brake YAMAHA RHINO 700 2012 Owner's Guide

8-21 1. Console
1. Console
1. Consola
1
5B410011
Console
To remove
1. Remove the seats. (See page 4-37 for seat
removal and installation procedures.)
2. Remove the parking brake lever boot.
3. Pull the console forward and upward (the
drive select lever boot will come loose). To
ease removal of the console, shift the drive
select lever into the low gear “L” position.
1RB60-EE.book Page 21 Thursday, April 7, 2011 10:43 AM

8-23
To install
1. Place the console in its original position.
2. Install the parking brake lever boot.
3. Install the seats.NOTICE

Be sure to position the seat belt buckles to
the outside of the console.


When installing the console, be sure not to
pinch the cables or wires.


Make sure that the groove at the bottom of
the parking brake lever boot and the drive
select lever boot fits securely around the
edge of the hole in the console.
1RB60-EE.book Page 23 Thursday, April 7, 2011 10:43 AM

8-87
Brakes
Replacement of brake components requires pro-
fessional knowledge. Brake service should be per-
formed by a Yamaha dealer.
WARNING
Operating with improperly serviced or adjust-
ed brakes could lead to a loss in braking ability
and an accident.
1RB60-EE.book Page 87 Thursday, April 7, 2011 10:43 AM

8-89 1. Brake pad wear indicator groove
1. Rainure d’indication d’usure de plaquette de frein
1. Ranura indicadora de desgaste de la pastilla de freno
1
5B410019
Checking the front and rear brake pads
Each brake pad is provided with wear indicator
grooves, which allow you to check the brake pad
wear without having to disassemble the brake. To
check the brake pad wear, check the wear indica-
tor grooves. If a brake pad has worn to the point
that the wear indicator grooves have almost disap-
peared, have a Yamaha dealer replace the brake
pads as a set.
The wheels need to be removed to check the
brake pads. (See pages 8-113–8-117 for wheel re-
moval and installation procedures.)
1RB60-EE.book Page 89 Thursday, April 7, 2011 10:43 AM

8-91 1. Brake pad wear indicator groove
1. Rainure d’indication d’usure de plaquette de frein
1. Ranura indicadora de desgaste de la pastilla de freno
1
5B410020
Checking the parking brake pads
Each brake pad is provided with two wear indicator
grooves, which allow you to check the brake pad
wear without having to disassemble the brake. To
check the brake pad wear, check the wear indica-
tor grooves. If a brake pad has worn to a wear in-
dicator groove, have a Yamaha dealer replace the
brake pads as a set.
1RB60-EE.book Page 91 Thursday, April 7, 2011 10:43 AM

8-93 1. Minimum level mark
1. Repère de niveau minimum
1. Marca de nivel mínimo
1
EVU00850
Checking the brake fluid level
The brake fluid reservoir is located under the
hood. (See pages 8-17–8-19 for hood opening
and closing procedures.)
Before riding, check that the brake fluid is above
the minimum level mark. Check the brake fluid lev-
el with the top of the reservoir level. Replenish the
brake fluid if necessary.
Specified brake fluid: DOT 4
1RB60-EE.book Page 93 Thursday, April 7, 2011 10:43 AM

8-95
WARNING
Improper maintenance can result in loss of
braking ability. Observe these precautions:

Insufficient brake fluid may allow air to en-
ter the brake system, reducing braking per-
formance.


Clean the filler cap before removing. Use
only DOT 4 brake fluid from a sealed con-
tainer.


Use only the specified brake fluid; other-
wise, the rubber seals may deteriorate,
causing leakage.


Refill with the same type of brake fluid.
Adding a brake fluid other than DOT 4 may
result in a harmful chemical reaction.


Be careful that water does not enter the
brake fluid reservoir when refilling. Water
will significantly lower the boiling point of
the fluid and may result in vapor lock.
1RB60-EE.book Page 95 Thursday, April 7, 2011 10:43 AM

8-97
NOTICEBrake fluid may damage painted surfaces or
plastic parts. Always clean up spilled fluid im-
mediately.As the brake pads wear, it is normal for the brake
fluid level to gradually go down. A low brake fluid
level may indicate worn brake pads and/or brake
system leakage; therefore, be sure to check the
brake pads for wear and the brake system for leak-
age. If the brake fluid level goes down suddenly,
have a Yamaha dealer check the cause before fur-
ther riding.
1RB60-EE.book Page 97 Thursday, April 7, 2011 10:43 AM

8-99 1. Brake pedal a. No brake pedal free play
1. Pédale de frein a. Absence de garde à la pédale de frein
1. Pedal de freno a. Ningún juego en el pedal de freno
1
a
EVU00860
Brake fluid replacement
Complete fluid replacement should be done only
by trained Yamaha service personnel. Have a
Yamaha dealer replace the following components
during periodic maintenance or when they are
damaged or leaking.

Replace the oil seals every two years.


Replace the brake hoses every four years.
EVU01220
Checking the brake pedal
Have a Yamaha dealer check the brakes at the in-
tervals specified in the periodic maintenance and
lubrication chart. There should be no free play in
the brake pedal. The brakes should operate
smoothly and there should be no brake drag. If the
brakes feel soft or spongy, this could indicate air in
the brake system. Have a Yamaha dealer check
the brake system if necessary.
1RB60-EE.book Page 99 Thursday, April 7, 2011 10:43 AM

8-101 a. Parking brake lever free play
a. Garde du levier de frein de stationnement
a. Holgura de la palanca del freno de estacionamiento
a
EVU00870
Parking brake lever free play adjustment
Periodically check the parking brake lever free
play and adjust it if necessary.
1. Shift the drive select lever into low gear “L”.
2. Remove the seats. (See page 4-37 for seat
removal and installation procedures.)
3. Remove the console. (See pages 8-21–8-23
for console removal and installation proce-
dures.)
4. Check the parking brake lever free play. The
maximum free play is equal to one click of the
parking brake lever. If necessary, adjust the
free play as follows.
5. Release the parking brake lever.
6. Slide the rubber cover back on the parking
brake cable.
1RB60-EE.book Page 101 Thursday, April 7, 2011 10:43 AM