Acura MDX 2004 Owner's Manual

µµ
´
CONT INUED
To select the CD changer, press the
CD button. The disc and track
numbers will be displayed. To select
a dif f erent disc, use the appropriate
preset buttons (1 6). On the model
with Rear Entertainment System,
use the preset 5 (DISC ) button to
select previous disc, or the preset 6
(DISC ) button to select the next
disc in sequence.
If you select an empty slot in the
magazine, the changer will, af ter
f inding that slot empty, try to load
the CD in the next slot. This
continues until it f inds a CD to load
and play. When you see LOAd in the display,
insert the disc into the CD slot.
Insert it only abut half way, the
drive will pull it in the rest of the
way. You will again see the dashes
in the display as the CD is loaded.
When LOAd appears again in the
display, insert the next disc into
the CD slot. Do not try to insert a
disc until LOAd appears. You
could damage the audio unit.
Repeat this until all six positions
are loaded. The system will then
begin playing the last CD loaded.
If you are not loading CDs into all six
positions, press the Load button
again after the last CD has loaded.
The system will begin playing the
last CD loaded.
On the lef t side of the display, the
CD Loaded indicator f or an empty
position will begin blinking. To load only one CD, press and
release the Load button. Press and hold the Load button
until you hear a beep and see
‘‘----’’inthedisplay,thenrelease
the button.
You cannot load and play 3-inch (8-
cm) discs in this system. The audio system on Touring model
has an in-dash CD changer that
holdsuptosixdiscs.
To load CDs or operate CD changer,
the ignition switch must be in the
ACCESSORY (I) or ON (II) position.
1.
2. 3.
4.
5.
On Touring Model
Comf ort and Convenience Feat ures
Operating the In-Dash CD
Changer
L oading CDs in the Changer
CD Changer
117

If you do not remove the disc f rom
the slot, the system will reload the
disc af ter 10 seconds and begin
playing it.
To remove a dif f erent CD f rom the
changer,firstselectitwiththe
appropriate preset button. When that
CD begins playing, press the eject
button.If you press the Eject button while
listening to the radio or tape, or with
the audio system turned of f , the disc
that was last selected is ejected.
Af ter that disc is ejected, pressing
the Eject button again will eject the
next disc in the numerical order. By
doing this six times, you can remove
all the CDs f rom the changer.
In any mode, if you press the eject
button and hold it until you hear a
beep, the system will eject all of the
discs in the changer.
You can also eject discs when the
ignition switch is of f . The disc that
was last selected is ejected f irst. You
can eject up to six discs, one at a
time.
To remove the disc that is currently
playing, press the eject button. You
will see ‘‘EJECT’’ in the display. The
system automatically begins the
Load sequence so you can load
another CD in that position. If you do
not load another CD, af ter 10
seconds the system begins playing
the next disc in the changer. If the
changer is empty, the system selects
the previous mode (AM, FM, or
Tape).
If you press the LOAD button while
a disc is playing, the system will stop
playing that disc and start the
loading sequence. It will then play
the disc just loaded. If you stop loading CDs bef ore all six
positions are f illed, and you do not
press the Load button, the system
will wait f or 10 seconds, then stop
the load operation and begin playing
the last CD loaded.
You can also load a CD into an empty
position while a CD is playing by
pressing the appropriate preset
button. Select an empty position (the
CD Loaded indicator is of f ), and
press the preset button f or that
position (1 to 6). The system will
stop playing the current CD and start
the loading sequence. It will then
play the CD just loaded. Removing CDs f rom the Changer
Comf ort and Convenience Feat ures
CD Changer
118

When using CD-R discs, use only
high quality CDs labeled f or audio
use.
When recording a CD-R, the
recording must be closed f or it to
be used by the CD players.
CD-RW discs will not work in this
unit.
Play only standard round CDs.
Odd-shaped CDs may jam in the
driveorcauseotherproblems.When a CD is not being played, store
it in its case to protect it f rom dust
and other contamination. To prevent
warpage, keep CDs out of direct
sunlight and extreme heat.
To clean a CD, use a clean sof t cloth.
Wipe across the CD f rom the center
to the outside edge.
AnewCDmayberoughonthe
inner and outer edges. The small
plastic pieces causing this roughness
can f lake of f and f all on the re-
cording surf ace of the CD, causing
skipping or other problems. Remove
these pieces by rubbing the inner
and outer edges with the side of a
pencil or pen.
Never try to insert f oreign objects in
the CD player or the magazine.
Handle a CD by its edges; never
touch either surf ace. Do not place
stabilizer rings or labels on the CD.
These, along with contamination
f rom f ingerprints, liquids, and f elt-tip
pens, can cause the CD to not play
properly, or possibly jam in the drive.
Handle your CDs properly to
prevent damage and skipping.
Comf ort and Convenience Feat ures
General Inf ormation
Protecting CDs
Protecting Your CDs
119

If you see an error message in the
display while playing a CD, f ind the
cause in the chart to the right. If you
cannot clear the error message, take
your vehicle to an Acura dealer.Without Touring Package
Error MessageCause Solution
FOCUS/CLV Error
Data Read Error
Search Error
Mechanical Error
Control Error
LSI ErrorPress the EJECT button and pull out the CD.
Check if it is inserted correctly in the CD player.
Make sure the CD is not scratched or damaged.
Press the EJECT button and pull out the CD.
Check the CD for damage or deformation.
If the CD cannot be pulled out or the error
message does not disappear after the CD is
ejected, see an Acura dealer.
Consult your Acura dealer.
CD Player Error Messages
Comf ort and Convenience Feat ures120

Error MessageCause Solution
FOCUS Error
Mechanical Error or a
DVD has been loaded in
the CD player
High TemperaturePress the EJECT button and pull out the CD.
Check if it is inserted correctly in the CD player.
Make sure the CD is not scratched or damaged.
Press the EJECT button and pull out the CD.
Check the CD for damage or deformation.
If the CD cannot be pulled out or the error
message does not disappear after the CD is
ejected, see an Acura dealer.
Will disappear when the temperature returns to
normal.
Models with Rear Entertainment System
CD Player Error Messages
Comf ort and Convenience Feat ures121

If you see an error message in the
display while operating the CD
changer, find the cause in the
f ollowing charts. If you cannot clear
theerrormessage,takeyourvehicle
to an Acura dealer.Without Touring Package
Solution
Error Message Cause
See an Acura dealer.
Press the magazine eject button, and insert an
empty magazine.
If the message disappears within a f ew seconds,
unit is OK. If it does not, see an Acura dealer.
Press the magazine eject button and pull it out
the magazine, check for error message. Insert
the magazine again. If the magazine can not be
pulled out, see an Acura dealer.
Press the magazine eject button. If the maga-
zine does not eject, see an Acura dealer.
Will disappear when the temperature returns to
normal.
See an Acura dealer.
Insert CD magazine.
Insert CD in magazine.
Disc changer
malf unction.
Disc is in changer
mechanism.
Disc changer
malf unction.
Disc changer
malf unction.
CD magazine ejection
impossible.
High temperature.
Misconnection or
disconnection of CD
changer.
No CD magazine in the
CD changer.
No CD in magazine.
Comf ort and Convenience Feat ures
CD Changer Error Messages
122

Error Messages CauseSolution
Disc changer
malf unction.
High temperature.
Disc changer
malf unction.
High temperature.See an Acura dealer.
Will disappear when the temperature returns to
normal.
See an Acura dealer.
Will disappear when the temperature returns to
normal.
Touring Model
Comf ort and Convenience Feat ures
CD Changer Error Messages
123

Error Messages CauseSolution
FOCUS Error
No CD in the CD
magazine
Mechanical Error
High Temperature
No CD magazine in the
CD changerPress the magazine eject button and pull it out,
check f or error message, and insert the
magazine again. If the message does not
disappear or the magazine cannot be pulled out,
see an Acura dealer.
Insert CD.
Press the magazine eject button and pull it out,
check f or error message, and insert the
magazine again. If the message does not
disappear or the magazine cannot be pulled out,
see an Acura dealer.
Will disappear when the temperature returns to
normal.
Insert CD magazine.
Models with Rear Entertainment System
Comf ort and Convenience Feat ures
CD Changer Error Messages
124

Playing a T ape
Comf ort and Convenience Feat ures125
TAPE EJECT BUTTON PWR/VOL KNOBTAPE DIRECTION INDICATOR CASSETTE SLOT
TAPE BUTTON
CD BUTTON DOLBY BUTTON
PLAY BUTTON
PROGRAM BUTTON FAST FORWARD BUTTON
PWR/VOL
KNOB PROGRAM BUTTON CASSETTE SLOT TAPE EJECT
BUTTON
TAPE
BUTTON DOLBY
INDICATOR TAPE
DIRECTION
INDICATOR FAST FORWARD
BUTTON
DOLBY BUTTON
CASSETTE
SLOT
FAST FORWARD
BUTTON
PWR/VOL
KNOB
DOLBY
BUTTON
REWIND BUTTON
REWIND
BUTTON TAPE
BUTTON
PROGRAM
BUTTON
TAPE EJECT
BUTTON
PLAY
BUTTON

Î
Ûµ
Î
Dolby noise reduction manuf actured under
license from Dolby Laboratories Licensing Corpo-
ration. ‘‘DOLBY’’ and the double-D symbol are trademarks of Dolby Laboratories
Licensing Corporation.
The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Make sure the open side of the tape
is facing right, then insert the tape
most of the way into the slot. The
system will pull the tape in the rest
of the way, and begin to play it.
Thetapedirectionindicatorinthe
display comes on to show you which
side of the tape is playing. The
indicates the side you inserted
upward is now playing. If you want to
play the other side, press the PROG
button. When the player reaches the
end of the tape, it will automatically
reverse direction and play the other
side. Dolby noise reduction turns on
when you insert a tape. The
indicator will come on in the
display. If the tape was not recorded
in Dolby, turn it of f by pressing the button. Dolby remains of f until
you press the button again.
To remove the tape, press the tape
EJECT button. If you want to turn
the player of f , press the PWR/VOL
knob or turn of f the ignition. The
tape will remain in the drive. When
youturnthesystembackon,the
tape will begin playing where it lef t
off. To rewind the tape,
push the REW ( ) button. You
will see REW in the display. To f ast
f orward the tape, push the FF
( ) button. You will see FF
displayed. Press the PLAY/PROG
button to take the system out of
rewind or fast forward. To switch to the radio while a tape is
playing, press the AM or FM button.
To change back to the tape player,
press the TAPE button.
To Play a Tape
To Stop Playing a TapeT ape Search Function
FF/REW
Playing a T ape
Comf ort and Convenience Feat ures126