low beam YAMAHA YFZ450 2005 Manuale de Empleo (in Spanish)

Brake pedal, brake lever and
clutch lever lubrication.................... 8-113
Front upper and lower arm pivot
lubrication ....................................... 8-117
Rear arm pivot lubrication ................ 8-119
Wheel removal ................................. 8-121
Wheel installation ............................. 8-123
Battery .............................................. 8-125
Battery maintenance ........................ 8-129
Fuse replacement............................. 8-131
Replacing a headlight bulb ............... 8-133
Headlight beam adjustment.............. 8-139
Tail/brake light bulb replacement ..... 8-141
Troubleshooting................................ 8-143
Troubleshooting chart....................... 8-147
CLEANING AND STORAGE ................... 9-1
A. Cleaning ........................................... 9-1
B. Storage ............................................ 9-7
SPECIFICATIONS ................................ 10-1
CONVERSION TABLE .......................... 11-1
91011U5TG61.book Page 3 Friday, April 2, 2004 11:28 AM

4-7 1. Light switch “LIGHTS”
2. Engine stop switch “ENG. STOP”
3. Start switch “START”
1. Contacteur d’éclairage “LIGHTS”
2. Coupe-circuit du moteur “ENG. STOP”
3. Contacteur du démarreur “START”
1. Interruptor de luces “LIGHTS”
2. Interruptor de parada del motor “ENG. STOP”
3. Interruptor de arranque “START”
EBU00530
Handlebar switches
EBU13741
Light switch “LIGHTS”
Set the switch to the “LO” position to turn on the
low beam and the taillight.
Set the switch to the “HI” position to turn on the
high beam and the taillight.
Set the switch to the “OFF” position to turn off all
the lights.NOTE:_ The headlights and the taillight can be turned on
only when the engine is started. _
EBU06470
Start switch “START”
The starter motor cranks the engine when this
switch is pushed.CAUTION:_ See the starting instructions on page 6-3 prior
to starting the engine. _
U5TG61.book Page 7 Friday, April 2, 2004 11:28 AM

8-8 * Since these items require special tools, data and technical skills, have a Yamaha dealer perform the service.
Engine oil filter element
Replace.Drive chain
Check and adjust slack/alignment/clean/lube.Front brake*Check free play/operation/fluid leakage/
See NOTE Page 8-9.
Correct if necessary.Rear brake*Check operation/fluid leakage/See NOTE Page 8-9.
Correct if necessary.Clutch*Check operation.
Adjust if necessary.Wheels*Check balance/damage/runout.
Replace if necessary.Wheel bearings*Check bearing assemblies for looseness/damage.
Replace if damaged.Steering system*Check operation.
Repair if damaged.
Check toe-in.
Adjust if necessary.Front and rear
suspension*Check operation.
Correct if necessary.Upper and lower arm
pivot and steering shaft*Lubricate every 6 months with lithium-soap-based grease.Rear arm pivot*
Lubricate every 6 months with lithium-soap-based grease.Fittings and fasteners*Check all chassis fittings and fasteners.
Correct if necessary.Lights and switches*Check operation.
Adjust headlight beams.
ITEM ROUTINEWhichever
comes firstINITIAL EVERY
month136612
km
(mi)320
(200)1,200
(750)2,400
(1,500)2,400
(1,500)4,800
(3,000)
hours 20 75 150 150 300
U5TG61.book Page 8 Friday, April 2, 2004 11:28 AM

8-139 1. Headlight beam adjusting bolt
1. Vis de réglage du faisceau de phare
1. Tornillo de ajuste de la luz faro
EBU14050
Headlight beam adjustmentCAUTION:_ It is advisable to have a Yamaha dealer make
this adjustment. _To raise the beam, turn the adjusting bolt in direc-
tion
a.
To lower the beam, turn the adjusting bolt in direc-
tion
b.
U5TG61.book Page 139 Friday, April 2, 2004 11:28 AM