ABS YAMAHA XMAX 300 2022 User Guide

Scooter care and stora ge
8-2
8
chemicals such as, solvents,
g
asoline, rust removers, b rake
flui d, or antifreeze, etc.
Before washin g
1. Park the vehicle out of direct sun- light and allow it to cool. This will
help avoid water spots.
2. Make sure all caps, covers, elec- trical couplers and connectors are
tightly installed.
3. Cover the muffler end with a plas- tic bag and a strong rubber band.
4. Pre-soak stubborn stains like in- sects or bird droppings with a wet
towel for a few minutes.
5. Remove road grime and oil stains with a quality degreasing agent
and a plastic-bristle brush or
sponge. NOTICE: Do not use
d eg reasin g a gent on areas re-
quirin g lu brication such as
seals, gaskets, an d wheel axles.
Follow pro duct instructions.
[ECA26290]
Washin g
1. Rinse off any degreaser and spray down the vehicle with a garden
hose. Use only enough pressure
to do the job. Avoid spraying wa-
ter directly into the muffler, instru-
ment panel, air inlet, or other inner
areas such as underseat storage
compartments.
2. Wash the vehicle with a quality au- tomotive-type detergent mixed
with cool water and a soft, clean
towel or sponge. Use an old tooth-
brush or plastic-bristle brush for
hard-to-reach places. NOTICE:
Use col d water if the vehicle has
b een exposed to salt. Warm wa-
ter will increase salt’s corrosive
properties.
[ECA26301]
3. For windshield-equipped vehicles: Clean the windshield with a soft
towel or sponge dampened with
water and a pH neutral detergent.
If necessary, use a high-quality
windshield cleaner or polish for
motorcycles. NOTICE: Never use
any stron g chemicals to clean
the wind shield. Additionally,
some cleanin g compoun ds for plastic may scratch the win
d-
shiel d, so b e sure to test all
cleanin g pro ducts before gen-
eral application.
[ECA26310]
4. Rinse off thoroughly with clean water. Be sure to remove all deter-
gent residues, as they can be
harmful to plastic parts.
After washin g
1. Dry the vehicle with a chamois or absorbent towel, preferably mi-
crofiber terrycloth.
2. For drive chain-equipped models: Dry and then lubricate the drive
chain to prevent rust.
3. Use a chrome polish to shine chrome, aluminum, and stainless
steel parts. Often the thermally in-
duced discoloring of stainless
steel exhaust systems can be re-
moved through polishing.
4. Apply a corrosion protection spray on all metal parts including
chrome or nickel-plated surfaces.
WARNING! Do not apply sili- cone or oil spray to seats, han d
g rips, ru bber foot pe gs or tire
trea ds. Otherwise these parts
UBBAE1E0.book Page 2 Monday, October 4, 2021 4:51 PM

11-1
11
Index
AABS warning light ................................... 4-2
Acceleration and deceleration ................ 6-3
Air filter and V-belt case air filter
elements ............................................. 7-15
Anti-lock brake system (ABS)............... 4-14
Auxiliary DC jack .................................. 4-25
Auxiliary lights....................................... 7-32BBattery .................................................. 7-29
Brake fluid, changing............................ 7-25
Brake fluid level, checking.................... 7-23
Brake lever, front .................................. 4-13
Brake lever, rear ................................... 4-14
Brake levers, lubricating ....................... 7-26
Brake/tail light....................................... 7-32
Braking ................................................... 6-3CCables, checking and lubricating ......... 7-25
Canister ................................................ 7-10
Care ........................................................ 8-1
Catalytic converter ............................... 4-20
Centerstand and sidestand,
checking and lubricating .................... 7-27
Coolant ................................................. 7-14DData recording, vehicle......................... 10-2
Diagnostic connector ........................... 10-2
Dimmer/Pass switch............................. 4-12EEmergency mode ................................. 7-37
Engine break-in ...................................... 6-1
Engine oil and oil filter element............. 7-10
Engine overheating ............................... 7-36 Engine serial number ........................... 10-1
FFinal transmission oil............................ 7-13
Front and rear brake lever free play,
checking ............................................ 7-22
Front and rear brake pads, checking ... 7-23
Front fork, checking ............................. 7-27
Front turn signal light ........................... 7-32
Fuel ...................................................... 4-18
Fuel consumption, tips for reducing ...... 6-4
Fuel tank cap........................................ 4-17
Fuel tank overflow hose ....................... 4-19
Fuses, replacing ................................... 7-30HHandlebar position, adjusting .............. 4-24
Handlebar switches ............................. 4-12
Hazard switch ...................................... 4-13
Headlights ............................................ 7-31
High beam indicator light ....................... 4-1
Horn switch .......................................... 4-12IIdentification numbers ......................... 10-1
Ignition circuit cut-off system .............. 4-27
Indicator lights and warning lights ......... 4-1KKey, handling of smart and mechanical keys .................................. 3-3LLicense plate light bulb, replacing ....... 7-33MMain switch ............................................ 3-8
Maintenance and lubrication, periodic... 7-4
Maintenance, emission control system ................................................. 7-3 Malfunction indicator light (MIL) ............. 4-1
Matte color, caution................................ 8-1
Model label ........................................... 10-1
Multi-function display ............................. 4-4
OOperating range of the smart key
system .................................................. 3-2PPanel, removing and installing ................ 7-8
Parking.................................................... 6-4
Part locations.......................................... 2-1SSafe-riding points ................................... 1-5
Safety information................................... 1-1
Shock absorber assemblies, adjusting ............................................. 4-25
Sidestand.............................................. 4-26
Smart key................................................ 3-5
Smart key battery, replacing................... 3-6
Smart key system ................................... 3-1
Smart key system indicator light ............ 4-2
Smart key system, troubleshooting ...... 7-34
Spark plug, checking .............................. 7-9
Specifications ......................................... 9-1
Speedometer .......................................... 4-3
Starting off .............................................. 6-3
Starting the engine ................................. 6-2
Steering, checking ................................ 7-28
Stop/Run/Start switch .......................... 4-13
Storage ................................................... 8-3
Storage compartments ......................... 4-20TTachometer............................................. 4-3
UBBAE1E0.book Page 1 Monday, October 4, 2021 4:51 PM