sport mode ACURA NSX 1997 Service Repair Manual

Shift Control

Engine torque controls shifting through the linear solenoid. The linear solenoid is controlled by the TCM, and it is used to

operate the throttle valve.

The TCM instantly determines which gear to select by various signals sent from sensors, and actuates shift control

solenoid valves A and B to control shifting. Also, Sport Shifting mode has been adopted to shift gears up and down manu-

ally in position, while using the shift switch on the steering column's right pod.

The combination of driving signals to shift control solenoid valves A and B is shown in the table below.

Sport Shifting (Manual Shifting) mode

In position, the driver can use the shift switch on the steering column's right pod to shift gears up and down, much

like a manual transmission.

• Pushing up on the shift switch: Transmission upshifts to the next higher gear.

• Pushing down on the shift switch: Transmission downshifts.

The number of the selected gear is displayed in the shift indicator next to the indicator.ProCarManuals.com

Electronic Control System (cont'd)
Description

• Automatic shifting control in Sport Shifting mode

This position also has automatic shifting areas:

• 1-2 upshift

• 4-3 downshift, 3-1 downshift, 2-1 downshift

depending on vehicle speed. To prevent engine over-revving, the transmission has a 1-2 automatic upshift speed, and 4-3,

3-1, 2-1 downshift allowable speeds.

• When the vehicle reaches the 1-2 automatic upshift speed, the TCM outputs the 1-2 upshift signal to the transmis-

sion and the transmission upshifts to 2nd from 1st gear.

• When the vehicle is coasting over the 4-3 downshift allowable speed and 3-2 downshift allowable speed, the TCM

does not input the downshift signal from the shift switch, and the transmission does not downshift.

• When the vehicle is coasting over the 2-1 downshift allowable speed in 2nd gear, the TCM inputs the signal to wait

until it reaches the 2-1 downshift allowable speed, then the shift indicator blinks to indicate it is waiting to downshift

to
1st.

When the vehicle decelerates to a stop, the transmission shifts to 1st gear automatically.

The transmission can be shifted to 2nd gear by pushing the shift switch up while the vehicle is stopped. This allows the

vehicle to start off in 2nd gear.

Lock-up Control

From sensor input signals, the TCM determines whether to turn the lock-up ON or OFF, and activates lock-up control

solenoid valve A and/or B accordingly.

The lock-up control mechanism comes into operation in 2nd, 3rd, and 4th, in positions.

The combination of driving signals to lock-up control solenoid valves A and B is shown in the table below.ProCarManuals.com