cooling Acura Integra 2001 User Guide

Coolin
g Syste m
1. Make sure the engine and radiator are cool.
2. Turn the radiator cap counter- clockwise, without pressing down
on it, until it stops. This relieves
any pressure remaining in the

cooling system.

3. Remove the radiator cap by pushing down and turning
counterclockwise.

4. The coolant level should be up tothe base of the filler neck. Addcoolant if it is low.
5. Put the radiator cap back on. Tighten it fully. 6. Pour coolant into the reserve tank.
Fill it to halfway between the MAX
and MIN marks. Put the cap backon the reserve tank.

CONTINUED

Maintenanc e

RESERV
E TAN K

RADIATO
R CA P

Coolin
g Syste m
Do not add any rust inhibitors or
other additives to your car's cooling system. They may not be compatible
with the coolant or engine compo-
nents.

Replacin g Engin e Coolan t
The cooling system should be completely drained and refilled with
new coolant according to the timeand distance recommendations in
the maintenance schedule. Only use Honda All Season Antifreeze/Coolant Type 2.
Draining the coolant requires access
to the underside of the car. Unless
you have the tools and knowledge,
you should have this maintenance done by a skilled mechanic. 1. Turn the ignition ON (II). Slide
the heater temperature control
lever to maximum heat. Turn theignition off.
2. Open the hood. Make sure the engine and radiator are cool to the
touch.
3. Remove the radiator cap. 4. Loosen the drain plug on the
bottom of the radiator. The
coolant will drain through thesplash guard. Remove the drain
bolt and washer from the engine
block.

Maintenanc e
DRAI
N PLU G

DRAI
N

BOL T

Coolin
g Syste m

5. Remove the reserve tank from its holder by pulling it straight up.Drain the coolant, then put the
tank back in its holder. 6. When the coolant stops draining,
tighten the drain plug at the
bottom of the radiator. Put a new
washer on the drain bolt, thenreinstall the drain bolt in the engine block. Tighten it securely.
Tightening torque:
58 Ibf.ft (78 N.m , 8.0 kgf.m)

7. Pou
r Honda All Season
Antifreeze/Coolant Type 2 into the radiator up to the base of the
filler neck. This coolant is amixture of 50 percent antifreeze
and 50 percent water. Pre-mixing
is not required. The cooling system capacity is:
With 5-speed manual transmission:

(SE,
LS,
GS)

1.16 US gal (4.4 , 0.97 Imp gal)

(GS-R, Type-R
)

1.24 US gal (4.7 , 1.03 Imp gal)
With automatic transmission:
1.24 US gal (4.7 , 1.03 Imp gal)
Maintenanc
e

CONTINUED

Fil
l u p
t
o her e

RESERV
E

TAN K CA P

HOLDE R

RESERV
E TAN K
FILLE
R NEC K

Coolin
g System , Windshiel d Washer s

8. Start the engine and let it run for about 30 seconds. Then turn off
the engine.
9. Fill the radiator with coolant up to the base of the filler neck.
10. Fill the reserve tank to the MAX mark. Install the reserve tank cap.
11. Install the radiator cap, and tighten it to the first stop.
12. Start the engine and let it run until the radiator cooling fan comes on
at least twice. Then stop the

engine.

13. Remove the radiator cap. Fill the radiator with coolant up to thebase of the filler neck. 14. Start the engine and hold it at
1,500 rpm until the radiator fan
comes on. Turn off the engine.
Check the coolant level in the
radiator and add coolant if needed.
15. Install the radiator cap, and tighten it fully.
16. If necessary, fill the reserve tank to the MAX mark. Install the
reserve tank cap. Windshiel
d Washer s
Check the level in the windshield
washer reservoir at least monthly during normal usage. In bad weather,
when you use the washers often, check the level every time you stop
for fuel. This reservoir supplies the
windshield and rear window washers.
Maintenanc e

Ai
r Conditionin g Syste m

Optional for Canadian Type-R model

Your car's air conditioning is a sealed system. Any major maintenance,
such as recharging, should be done
by a qualified mechanic. You can do a couple of things to make sure the
air conditioning works efficiently. Periodically check the engine's
radiator and air conditioning condenser for leaves, insects, and
dirt stuck to the front surface. These
block the air flow and reduce cooling efficiency. Use a light spray from a
hose or a soft brush to remove them.

The condenser and radiator fins bend
easily. Only use a low-pressure spray
or soft-bristle brush to clean them.

Run the air conditioning at least once a week during the cold weather
months. Run it for at least ten
minutes while you are driving at asteady speed with the engine at
normal operating temperature. This circulates the lubricating oil con-
tained in the refrigerant. If the air conditioning does not get as
cold as before, have your dealer
check the system. Recharge the
system with Refrigerant HFC-134a
(R-134a). (See Specifications on page 254.)

Whenever you have the air conditioning

system serviced, make sure the service

facility uses a refrigerant recycling
system. This system captures the
refrigerant for reuse. Releasing
refrigerant into the atmosphere can

damage the environment.

Maintenanc e
NOTIC
E
NOTIC E

AI
R CONDITIONIN G
CONDENSE R

I
f You r Engin e Overheat s
The pointer of your car's tempera- ture gauge should stay in the mid-range under most conditions. It may
go higher if you are driving up a longsteep hill on a very hot day. If it
climbs to the red mark, you should determine the reason.

Driving with the temperature gauge
pointer at the red mark can cause serious damage to your engine.
Your car can overheat for several
reasons, such as lack of coolant or a
mechanical problem. The only
indication may be the temperature
gauge climbing to or above the red
mark. Or you may see steam or spray coming from under the hood.
In either case, you should take
immediate action.
1. Safely pull to the side of the road. Put the transmission in Neutral or
Park and set the parking brake.
Turn off the heating and cooling system and all other accessories.
Turn on the hazard warning indicators. 2. If you see steam and/or spray
coming from under the hood, turnoff the engine.
3. If you do not see steam or spray, leave the engine running and
watch the temperature gauge. If the high heat is due to overloading (climbing a long, steep hill on a
hot day with the A/C running, for example), the engine should start
to cool down almost immediately. If it does, wait until the tempera-
ture gauge comes down to the mid-
point then continue driving.
4. If the temperature gauge stays at the red mark, turn off the engine.
5. Wait until you see no more signs of steam or spray, then open the
hood.
Takin g Car e o f th e Unexpecte d
Steam and spray from an

overheated engine can

seriously scald you.

Do not open the hood if steam

is coming out.

NOTIC
E

I
f You r Engin e Overheat s
6. Look for any obvious coolant leaks, such as a split radiator hose.
Everything is still extremely hot, so use caution. If you find a leak, it
must be repaired before you
continue driving (see Emergenc y
Towin g on page 248).
7. If you don't find an obvious leak, check the coolant level in the
radiator reserve tank (see page128). If the level is below the
MIN mark, add coolant to halfway
between the MIN and MAX marks.
8. If there was no coolant in the reserve tank, you may also have toadd coolant to the radiator. Let the
engine cool down until the pointer
reaches the middle of the tempera-
ture gauge, or lower, before check-
ing the radiator.
9. Using gloves or a large heavy
cloth, turn the radiator capcounterclockwise, without pushingdown, to the first stop. This
releases any remaining pressure in
the cooling system. After the
pressure releases, push down on
the cap and turn it until it comes off.
10. Start the engine and set the
temperature control lever tomaximum. Add coolant to the
radiator up to the base of the filler
neck. If you do not have the
proper coolant mixture available,
you can add plain water.
Remember to have the cooling
system drained and refilled with
the proper mixture as soon as you

can.

11. Put the radiator cap back on tightly. Run the engine and watch
the temperature gauge. If it goes
back to the red mark, the engine
needs repair. (See Emergenc y
Towin g on page 248.)
12. If the temperature stays normal, check the coolant level in theradiator reserve tank. If it has
gone down, add coolant to the
MAX mark. Put the cap back on

tightly.

Takin g Car e o f th e Unexpecte d

Removing the radiator cap

while the engine is hot can
cause the coolant to spray out,
seriously scalding you.

Always let the engine and radiator cool down before

removing the radiator cap.

Inde
x

Fuel.................................................. 123
Fill Door and Cap....................... 124

Gauge............................................ 59
Octane Requirement................. 123

Oxygenated................................ 258

Reserve Indicator......................... 54

Tank, Filling the......................... 124

Fuses, Checking the...................... 243

Gas Mileage, Improving................ 129
Gasohol........................................... 258

Gasoline.......................................... 123
Fuel Reserve Indicator................ 54
Gauge............................................ 59
Octane Requirement................. 123

Tank, Filling the......................... 124

Gas Station Procedures................. 124
Gauges
Engine Coolant Temperature.... 59

Fuel................................................ 59
Speedometer................................ 58

Tachometer.................................. 58

Gearshift Lever Positions
Automatic Transmission........... 140
5-speed Manual

Transmission.......................... 138

Glass Cleaning............................... 222

Glove Box......................................... 78

Halogen Headlight Bulbs.............. 209

Hatch................................................. 76
Opening the.................................. 76

Open Monitor Light.................... 56

Hazard Warning Flashers............... 65

Headlights
Aiming......................................... 207

Daytime Running Lights............. 62High Beam Indicator................... 57
Reminder Chime.......................... 62
Replacing Halogen Bulbs......... 209

Turning on....................................
62

Head Restraints..............................
. 82

Heating and Cooling........................ 94
High Altitude, Starting at.............. 137
High-Low Beam Switch.................. 62
High-mount Brake Light............... 211

Hood Latch..................................... 189

Hood, Opening the........................ 125
Horn................................................... 61

Hydraulic Clutch............................ 186
Hydroplaning.................................. 150

Identification Number, Vehicle.... 252

Ignition Keys............................................... 71

Switch............................................ 73

Timing Control System............. 261
Immobilizer System......................... 72
Important Safety Precautions.......... 6
Indicators, Instrument
Panel.............................................. 53

Infant Restraint................................ 21

Infant Seats....................................... 30
Tether Anchorage Points........... 41
Inflation, Proper Tire.................... 198
Inside Mirror.................................... 86
Inspection, Tire.............................. 199 Instrument Panel......................... 2, 52
Instrument Panel Brightness......... 63
Interior Cleaning............................ 220
Interior Lights.................................. 92
Introduction......................................... i