window YAMAHA XV125S 2000 Owners Manual

6-9
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
1
2
3
EAU01523Engine oil
Oil level inspection
1. Place the motorcycle on a level
place and hold it in an upright
position. Warm up the engine
for several minutes.
NOTE:
Be sure the motorcycle is posi-
tioned straight up when checking
the oil level. A slight tilt toward the
side can result in false readings.
1. Oil level window
2. Maximum level mark
3. Minimum level mark
a
Installation
1. Measure the electrode gap
with a wire thickness gauge
and, if necessary, adjust the
gap to specification.
2. Clean the gasket surface. Wipe
off any grime from the
threads.
3. Install the spark plug and tight-
en it to the specified torque.
a. Spark plug gap
NOTE:
If a torque wrench is not available
when you are installing a spark
plug, a good estimate of the cor-
rect torque is 1/4 to 1/2 turn past
finger tight. Have the spark plug
tightened to the specified torque as
soon as possible.
4. Install the spark plug caps.
Spark plug gap:
0.6 ~ 0.7 mm
Tightening torque:
Spark plug:
12.5 Nm (1.25 m0kg)
5AJ-9-E3 (XV125S)<3.1E> 4/5/0 5:01 PM Page 40

PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
6-10
2. With the engine stopped,
check the oil level through the
level window located at the
lower part of the right side
crankcase cover.
NOTE:
Wait a few minutes until the oil
level settles before checking.
3. The oil level should be
between maximum level and
minimum level marks. If the
level is low, fill engine with
sufficient oil to raise it to the
specified level.
1
Engine oil and oil filter element
replacement
1. Warm up the engine for a few
minutes.
2. Stop the engine. Place an oil
pan under the engine and
remove the oil filler cap.
1. Oil filler cap
3. Remove the drain plug and
drain the oil.
1. Engine oil drain plug
1
5AJ-9-E3 (XV125S)<3.1E> 4/5/0 5:01 PM Page 41