light YAMAHA YXZ1000R 2016 Owner's Guide

8-42
8
EBU35140Cleaning the spark arrester
WARNING
EWB03370Hot exhaust system may cause burns. To
avoid burns or fires, make sure that the en-
gine is stopped and the exhaust system is
cool before cleaning the spark arrester. Do
not start the engine while cleaning the ex-
haust system. 1. Remove the tailpipe cover by removingthe bolts. 2. Remove the tailpipe bolts.
3. Remove the tailpipe by pulling it out of
the muffler, and then remove the gasket.
4. Tap the tailpipe lightly, and then use a wire brush to remove any carbon depos-
its from the spark arrester portion of the
tailpipe and inside of the tailpipe housing.1. Tailpipe cover
2. Bolt
1
2
2
1. Tailpipe bolt
1
1
U2HC7LE0.book Page 42 Wednesday, October 7, 2015 12:09 PM

8-50
8
EBU32550Brake light switch adjustmentThe brake light switch, which is activated by
the brake pedal, is properly adjusted when
the brake light comes on just before braking
takes effect. If necessary, adjust the brake
light switch as follows.
Turn the adjusting nut while holding the brake
light switch in place. To make the brake light
come on earlier, turn the adjusting nut in di-
rection (a). To make the brake light come on
later, turn the adjusting nut in direction (b).
EBU35930Cable inspection and lubrication
WARNING
EWB03380Damaged cables could restrict operation,
which may cause an accident or injury. In-
spect control cables frequently and re-
place damaged cables. Corrosion can
result when the outer covering of control
cables becomes damaged. Cables can
also become frayed or kinked. Lubricate the cable ends. If the cables do not
operate smoothly, ask a Yamaha dealer to re-
place them.
1. Brake light switch
2. Adjusting nut
1
2
(b) (a)
Recommended lubricant:
Yamalube LubezAll (synthetic lubricant
spray with PTFE)
U2HC7LE0.book Page 50 Wednesday, October 7, 2015 12:09 PM

8-61
8
If a fuse is blown, replace it as follows.1. Turn the key to “ ” (off) and turn off the
electrical circuit in question.
NOTICEECB00641To prevent accidental short-circuiting,
turn off the main switch when checking or
replacing a fuse. 2. Remove panel A. (See page 8-10.)
3. Remove the blown fuse, and then install anew fuse of the specified amperage.
WARNING! Always use a fuse of the specified amperage. Never use any
material in place of the proper fuse.
Using an improper fuse can cause
damage to the electrical system and
may lead to a fire.
[EWB03440]
1. Headlight fuse “HEAD”
2. Signaling system fuse “SIGNAL”
3. Four-wheel-drive motor fuse “DIFF”
4. Backup fuse “BACK UP” (for clock)
5. Ignition fuse “IGNITION”
6. Radiator fan motor fuse “FAN”
7. Spare fuse
8. Auxiliary DC jack fuse “TERMINAL”
1 234
5
6
7
8
U2HC7LE0.book Page 61 Wednesday, October 7, 2015 12:09 PM

8-62
8
4. Turn the key to “ ” (on) and turn on theelectrical circuit in question to check if
the device operates. If the fuse blows
again immediately, have a Yamaha dealer
check the electrical system.
5. Install the panel.EBU35261HeadlightsThis model is equipped with LED headlights.
There are no user replaceable bulbs. If one or
more headlights do not come on, check for a
loose connection, check the headlight fuse,
and then have a Yamaha dealer check the ve-
hicle.TIP When the headlights are set to low beam,
only the top half of each lamp will illuminate.
 When the headlights are set to high beam,
both halves of each lamp will illuminate.
Specified fuses:
Main fuse:40.0 A
Fuel injection system fuse: 15.0 A
Headlight fuse: 15.0 A
Ignition fuse: 15.0 A
Auxiliary DC jack fuse: 10.0 A
Signaling system fuse: 10.0 A
Four-wheel-drive motor fuse: 10.0 A
Radiator fan motor fuse: 30.0 A
Backup fuse: 10.0 A
EPS fuse: 40.0 A
U2HC7LE0.book Page 62 Wednesday, October 7, 2015 12:09 PM

8-63
8
EBU32681Headlight beam adjustmentNOTICEECB00691It is advisable to have a Yamaha dealer
make this adjustment. To raise the beam, turn the headlight beam
adjusting screw in direction (a).
To lower the beam, turn the headlight beam
adjusting screw in direction (b).
EBU35271Tail/brake lightThis model is equipped with an LED tail/brake
light, there are no replaceable bulbs.
If the tail/brake light does not come on, check
the fuses, and then have a Yamaha dealer
check the vehicle.EBU32700TroubleshootingAlthough Yamaha vehicles receive an inspec-
tion before shipment from the factory, trouble
may occur during operation. Any problem in
1. Headlight beam adjusting screw
(a)
(b)
1
1. Headlight beam adjusting screw
(b)
(a)
1
U2HC7LE0.book Page 63 Wednesday, October 7, 2015 12:09 PM

8-64
8
the fuel, compression, or ignition systems can
cause poor starting and loss of power. The
troubleshooting chart describes a quick, easy
procedure for making checks. If your vehicle
requires any repair, take it to a Yamaha deal-
er.
The skilled technicians at a Yamaha dealer-
ship have the tools, experience, and know-
how to properly service your vehicle. Use only
genuine Yamaha parts on your vehicle. Imita-
tion parts may look like Yamaha parts, but
they are often inferior. Consequently, they
have a shorter service life and can lead to ex-
pensive repair bills.
WARNING
EWB03450When checking the fuel system, do not
smoke and make sure there are no open
flames or sparks in the area, including pilot
lights from water heaters or furnaces.Gasoline or gasoline
vapors can ignite or
explode, causing severe injury or property
damage.

U2HC7LE0.book Page 64 Wednesday, October 7, 2015 12:09 PM

9-3
9
6. If storing in a humid or salt-air atmo-sphere, coat all exposed metal surfaces
with a light film of oil. Do not apply oil to
any rubber parts or the seat covers.
7. Remove the battery and charge it. Store
it in a dry place and recharge it once a
month. Do not store the battery in an ex-
cessively warm or cold place [less than 0
°C (30 °F) or more than 30 °C (90 °F)].
Use of fuel stabilizer eliminates the need to
drain the fuel system. Consult a Yamaha
dealer if the fuel system needs to be drained.
U2HC7LE0.book Page 3 Wednesday, October 7, 2015 12:09 PM

10-5
10
Wheel travel:432 mm (17.0 in)Electrical system:Ignition system:
TCI
Charging system: AC magnetoBattery:Model:
U1-H11L
Voltage, capacity: 12 V, 28.0 AhBulb voltage, wattage × quantity:Headlight:
LED
Tail/brake light: LED
Neutral indicator light: LED
Reverse indicator light:
LED
Coolant temperature warning light: LED
Engine trouble warning light: LED
Parking brake indicator light:
LED
Differential gear lock indicator light: LED
EPS warning light: LED Helmet/Seat belt indicator light:
14 V, 0.85 W × 2
Shift timing indicator light: LED
Fuses:Main fuse:40.0 A
Fuel injection system fuse: 15.0 A
EPS fuse:
40.0 A
Headlight fuse: 15.0 A
Signaling system fuse: 10.0 A
Ignition fuse:
15.0 A
Auxiliary DC jack fuse: 10.0 A
Backup fuse: 10.0 A
Four-wheel-drive motor fuse:
10.0 A
Radiator fan motor fuse: 30.0 A
U2HC7LE0.book Page 5 Wednesday, October 7, 2015 12:09 PM

12-1
12
INDEX
AAccelerator pedal ......................................................... 4-16
Accelerator pedal, checking ........................................ 8-48
Accelerator pedal, Pre-operation check ........................ 5-7
Air filter ......................................................................... 8-37
Air filter case hoses, cleaning ...................................... 8-41
Auxiliary DC jack .......................................................... 4-38
Axle boots .................................................................... 8-34BBasic guide for safe use ................................................. 7-1
Battery, Periodic maintenance ..................................... 8-55
Brake and clutch fluid levels, checking ........................ 8-45
Brake fluid, replacing ...................................................8-47
Brake light switch, adjusting ........................................ 8-50
Brake pedal .................................................................. 4-17
Brake pedal, checking ................................................. 8-47
Brakes, Periodic maintenance ..................................... 8-43
Brakes, Pre-operation check ......................................... 5-3CCable, inspecting and lubrication ................................ 8-50
Cargo bed .................................................................... 4-27
Cleaning ......................................................................... 9-1
Clutch pedal ................................................................. 4-17
Clutch pedal, checking ................................................ 8-47
Clutch, Pre-operation check .......................................... 5-3
Control cables, Pre-operation check ............................. 5-8
Coolant, Periodic maintenance .................................... 8-33
Coolant, Pre-operation check ........................................ 5-6
Coolant temperature warning light ................................. 4-4Cup holders ................................................................. 4-26
DDifferential gear lock indicator light ............................... 4-3
Differential gear oil, Periodic maintenance .................. 8-30
Differential gear, Pre-operation check ........................... 5-7
Doors ........................................................................... 4-20
Drive mode, selecting .................................................... 6-7
Driver seat position ...................................................... 4-22
Drive shaft universal joint, lubrication .......................... 8-53
Drivetrain icon ................................................................ 4-3EEngine break-in .............................................................. 6-1
Engine oil and oil filter, Periodic maintenance ............. 8-15
Engine oil, Pre-operation check ..................................... 5-5
Engine trouble warning light .......................................... 4-5
EPS warning light ........................................................... 4-5FFinal gear oil, Periodic maintenance ............................ 8-28
Final gear, Pre-operation check ..................................... 5-6
Fittings and fasteners, Pre-operation check .................. 5-8
Flag pole bracket ......................................................... 4-28
Front and rear brake pads, checking ........................... 8-44
Fuel, Pre-operation check .............................................. 5-4
Fuel tank cap ............................................................... 4-19
Fuse, replacing ............................................................. 8-60GGlove compartment ..................................................... 4-23HHeadlight beam, adjusting ........................................... 8-63
Headlights .................................................................... 8-62
Helmet indicator light ..................................................... 4-6
U2HC7LE0.book Page 1 Wednesday, October 7, 2015 12:09 PM

12-2
12
Hood ............................................................................ 8-10IIdentification number records ...................................... 11-1
Indicator lights and warning lights ................................. 4-2
Instruments, lights and switches, Pre-operation check ........................................................................... 5-8JJump-starting .............................................................. 8-59LLabel locations ............................................................... 1-1
Light switch .................................................................. 4-15
Loading .......................................................................... 6-9MMain switch .................................................................... 4-1
Maintenance and lubrication chart ................................ 8-6
Maintenance chart, emission control system ................ 8-4
Model label .................................................................. 11-1
Multi-function meter unit ............................................... 4-6NNeutral indicator light ..................................................... 4-2OOn-Command drive knob ............................................ 4-15
Owner’s manual and tool kit .......................................... 8-2PPanels .......................................................................... 8-10
Parking ........................................................................... 6-9
Parking brake indicator light .......................................... 4-3
Parking brake lever ...................................................... 4-18
Parking brake lever free play, adjusting ....................... 8-49
Parking brake pads, checking ..................................... 8-44
Passenger handhold, Pre-operation check ................... 5-7 Pedal, lubrication ......................................................... 8-51
RRear knuckle upper and lower pivot, lubrication ......... 8-53
Reverse gear lock lever ............................................... 4-16
Reverse indicator light ................................................... 4-2SSafety information .......................................................... 2-1
Seat belt indicator light .................................................. 4-6
Seat belts ..................................................................... 4-23
Seat belts, Pre-operation check .................................... 5-7
Seats ............................................................................ 4-20
Shift lever ..................................................................... 4-19
Shift lever operation and reverse driving ....................... 6-3
Shift lever, Pre-operation check .................................... 5-8
Shift timing indicator light .............................................. 4-3
Shock absorber assemblies, adjusting the front ......... 4-28
Shock absorber assemblies, adjusting the rear .......... 4-33
Spark arrester, cleaning ............................................... 8-42
Spark plugs, checking ................................................. 8-35
Specifications .............................................................. 10-1
Stabilizer bushes, checking ..........
............................... 8-51
Starting the engine ........................................................ 6-2
Steering, Pre-operation check ....................................... 5-7
Steering shaft, lubrication ............................................ 8-53
Steering wheel position ............................................... 4-22
Storage .......................................................................... 9-2
Storage compartments ................................................ 4-24TTail/brake light ............................................................. 8-63
Tire, replacing .............................................................. 8-54
Tires, Pre-operation check ............................................ 5-8
Transmission oil ........................................................... 8-25
U2HC7LE0.book Page 2 Wednesday, October 7, 2015 12:09 PM