screw YAMAHA YBR250 2007 Owners Manual

2-1
2
DESCRIPTION
EAU10410
Left view1. Idle adjusting screw
2. Battery
3. Main fuse
4. Fuse box
5. Storage compartment
6. Grab bar
7. Seat lock
8. Shift pedal
9. Engine oil drain bolt
cap 2.pmd24/1/2007, 14:37
1

6-6
6
PERIODIC MAINTENANCE AND MINOR REPAIR
EAU18721
Removing and installing the
cowling and panelsThe cowling and panels shown need to
be removed to perform some of the
maintenance jobs described in this
chapter. Refer to this section each time
the cowling or a panel needs to be
removed and installed.
1
1. Panel B
12
1. Cowling
2. Panel A
EAU19040
Cowling
2
1
1. Screw
2. Quick fastenerTo remo
ve the co
wling
1. Remove the seat and panel A. (See pages 3-9 and 6-6.) 2. Remove the screws, and then pull
the cowling off as shown.
To install the co
wling
1. Place the cowling in the original position, and then install the
screws.
2. Install the panel and the seat.
EAUW0110
Panels A and BTo remo
ve one of the panels
1
2
1. Screw
2. Quick fastener
cap 6.pmd 24/1/2007, 14:37
6

6-7
6
PERIODIC MAINTENANCE AND MINOR REPAIR
1. Remove the seat. (See page 3-9.)
2. Remove the screws, and then pullthe panel to the outside as shown.To install the panel1. Place the panel in the original position, and install the screws.
2. Install the seat.
EAU19630
Checking the spark plugl
The spark plug is an important
engine component, which is easy
to check. Since heat and deposits
will cause any spark plug to slowly
erode, the spark plug should be
removed and checked in
accordance with the periodic
maintenance and lubrication chart.
In addition, the condition of the
spark plug can reveal the condition
of the engine.
To remove the spark plug 1. Remove cowling. (See page 6-6.)
1. Spark plug cap2. Remove the spark plug cap.
3. Remove the spark plug as shown, with the spark plug wrench included
in the owner’s tool kit.
1. Spark plug wrenchTo check the spark plug1. Check that the porcelain insulator around the center electrode of the
spark plug is a medium-to-light tan
(the ideal color when the
motorcycle is ridden normally).If the spark plug shows a distinctly
different color, the engine could be
defective. Do not attempt to diagnose
such problems yourself. Instead, have
a Yamaha dealer check the motorcycle.2. Check the spark plug for electrodeerosion and excessive carbon or
other deposits, and replace it if
necessary.
cap 6.pmd 24/1/2007, 14:37
7

6-11
6
PERIODIC MAINTENANCE AND MINOR REPAIR
EAU20880
Cleaning the air filter elementThe air filter should be cleaned at the
specified intervals. It should be cleaned
more frequently when riding in unusually
wet or dusty areas.1. Remove panel B. (See page 6-6.)
1 2
2
1. Air filter case cover
2. Screw2. Remove the air filter case by
removing the screws.
3. Remove the air filter from the case.
1
1. Air filter element
4. Remove the air filter element from its guide and clean it with solvent.
After cleaning, remove the
remaining solvent by squeezing
the element.5. Apply recommended oil to theentire surface of the element and
squeeze out the excess oil. It
should be wet but not dripping.Recommended oil:Engine oil6. Insert the air filter element guide
into the air filter and install it in the
case.
7. Install the air filter case cover and panel by installing the screws.
ECA10480
l
l l
l
l
Make sure that the air filter
element is properly seated in the
air filter case.
l
l l
l
l
The engine should never be
operated without the air filter
element installed, otherwise the
piston(s) and/or cylinder(s) may
become excessively worn.
cap 6.pmd 24/1/2007, 14:37
11

6-27
6
PERIODIC MAINTENANCE AND MINOR REPAIR
EAU23780
Replacing the headlight bulbThis model is equipped with a quartz
bulb headlight. If the headlight bulb burns
out, replace it as follows.1. Remove the headlight unit by removing the screws.
1
1. Screw2. Disconnect the headlight coupler,and then remove the bulb cover.
2
1
1. Headlight coupler
2. Bulb cover
3. Remove the headlight bulb holder
by turning it counterclockwise, and
then remove the defective bulb.1.Headlight bulb holder
EWA10790
Headlight bulbs get very hot.
Therefore, keep flammable products
away from a lit headlight bulb, and
do not touch the bulb until it has
cooled down.4. Place a new headlight bulb intoposition, and then secure it with
the bulb holder.
ECA10660
Do not touch the glass part of the
headlight bulb to keep it free from oil,
otherwise the transparency of the
glass, the luminosity of the bulb, and
the bulb life will be adversely affected.
Thoroughly clean off any dirt and
fingerprints on the headlight bulb
using a cloth moistened with alcohol
or thinner.1. Do not touch the glass part of the bulb5. Install the headlight bulb cover, andthen connect the coupler.
6. Install the headlight unit by installing the screws
7. Have a Yamaha dealer adjust the headlight beam if necessary.
cap 6.pmd 24/1/2007, 14:38
27

6-28
6
PERIODIC MAINTENANCE AND MINOR REPAIR
EAU24281
Replacing a turn signal light
bulb or the tail/brake light
bulb1. Remove the lens by removing thescrews.
1
1.Screw
1
1. Screw2. Remove the defective bulb bypushing it in and turning it
counterclockwise. 3. Insert a new bulb into the socket,
push it in, and then turn it clockwise
until it stops.
4. Install the lens by installing the screws.
ECA10680
Do not overtighten the screws,
otherwise the lens may break.
EAU37270
Replacing the auxiliary light
bulb
1
1. Auxiliary light bulbIf the auxiliary light bulb burns out,
replace it as follows.1. Remove the headlight unit by removing the screws.
2. Remove the socket (together with the bulb) by pulling it out.
3. Remove the defective bulb by pulling it out.
4. Insert a new bulb into the socket.
5. Install the socket (together with the bulb) by pushing it in.
6. Install the headlight unit by installing the screws.
cap 6.pmd 24/1/2007, 14:38
28