Acura Integra 2000 Sedan Repair Manual

Gauge
s

Fue l Gaug e
This shows how much fuel you have.
It is most accurate when the car is on
level ground. It may show slightly
more or less than the actual amount
when you are driving on curvy or
hilly roads. The gauge stays at the same fuel
level reading after you turn off the
ignition. When you add fuel, the
gauge slowly changes to the new reading after you turn the ignitionswitch back ON (II). Temperatur
e Gaug e
This shows the temperature of the
engine's coolant. During normal
operation, the pointer should rise from the bottom white mark to about
the middle white mark. In severe
driving conditions, such as very hot weather or a long period of uphill
driving, the pointer may rise to the
upper white mark. If it reaches the red (Hot) mark, pull safely to the
side of the road. Turn to page 229 for
instructions and precautions on
checking the engine's cooling

system.

Instrument s an d Control s
TRI
P METE R
ODOMETE R
TRI
P METE R
RESE T BUTTO N FUE
L GAUG E
SPEEDOMETE R
TACHOMETE
R
TEMPERATUR
E
GAUG E

Gauge
s

Maintenanc e Require d Indicato r
This indicator reminds you that it is
time to take your vehicle in for sched-
uled maintenance.
Refer to the Maintenance Schedules
for Normal and Severe Driving Conditions on pages 158 — 162.
For the first 6,000 miles (9,600 km) after the Maintenance Required
Indicator is reset, it will come on for
two seconds when you turn the ignition switch ON (II).

Between 6,000 miles (9,600 km) and

7,500 miles (12,000 km) this

indicator will light for two seconds
when you first turn the ignition switch ON (II), and then flash for
ten seconds.

If you exceed 7,500 miles (12,000

km) without having the scheduled
maintenance performed, this
indicator will remain on as a constant
reminder.
Your dealer will reset this indicatorafter completing the scheduled
maintenance. If this maintenance is
done by someone other than your
Acura dealer, reset the indicator by
pressing the reset button. This
button is located on the bottom of the dashboard to the right of the
steering column.

Instrument s an d Control s

MAIN
T

REQ D

Control
s Nea r th e Steerin g Whee l
The two levers on the steering
column contain controls for driving
features you use most often. The left
lever controls the turn signals,
headlights, and high beams. The right lever controls the windshield
washers and wipers.
The controls on the dashboard to the right of the steering column are for
the instrument panel brightness,
hazard warning lights and rear
window defogger.
The moonroof switch and cruise
control switch are to the left of thesteering column.
The tilt adjustment lever on the
underside of the steering column allows you to tilt the steering wheel.
Instrument s an d Control s
WINDSHIEL
D

WIPERS/WASHER S

HOR
N
BUTTON S

TIL T ADJUSTMEN T

HEADLIGHTS /
TUR N SIGNAL S

MOONROO
F
HAZAR
D WARNIN G

REA
R WINDO W

DEFOGGE R

INSTRUMEN
T PANE L

BRIGHTNES S

CRUIS
E
CONTRO L

Control
s Nea r th e Steerin g Whee l

Headlight s
The rotating switch on the left lever
controls the lights. Turning this switch to the position turns
on the parking lights, taillights,
instrument panel lights, side-marker
lights, and rear license plate lights. Turning the switch to the
position turns on the headlights. If you leave the lights on with the
ignition switch in ACCESSORY (I)
or LOCK (0), you will hear a
reminder chime when you open the driver's door.
To change between low beams and high beams, pull the turn signal lever
until you hear a click, then let go.
The blue high beam indicator will
light (see page 56). To flash the high beams, pull the
turn signal lever back lightly, then
release it. The high beams will come
on and go off.
The high beams will stay on for as long as you hold the lever back, no
matter what position the headlight
switch is in.

CONTINUED

Instrument s an d Control s

Control
s Nea r th e Steerin g Whee l
Instrument Panel Brightness
The knob on the dashboard to the
right of the steering column controls
the brightness of the instrument
panel lights. Turn the knob to adjust
the brightness. Tur
n Signal s
Signal a turn or lane change with this
lever. Push down on the lever to
signal a left turn, and up to signal a right turn. If you push it up or down
all the way, the turn signal continues
to blink even when you release the lever. It shuts off automatically as
you complete the turn. To signal a lane change, push lightly
on the turn signal lever in the proper
direction and hold it. The lever will
return to the center position as soon as you release it.

Instrument s an d Control s
TUR
N SIGNA L LEVE R

Control
s Nea r th e Steerin g Whee l

Windshiel d Wiper s
The right lever controls the wind-

shield wipers and washers. The

rotary switch at the end of the lever

has three positions:
INT: intermittent : low speed
: high speed

In intermittent, the wipers operate

every few seconds. In low speed and

high speed, the wipers run continu-
ously.
To operate the wipers in mist mode,
push the control lever down. The
wipers run at high speed until you
release the lever. This gives you a quick way to clear the windshield. Windshiel
d Washer s
To clean the windshield, pull back on
the wiper control lever. The washers
spray until you release the lever. Instrument s an d Control s

Control
s Nea r th e Steerin g Whee l
Hazar d Warnin g
Push the red button under the center
air vent to turn on the hazard warn-
ing lights (four-way flashers). This
causes all four outside turn signals
and both indicators in the instrument
panel to flash. Use the hazard
warning lights if you need to park in a dangerous area near heavy traffic,
or if your car is disabled. Rea
r Windo w Defogge r
The rear window defogger will clear fog, frost, and thin ice from the
window. Push the defogger button to
turn it on and off. The light in the button lights to show the defogger ison. If you do not turn it off, the
defogger will shut itself off after
about 25 minutes. It also shuts off
when you turn off the ignition. You have to turn it on again when you
restart the car. Make sure the rear window is clear
and you have good visibility before
starting to drive.
The defogger wires on the inside of the rear window can be accidentallydamaged. When cleaning the glass,
always wipe side to side.

Instrument s an d Control s

Control
s Nea r th e Steerin g Whee l

Steerin g Whee l Adjustmen t

See page 18 for important safety
information about how to properly

position the steering wheel.
Make any steering wheel adjustment
before you start driving.
To adjust the steering wheel upwardor downward:
1. Push the lever under the steering column all the way down.
2. Move the steering wheel to the desired position, making sure the
wheel points toward your chest,
not toward your face. Make sure
you can see the instrument panel
gauges and the indicator lights. 3. Push the lever up to lock the
steering wheel in that position.
4. Make sure you have securely locked the steering wheel in place
by trying to move it up and down.
Instrument s an d Control s

Adjusting the steering wheel

position while driving may
cause you to lose control of the
car and be seriously injured in a

crash.

Adjust the steering wheel only

when the car is stopped.

Steerin
g Whee l Control s

Cruis e Contro l
Cruise control allows you to maintain
a set speed above 25 mph (40 km/h)
without keeping your foot on the accelerator pedal. It should be used
for cruising on straight, open
highways. It is not recommended for conditions such as city driving,
winding roads, slippery roads, heavy rain, or bad weather. You should
have full control of the car under
those conditions.
The cruise control, as it operates,

moves the accelerator pedal. You can

damage your car's accelerator mechanism by resting your foot under

the pedal and blocking the movement.
Using the Cruise Control
1. Push in the Cruise Control Master Switch to the left of the steering
column. The indicator in the
switch will light.
2. Accelerate to the desired cruising speed above 25 mph (40 km/h).
Instrument s an d Control s

Improper use of the cruise

control can lead to a crash.

Use the cruise control only

when traveling on open
highways in good weather.
NOTIC
E

Steerin
g Whee l Control s

3. Press and release the SET/decel
button on the steering wheel. The
CRUISE CONTROL light on the
instrument panel comes on to
show the system is now activated.

The cruise control may not hold

the set speed when you are going
up and down hills. If your speed

increases going down a hill, use

the brakes to slow down to the

desired speed. This will cancel the
cruise control. To resume the set

speed, press and hold the

RESUME/accel button until the
CRUISE CONTROL light on the

instrument panel comes on. When

climbing a steep hill, the automatic
transmission may downshift to
hold the set speed.

Changing the Set Speed

You can increase the set cruising
speed in any of these ways: Press and hold the RESUME/
accel button. The car will acceler-
ate. When you reach the desired
cruising speed, release the button. Push on the accelerator pedal. Ac-
celerate to the desired cruising
speed and press the SET/decel

button.
You can decrease the set cruising
speed in any of these ways: Press and hold the SET/decel
button. The car will decelerate. Release the button when you
reach the desired speed.
Tap the brake or clutch pedal
lightly with your foot. The CRUISE CONTROL light on the
instrument panel will go out.
When the car slows to the desired
speed, press the SET/decel button.
The car will then maintain the
desired speed.

CONTINUED

Instrument s an d Control s

RESUME
/

acce l

SET/dece l