engine YAMAHA GRIZZLY 125 2005 Owner's Manual

6-5
NOTE:
8The engine can be started only when the
drive select lever is in neutral.
8When the drive select lever is in neutral, the
neutral indicator light should come on. If the
light does not come on, ask a Yamaha dealer
to inspect it.
5. Use the starter (choke) in reference to the
figure:
Position 1: Cold engine start-
ambient temperature below 5
°C .
Position 2: Cold engine start-
ambient temperature at 0
°C – 30°C
and warming up position.
Position 3: Cold engine start-
ambient temperature above 25
°C
and warm engine start position.
1. Fully open 2. Half open
3. Closed a. Starter (choke)
1. Pleine course 2. Mi-course
3. Fermé a. Starter (choke)
1. Abierto completamente 2. Semiabierto
3. Cerrado a. Starter (choke)
q
we
w
qe
w q
e
a
AMBIENT TEMP. / STARTER (CHOKE) POSITIONPOSITION DE STARTER (CHOKE) / TEMP. AMBIANTEPOSICION DEL STARTER (CHOKE) / TEMP. AMBIENTE
1C5-9-61-06 9/4/04 8:15 PM Page 6

6-7
6. Completely close the throttle lever and start
the engine by pushing the starter switch.
NOTE:
If the engine fails to start, release the starter
switch, then push the starter switch again.
Pause a few seconds before the next attempt.
Each cranking should be as short as possible to
preserve battery energy. Do not crank the
engine more than 10 seconds on each attempt.
7. If the engine is started with the starter
(choke) in position 1, the starter (choke)
should be returned to position 2to warm up
the engine. If the engine is started with the
starter (choke) in position 2, keep the
starter (choke) in this position to warm up
the engine.
1C5-9-61-06 9/4/04 8:15 PM Page 8

6-9
8. Continue warming up the engine until it idles
smoothly and return the starter (choke) to
position 3before riding.
cC
See the “Engine break-in” section prior to
operating engine for the first time.
1C5-9-61-06 9/4/04 8:15 PM Page 10

6-11
EBU00180
Starting a warm engine
To start a warm engine, refer to the “Starting a
cold engine” section. The starter (choke) should
not be used. The throttle should be opened
slightly.
EBU00182
Warming up
To get maximum engine life, always warm up
the engine before starting off. Never accelerate
hard with a cold engine! To see whether or not
the engine is warm, check if it responds to the
throttle normally with the starter (choke) turned
off.
1C5-9-61-06 9/4/04 8:15 PM Page 12

6-17
NOTE:
If the drive select lever is shifted into reverse
while the engine is running, the engine will stop
unless the parking brake or rear brake lever is
applied.
w
Improper operation in reverse could make
you hit an obstacle or person behind you,
resulting in serious injury. When you shift
into reverse, make sure there are no obsta-
cles or people behind you. When it is safe to
proceed, go slowly.
1C5-9-61-06 9/4/04 8:15 PM Page 18

6-19
EBU02092
Engine break-in
There is never a more important period in the
life of your machine than the period between
zero and 20 hours.
For this reason, we ask that you carefully read
the following material. Because the engine is
brand new, you must not put an excessive load
on it for the first several hours of running. During
the first 20 hours, the various parts in the engine
wear and polish themselves to the correct oper-
ating clearances.
During this period, prolonged full throttle opera-
tion or any condition which might result in exces-
sive engine heating must be avoided. However,
momentary (2–3 seconds maximum) full throttle
operation under load does not harm the engine.
1C5-9-61-06 9/4/04 8:15 PM Page 20

6-21
Each full throttle acceleration sequence should
be followed with a substantial rest period for the
engine by cruising at lower r/min so the engine
can rid itself of the temporary build up of heat.
If any abnormality is noticed during this period,
consult a Yamaha dealer.
0–10 hours:
Avoid continuous operation above half throttle.
Allow a cooling off period of five to ten minutes
after every hour of operation. Vary the speed of
the machine from time to time. Do not operate it
at one set throttle position.
10–20 hours:
Avoid prolonged operation above 3/4 throttle.
Rev the machine freely through the gears but do
not use full throttle at any time.
After break-in:
Avoid prolonged full throttle operation. Vary
speeds occasionally.
1C5-9-61-06 9/4/04 8:15 PM Page 22

6-23
EBU00211
Parking
When parking, stop the engine and shift into
neutral. Turn the fuel cock to “OFF” and apply
the parking brake.
1
1. Locked position1. Verrouillé1. Posición de bloqueada
1C5-9-61-06 9/4/04 8:15 PM Page 24

6-25
EBU00216
Parking on a slope
w
Avoid parking on hills or other inclines.
Parking on a hill or other incline could cause
the ATV to roll out of control, increasing the
chance of an accident. If you must park on
an incline, place the machine transversely
across the incline, apply the parking brake,
and block the front and rear wheels with
rocks or other objects. Do not park the ATV
at all on hills that are so steep you could not
walk up them easily.
1. Bring the machine to a stop by applying the
brakes.
2. Stop the engine.
3. With the rear brake applied, apply the park-
ing brake.
1C5-9-61-06 9/4/04 8:15 PM Page 26

<16
7-7
Riding your ATV requires skills acquired
through practice over a period of time.
Take the time to learn the basic techniques well
before attempting more difficult maneuvers.
Not recommended for children under 16
years of age.
w
A child under 16 should never operate an
ATV with engine size greater than 90cc. Use
by children of ATVs that are not recommend-
ed for their age can lead to severe injury or
death of the child.
1C5-9-61-07 9/4/04 9:34 PM Page 8