oil tank is refilled.
NOTE:
If the oil level warning indicator and the
“WARNING” light blink when there is ade-
quate oil in the oil tank, have a Yamaha dealer
check the oil filter for dirt and clogs.
EJU31580Engine overheat warning indicator
This model is equipped with an engine over-
heat warning system.
If the engine starts to overheat, the “WARN-
ING” light and the engine overheat warning in-
dicator begin to blink, and the buzzer sounds
intermittently.
If this occurs, reduce the engine speed, return
to shore, and then check for water discharge
UF1G74E0.book Page 29 Monday, July 31, 2006 10:10 AM

Features and functions
30
at the cooling water pilot outlet while the en-
gine is running. If there is no discharge of wa-
ter, shut the engine off, and then check the
intake grate and impeller for clogging.
WARNING
EWJ00050
Before attempting to remove weeds or de-
bris from the intake grate or impeller, shut
the engine off and remove the clip from the
engine shut-off switch. Severe injury ordeath could result from coming in contact
with the rotating parts of the jet pump.
CAUTION:
ECJ00800
This watercraft is equipped with a catalytic
converter.

If the “WARNING” light, engine overheat
warning indicator, and buzzer come on,
reduce the engine speed and return to
shore. If you ignore these signals, the
engine will stop running and cannot be
restarted until the exhaust system cools
down.

If you cannot locate and correct the
cause of the overheating, consult a
Yamaha dealer. Continuing to operate at
higher speeds could result in severe en-
gine damage.
If the overheat warning is ignored, engine and
exhaust system heat may increase, particu-
larly if the watercraft is operated at higher
UF1G74E0.book Page 30 Monday, July 31, 2006 10:10 AM

Features and functions
31
speeds. If this occurs, the “WARNING” light
and the engine overheat warning indicator
come on and the buzzer sounds continuously.
In addition, the warning system will cut the ig-
nition to the engine to reduce the risk of se-
vere overheating. The engine cannot be
started until it cools down, so it may be neces-
sary to have the watercraft towed back to the
shore. (See “Towing the watercraft” on page
78 for towing procedures.)
The warning signals will be cleared when the
engine is restarted after it has cooled down.
NOTE:
If multiple warnings occur at the same time,
their priority is as follows:
(1) Final engine overheat warning
(2) Fuel level warning
(3) Oil level warning
(4) Initial engine overheat warning
(5) Exhaust temperature warning
(6) Check engine warning
EJU31610Exhaust temperature warning indicator
This model is equipped with an exhaust tem-
perature warning system.
If the exhaust temperature becomes too hot,
the “WARNING” light and the exhaust tem-
perature warning indicator begin to blink, and
the buzzer sounds intermittently.If this occurs, reduce the engine speed and
return to shore to allow the exhaust system to
cool down.
WARNING
EWJ00830
Do not touch the hot muffler or catalytic
converter during or immediately after en-
gine operation; they can cause serious
burns. In addition, the catalytic converter
becomes hotter after the engine stops be-
fore cooling down.
CAUTION:
ECJ00810
This model is equipped with a catalytic
converter.

If the “WARNING” light, exhaust temper-
ature warning indicator, and buzzer
come on, reduce the engine speed (be-
low 4000 r/min) and return to shore.

If you cannot locate and correct the
cause of the overheating, consult a
Yamaha dealer. Continuing to operate at
higher speeds could result in severe en-
gine damage.
The warning signals will be cleared when the
engine is restarted after it has cooled down.
EJU31630Check engine warning indicator
If a sensor malfunction or a short circuit is de-
tected, the “WARNING” light and the check
UF1G74E0.book Page 31 Monday, July 31, 2006 10:10 AM

Trouble recovery
74
Engine runs irregu-
larly or stallsFuel Empty Refill as soon as pos-
sible36
Stale or contaminat-
edHave serviced by
Yamaha dealer66
Fuel tank Water or dirt present Have serviced by
Yamaha dealer66
Spark plug Fouled or defective Replace 67
Incorrect heat range Replace 67
Gap incorrect Adjust 67
Spark plug
capLoose Connect properly 67
Cracked, torn, or
damagedReplace
—
Electrical wir-
ingLoose connection Tighten or connect
properly—
Fuel injec-
tion systemFaulty or clogged in-
jectorsHave serviced by
Yamaha dealer—
Warning light or in-
dicator blinksFuel level Empty Refill as soon as pos-
sible36
Engine oil
levelEmpty Refill immediately 36
Oil filter clogged Have serviced by
Yamaha dealer—
Engine over-
heatedJet intake clogged Clean 76
Water temperature
sensor is failedHave serviced by
Yamaha dealer29
Low battery
voltageBattery voltage low Charge 69
Battery terminal con-
nected wrongConnect properly
69
Exhaust gas
temperatureGas temperature is
too highCool down engine
31
Check engine
warningFaulty sensors Have serviced by
Yamaha dealer31 TROUBLE POSSIBLE CAUSE REMEDY PAGE
UF1G74E0.book Page 74 Monday, July 31, 2006 10:10 AM