lock YAMAHA TRACER 900 GT 2021 Owner's Guide

Periodic maintenance an d a djustment
7-33
7 3. Remove the license plate light
bulb socket (together with the
bulb) by turning it counterclock-
wise, and then pulling it out.
4. Remove the burnt-out bulb by pulling it out.
5. Insert a new bulb into the socket.
6. Install the socket (together with the bulb) by pushing it in, and then
turning it clockwise until it stops.
7. Install the license plate unit onto the rear fender.
8. Install the bolts and tighten to the specified torque.
EAU25872
Trou bleshootin gAlthough Yamaha motorcycles receive
a thorough inspection before shipment
from the factory, trouble may occur
during operation. Any problem in the
fuel, compression, or ignition systems,
for example, can cause poor starting
and loss of power.
The following troubleshooting charts
represent quick and easy procedures
for checking these vital systems your-
self. However, should your motorcycle
require any repair, take it to a Yamaha
dealer, whose skilled technicians have
the necessary tools, experience, and
know-how to service the motorcycle
properly.
Use only genuine Yamaha replace-
ment parts. Imitation parts may look
like Yamaha parts, but they are often
inferior, have a shorter service life and
can lead to expensive repair bills.
WARNING
EWA15142
When checkin g the fuel system, do
not smoke, an d make sure there are
no open flames or sparks in the ar-
ea, inclu din g pilot li ghts from water
1. Collar
2. License plate light bulb
3. License plate light unit
3
2
1 1 1
Ti
ghtenin g torque:
License plate light unit bolt:
4.0 N·m (0.4 kgf·m, 3.0 lb·ft)
UBAPE0E0.book Page 33 Thursday, December 24, 2020 9:14 AM

Periodic maintenance an d a djustment
7-36
7
EAU86420
En gine overheatin g
WARNING
EWAT1041
Do not remove the ra diator cap when the en gine an d ra diator are hot. Scal din g hot flui d an d steam may be
b lown out un der pressure, which coul d cause serious injury. Be sure to wait until the en gine has coole d.
 Place a thick rag , like a towel, over the ra diator cap, an d then slowly rotate the cap counterclockwise to the
d etent to allow any resi dual pressure to escape. When the hissin g soun d has stopped , press down on the cap
while turnin g it counterclockwise, an d then remove the cap.TIPIf coolant is not available, tap water can be temporarily used instead, provided that it is changed to the recommended cool-
ant as soon as possible.
Wait until the
engine has cooled.
Check the coolant level in the
reservoir and radiator.
The coolant level
is OK.The coolant level is low.
Check the cooling system
for leakage.
Have a Yamaha dealer checkand repair the cooling system.Add coolant. (See TIP.)
Start the engine. If the engine overheats again,
have a
Yamaha dealer check
and repair the cooling system.
There is
leakage.
There is
no leakage.
UBAPE0E0.book Page 36 Thursday, December 24, 2020 9:14 AM

11-1
11
Index
AABS warning light ................................... 4-7
Air filter element.................................... 7-14
Auxiliary DC connector ......................... 4-35
Auxiliary DC jack .................................. 4-34
Auxiliary system warning light ................ 4-9BBattery .................................................. 7-28
BC........................................................... 3-7
Brake and clutch levers, checking and
lubricating........................................... 7-25
Brake and shift pedals, checking and
lubricating........................................... 7-25
Brake control system (BC).................... 4-23
Brake fluid, changing............................ 7-21
Brake fluid level, checking.................... 7-20
Brake lever............................................ 4-22
Brake lever free play, checking ............ 7-18
Brake light switches ............................. 7-19
Brake pedal .......................................... 4-23CCables, checking and lubricating ......... 7-24
Canister ................................................ 7-10
Care ........................................................ 8-1
Catalytic converter ............................... 4-27
Centerstand and sidestand, checking
and lubricating ................................... 7-26
Clutch lever........................................... 4-21
Clutch lever free play, adjusting ........... 7-18
Coolant ................................................. 7-13
Cruise control indicator lights................. 4-6
Cruise control switches .......................... 4-4
Cruise control system............................. 3-1
DData recording, vehicle ........................ 10-2
Diagnostic connector ........................... 10-2
Dimmer/Pass switch .............................. 4-3
Display, menu screen........................... 4-17
Displays.................................................. 4-9
D-MODE................................................. 3-3
Drive chain, cleaning and lubricating ... 7-23
Drive chain slack .................................. 7-22EEngine break-in ...................................... 6-1
Engine idling speed, checking ............. 7-14
Engine oil.............................................. 7-10
Engine overheating .............................. 7-36
Engine serial number ........................... 10-1FFront and rear brake pads, checking ... 7-19
Front fork, checking ............................. 7-27
Fuel ...................................................... 4-25
Fuel consumption, tips for reducing ...... 6-4
Fuel level warning light........................... 4-6
Fuel tank cap........................................ 4-24
Fuel tank overflow hose ....................... 4-27
Fuses, replacing ................................... 7-30HHandlebar position, adjusting .............. 4-32
Handlebar switches ............................... 4-3
Hazard switch ........................................ 4-4
High beam indicator light ....................... 4-6
Horn switch ............................................ 4-4IIdentification numbers ......................... 10-1
Ignition circuit cut-off system .............. 4-36
Immobilizer system ................................ 4-1 Immobilizer system indicator light .......... 4-8
Indicator lights and warning lights .......... 4-6
LLicense plate light bulb, replacing ........ 7-32
Luggage strap holders.......................... 4-34MMain switch/steering lock ....................... 4-2
Maintenance and lubrication, periodic ... 7-5
Maintenance, emission control
system .................................................. 7-3
Malfunction indicator light (MIL) ............. 4-7
Matte color, caution................................ 8-1
Model label ........................................... 10-1NNeutral indicator light ............................. 4-6OOil pressure and Coolant temperature warning light ......................................... 4-8PParking.................................................... 6-5
Part locations.......................................... 2-1QQSS ........................................................ 3-6RRider footrest position, adjusting ......... 4-31
Rider seat height, adjusting .................. 4-29SSafety information................................... 1-1
Seats ..................................................... 4-28
Shifting.................................................... 6-3
Shift pedal............................................. 4-22
Sidestand.............................................. 4-35
Spark plugs, checking ............................ 7-9
Special features ...................................... 3-1
UBAPE0E0.book Page 1 Thursday, December 24, 2020 9:14 AM