remove seats ACURA NSX 1997 Service Repair Manual

P/S ADJUSTMENT GUIDE

07973-6920001

11. Insert the steering rack into the cylinder housing,

being careful not to damage the steering rack

sliding surface.
13. If the pinion dust seal was removed, drive in the

new dust seal until it bottoms on the step on the pi-

nion set screw.

14. Grease the sealing lip of the pinion dust seal.
• Press the new lower bearing into the gearbox

housing until it seats using a press and special

tool.

NOTE:

• Install the lower bearing with the wider side of

the outer race toward the bottom of the

gearbox.

• Hold the outer race with the tool securely.

• Do not allow dust and other foreign materials to

enter the lower bearing.
12. Install the steering pinion into the gearbox.

NOTE: Do not engage the steering pinion with the

steering rack this time.ProCarManuals.com

Seats

Seat Cover Replacement (cont'd)

7. Detach the hooks, then remove the seat-back

cushion.

HOOKS

8. Detach the clips, then remove the seat cover.

Clip locations

SEAT COVER
9. Installation is the reverse of the removal procedure.

NOTE:

• To prevent wrinkles when installing the seat

cover, make sure the material is stretched even-

ly over the frame before securing all the hooks

and clips.

• If necessary, replace any damaged clips.

• Before installing the seat cushion, scrape the old

adhesive smoothly from the seat cushion frame.

Clean the bonding surface with a sponge

dampened in alcohol.

Apply an adhesive to the shadowed area as

shown.

Forward

SEAT CUSHION

FRAME
SEAT-BACK

CUSHION

ADHESIVE AREAProCarManuals.com

Power Seats

Seat Switch Test

CAUTION: Be careful not to damage the seats, the

interior trim or the body.

1. Remove the two screws, then remove the power

seat switch from the power seat.

2. Disconnect the 5P connectors from each power seat

switch.

3. Check for continuity between the terminals, in each

switch position, according to the table.

RECLINE

SWITCH

SLIDE

SWITCH
SLIDE

RECLINE
Position
Terminal

FORWARD

NEUTRAL

BACKWARD

FORWARD

NEUTRAL

BACKWARDProCarManuals.com

Motor Test

CAUTION: Be careful not to damage the seats, the

interior trim or the body.

1. Remove the power seat, then disconnect the 2P con-

nector from the slide motor.

2. Remove the two screws, then remove the power seat

switch from the power seat.

3. Disconnect the 5P connector from the power seat

switch (recline switch side).

View from

wire side

RECLINE

MOTOR

SLIDE

MOTOR

View from

wire side
4. Test motor operation.

CAUTION: When the motor stops running, discon-

nect power immediately.

FORWARD

SLIDE: Connect battery power to the No. 6

terminal and ground to the No. 7

terminal.

BACKWARD

SLIDE: Connect battery power to the No. 7

terminal and ground to the No. 6

terminal.

FORWARD

RECLINE: Connect battery power to the No. 4

terminal and ground to the No. 1

terminal.

BACKWARD

RECLINE: Connect battery power to the No. 1

terminal and ground to the No. 4

terminal.

NOTE: If a motor does not run, reverse the power

and ground connections. If the motor still does not

run, the motor or the wire harness is faulty.

2P CONNECTOR
5P CONNECTORProCarManuals.com