checking oil YAMAHA XV125S 2000 Owners Manual
[x] Cancel search | Manufacturer: YAMAHA, Model Year: 2000, Model line: XV125S, Model: YAMAHA XV125S 2000Pages: 88, PDF Size: 3.61 MB
Page 42 of 88
6-9
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
1
2
3
EAU01523Engine oil
Oil level inspection
1. Place the motorcycle on a level
place and hold it in an upright
position. Warm up the engine
for several minutes.
NOTE:
Be sure the motorcycle is posi-
tioned straight up when checking
the oil level. A slight tilt toward the
side can result in false readings.
1. Oil level window
2. Maximum level mark
3. Minimum level mark
a
Installation
1. Measure the electrode gap
with a wire thickness gauge
and, if necessary, adjust the
gap to specification.
2. Clean the gasket surface. Wipe
off any grime from the
threads.
3. Install the spark plug and tight-
en it to the specified torque.
a. Spark plug gap
NOTE:
If a torque wrench is not available
when you are installing a spark
plug, a good estimate of the cor-
rect torque is 1/4 to 1/2 turn past
finger tight. Have the spark plug
tightened to the specified torque as
soon as possible.
4. Install the spark plug caps.
Spark plug gap:
0.6 ~ 0.7 mm
Tightening torque:
Spark plug:
12.5 Nm (1.25 m0kg)
5AJ-9-E3 (XV125S)<3.1E> 4/5/0 5:01 PM Page 40
Page 43 of 88
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
6-10
2. With the engine stopped,
check the oil level through the
level window located at the
lower part of the right side
crankcase cover.
NOTE:
Wait a few minutes until the oil
level settles before checking.
3. The oil level should be
between maximum level and
minimum level marks. If the
level is low, fill engine with
sufficient oil to raise it to the
specified level.
1
Engine oil and oil filter element
replacement
1. Warm up the engine for a few
minutes.
2. Stop the engine. Place an oil
pan under the engine and
remove the oil filler cap.
1. Oil filler cap
3. Remove the drain plug and
drain the oil.
1. Engine oil drain plug
1
5AJ-9-E3 (XV125S)<3.1E> 4/5/0 5:01 PM Page 41
Page 56 of 88
6-23
1
2
3
4
5
6
7
8
98Use only the designated quali-
ty brake fluid. Otherwise, the
rubber seals may deteriorate,
causing leakage and poor
brake performance.
NOTE:
If DOT 4 is not available, DOT 3 can
be used.
8Refill with the same type of
brake fluid. Mixing fluids may
result in a harmful chemical
reaction and lead to poor
brake performance.
8Be careful that water does not
enter the master cylinder when
refilling. Water will significant-
ly lower the boiling point of
the fluid and may result in
vapor lock. Recommended brake fluid:
DOT 4
PERIODIC MAINTENANCE AND MINOR REPAIR
EAU00727
Rear brake
Apply the brake and inspect the
wear indicator.
If the indicator reaches the wear
limit line, ask a Yamaha dealer to
replace the shoes.
1. Wear limit line
2. Wear indicator
EAU00732Inspecting the brake fluid
level
Insufficient brake fluid may let air
enter the brake system, possibly
causing the brakes to become inef-
fective.
Before riding, check that the brake
fluid is above the minimum level
and fill when necessary.
Observe these precautions:
8When checking the fluid level,
make sure the top of the mas-
ter cylinder is level by turning
the handlebars.
1. Minimum level mark
1
2
1
5AJ-9-E3 (XV125S)<3.1E> 4/5/0 5:01 PM Page 54