wheel YAMAHA VERSITY 300 2004 User Guide

SCOOTER CARE AND STORAGE
7 Long-term
Before storing your scooter for several
months:
1. Follow all the instructions in the
"Care" section of this chapter.
2. Drain the carburetor float chamber
by loosening the drain bolt; this will
prevent fuel deposits from building
up. Pour the drained fuel into the
fuel tank.
3. Fill up the fuel tank and add fuel
stabilizer (if available) to prevent
the fuel tank from rusting and the
fuel from deteriorating.
4. Perform the following steps to
protect the cylinder, piston rings,
etc. from corrosion.
a. Remove the spark plug cap and
spark plug.
b. Pour a teaspoonful of engine oil
into the spark plug bore.
c. Install the spark plug cap onto
the spark plug, and then place
the spark plug on the cylinder
head so that the electrodes are
grounded. (This will limit
sparking during the next step.)d. Turn the engine over several
times with the starter. (This will
coat the cylinder wall with oil.)
e. Remove the spark plug cap from
the spark plug, and then install
the spark plug and the spark
plug cap.
EWA00003
To prevent damage or injury from
sparking, make sure to ground the
spark plug electrodes while turning
the engine over.
5. Lubricate all control cables and
the pivoting points of all levers and
pedals as well as of the sidestand/
centerstand.
6. Check and, if necessary, correct
the tire air pressure, and then lift
the scooter so that both of its
wheels are off the ground.
Alternatively, turn the wheels a
little every month in order to
prevent the tires from becoming
degraded in one spot.
WARNING
7. Cover the muffler outlet with a
plastic bag to prevent moisture
from entering it.
8. Remove the battery and fully
charge it. Store it in a cool, dry
place and charge it once a month.
Do not store the battery in an
excessively cold or warm place
(less than 0 °C or more than 30
°C). For more information on
storing the battery, see page
6-30.
NOTE :
Make any necessary repairs before
storing the scooter.
7-4

SPECIFICATIONS
8
Model VP300
Dimensions:
Overall length 2,170 mm
Overall width 765 mm
Overall height 1,465 mm
Seat height 805 mm
Wheelbase 1,480 mm
Minimum ground clearance 155 mm
Minimum turning radius 1,706 mm
Weight:
Wet (with oil and a full fuel tank) 174 kg
Engine:
Engine type Liquid cooled, 4 strokes SOHC
Cylinder arrangementSingle cylinder, Forward inclined
Displacement 264 cm
3
Bore x stroke 71.0 x 66.8
Compression ratio 10:1
Starting system type Electric starter
Lubrication system Wet sump
Specifications
Engine oil:
Type
-20°-10°10°20°30°40°50°C
0°
SAE 10W/30
SAE 10W/40
SAE 15W/40
SAE 20W/40
SAE 20W/50
Recommended engine oil API Service SE, SF, SG type
Classification or higher
CAUTION:
8-1
Be sure to use motor oils that do not contain anti-fric-
tion modifiers. Passenger car motor oils (often labeled
“Energy Conserving II”) contain anti-friction additives
which will cause clutch and/or starter cluth slippage,
resulting in reduced component life and poor engine
performance.
Quantity
Periodic oil change 1.2 L
Total amount (dry engine) 1.4 L

SPECIFICATIONS
8
Wheels:
Front
Type Cast wheel
Size 14 x MT 2.75
Rear
Type Cast wheel
Size 14 x MT 4.00
Brakes:
Front
Type Single disc brake
Operation Right hand
Type brake fluid DOT 4
Rear
Type Single disc brake
Operation Left hand
Type brake fluid DOT 4
Suspension:
Front suspension Telescopic fork
Rear suspension Unit swing
Shock absorber:
Front fork type Coil spring/oil damper
Rear shock absorber Coil spring/oil damper
assembly type
Wheel travel:
Front wheel travel 108 mm
Rear wheel travel 120 mmElectrical:
Ignition system type Transistorized coil ignition
Charging system AC magneto
Battery
Model F9-12B
Voltage/capacity 12 V / 9 Ah
Headlight type:Halogen bulb
Bulbs (voltage/wattage x quantity):
Headlight 12V, 35W/35Wx2
Auxiliary light 12V, 5Wx2
Tail/brake light 12V, 5W/21Wx2
Turn signal light
Front 12V, 21Wx2
Rear 12V, 10Wx2
High beam indicator light LED
Turn signal indicator light LED
Headlight indicator light LED
Fuses:
Main fuse: 30 A
Backup fuse: 3 A
Headlight fuse: 15 A
Radiator fan fuse: 15 A
Signaling system fuse: 15 A
Ignition fuse: 7.5 A
Auxiliary DC jack fuse: 3 A
Reserve fuse (x quantity) 30Ax1, 15Ax1, 7.5Ax1
8-3

INDEX
Storage compartments ...................... 3-12
T
Tail/brake light bulb or rear turn
signal light bulb, replacing ............ 6-34
Throtlle cable free play, adjusting ...... 6-20
Throttle grip and cable,
checking and lubricating .............. 6-26
Tires .................................................. 6-21
Tool kit ................................................. 6-1
Troubleshooting ................................. 6-35
Troubleshooting charts ...................... 6-36
Turn signal light bulb (front),
replacing ...................................... 6-34
V
Valve clearance, adjusting ................ 6-21
Vehicule identification number ............ 9-1
W
Wheel bearing, checking ................... 6-29
Wheels .............................................. 6-23 Luggage hook ................................... 3-15
M
Main switch/steering lock .................... 3-1
Model label .......................................... 9-2
Multi-function display .......................... 3-4
P
Parking ................................................ 5-5
Part locations ...................................... 2-1
Periodic maintenance and lubrication
chart ............................................... 6-2
Pre-operation check list ...................... 4-1
S
Safe-riding points ................................ 1-2
Seat ................................................... 3-12
Shock absorber assemblies,
adjusting ....................................... 3-14
Sidestand .......................................... 3-16
Spark plug, checking ......................... 6-11
Specifications ...................................... 8-1
Speedometer ...................................... 3-2
Starting off .......................................... 5-2
Starting the engine .............................. 5-1
Steering, checking ............................ 6-28
Storage ............................................... 7-3