Alfa Romeo 8C 2010 Owner handbook (in English)

99
4
BAECD
BEFORE YOU DRIVE
WINDSCREEN
WASHER/WIPERS
AND HEADLIGHT
WASHERThe windscreen wiper and washer only works
with the ignition key turned to MAR.
WINDSCREEN WIPER
The lever has 5 setting positions:A - Windscreen wipers off.B - Automatic operation. In this position,
the sensing range of the rain sensor can
be adjusted (lever turned to first click
position).
C - Slow continuous operation (lever turned to
second click position).D - Fast continuous operation (lever turned to
third click position).E - Fast temporary operation (non-permanent
position).
WINDSCREEN WASHER
Pulling the lever towards the steering wheel
(non-permanent position) activates the
windscreen washer and wiper.
When the windscreen washer is activated, the
windscreen wipers start automatically. Releasing
the lever stops the spray of fluid while the blades
continue to wipe for a short time.
WARNING: Do not activate the windscreen
washer during the cold months until the
windscreen has warmed up. If it has not warmed
up, the liquid could freeze on the glass and block
the view.
WARNING: If there is ice or snow on the
windscreen, do not activate the windscreen wiper
to prevent damage to the device.

100
4
F
HEADLIGHT WASHERS
The headlight washers are activated
automatically when the windscreen washer is
started and the low beams are on.
The headlight washer and windscreen washer
share the same fluid tank, and a low fluid level
is indicated by the same warning light on the
instrument panel.
The headlight washers are deactivated if the
vehicle speed exceeds 130 Km/h.RAIN SENSOR
The function of the rain sensor is to adapt the
frequency of the windscreen wiper strokes (in
the intermittent operation mode) to the intensity
of the rain.
All the other functions controlled by the right-
hand lever (windscreen wipers off, headlight and
windscreen washer in continuous slow and fast
operation mode and in temporary fast operation
mode) remain the same.
The rain sensor is automatically activated when
shifting the right-hand lever to position
B and has
an adjustment range that varies progressively
from “windscreen wiper off” when the
windscreen is dry, to” second continuous speed”
in heavy rain.To adjust the intermittent wiping frequency, shift
the lever to position
B, rotate the dial
F.
Turning the dial clockwise, intermittent operation
varies from a maximum (fast intermittent
operation) to a minimum (slow intermittent
operation).
If the engine is turned off when the windscreen
wiper is set to automatic with the lever in
position
B, to reactivate the feature, the next
time the engine is started you must shift the
lever to the standby position
A, and then back to
position
B.

101
4
BEFORE YOU DRIVE
CAUTION
Before cleaning the front
windscreen (for example in service
stations) make sure the rain sensor is
deactivated or that the key is turned
to STOP. The rain sensor must be
deactivated also when washing the
vehicle by hand or in automatic car
washes.WARNING: If there is ice or snow on the front
windscreen, do not activate the rain sensor to
avoid damaging the wiper motor.
SENSOR FAILURE
When the rain sensor is activated, in the event
that it is malfunctioning, the windscreen wiper
will be turned on in intermittent mode and the
sensing range will be set by the user, regardless
of whether or not there is rain on the windscreen.
A failure message will be displayed on the
instrument panel.
In this case, we recommend that you deactivate
the rain sensor and turn on the windscreen wiper,
if necessary, in continuous mode. As soon as
possible, contact an Authorised Service Centre
of the Manufacturer’s Network.

102
4
D
A
C
B
C
A
D
E
A
AIR CONDITIONING AND HEATING SYSTEM

103
4
BEFORE YOU DRIVE
A) Adjustable central and side vents.B) Air conditioning and heating system
controls.C) Air vents for foot area.D) Fixed air vents for side windows.E) Fixed air vents for windscreen.
The vehicle is equipped with an automatic dual-
zone air conditioner/heater,
which adjusts the air temperature, its distribution
and flow in the passenger compartment in two
separate zones: driver side and passenger side.OPERATING MODES
Automatic
This mode automatically adjusts humidity
and ventilation according to the selected
temperature.
Partially Automatic
This is used to adjust certain parameters
manually, while others remain automatic.
Manual
This mode allows the user to set different values
as desired.

104
4
AB
D
F
H
J
C
E
G
I
Controls A) Left-hand temperature controlB) Air conditioning compressor activation/
deactivationC) Left-hand air distribution controlD) Windscreen defogging/demistingE) Fan speed adjustmentF) Recirculation functionG) Right-hand air distribution controlH)
Rear window and external rear-view mirror
defogging/demisting
I) Right-hand temperature settingJ) Residual heat function.

105
4
BEFORE YOU DRIVE

Air distribution controls C
and G
They can operate in two modes:
Automatic (AUTO)
the air flow distribution is controlled by the
electronic system depending on the climate
conditions and the selected temperature.
Manual
This is used to direct the air flow in the six
positions of the respective areas (driver-
passenger).

Temperature selection
controls A and I
This is used to set the temperature desired
inside the passenger compartment.
The end positions activate the functions
“LO” and “HI” (minimum and maximum air
temperature). Activation
Fully automatic operation: turn the controls
C, E
and
G to AUTO.
Deactivation
Deactivate the compressor by pressing the button
B and set the control to OFF
E (fan speed).
Air conditioning control
switch B
Released
the air conditioner is on. The air is cooled and/
or only dehumidified according to the selected
temperature.
Pressed (LED on)
The air conditioner is off.
However, heating is still enabled and will turn
on according to the temperature set.

Fan speed control E
It can operate in three modes:
Automatic (AUTO)
The air flow is controlled by the electronic
system according to the selected temperature to
be reached and maintained.
Manual “OFF”
Turn the control to this position to turn off the air
conditioning and to only allow air inlet from the
outside when the vehicle is in motion.
Fan speed
The four setting positions allow the occupants to
select the air flow rate.

106
4

Residual heat function J
This function allows the user to maintain the
temperature set for the passenger compartment
for a certain time (15 minutes), even after the
key has been turned to STOP. To activate this
function, push the “REST” button before turning
the key to STOP.
Once selected, this function is activated when
the key is turned to STOP and sets the following
features:
- bilevel air distribution
- compressor deactivation
- minimum fan speed
- air recirculation activation
- water recirculation pump activation
The system is deactivated after 15 minutes or
when the key is turned to MAR.
In addition, the REST function will be disabled
(if active), when the battery voltage is below
11.5V. When the outside temperature is above
25°C it will not be possible to activate the
function.

Air recirculation switch F
Released
the air flow comes from the outside.
When outside temperatures exceed 35 °C,
the air recirculation option remains on with a
120-second pause every twenty minutes, to
refresh the air.
Pressed (LED on)
The air flow comesfrom inside the passenger
compartment.
The recirculation speeds up air heating or
cooling.
Prolonged use is not advisable.

Windscreen defogging/
demisting switch D
Press this switch (LED on) to activate
windscreen defogging/demisting.
To deactivate this function, press the switch.

Defogging/demisting switch
H for rear window and
external rear-view mirrors
It is activated by operating the switch
H and
activation is signalled by the LED.
If it is not deactivated within thirty minutes
after activation, this function deactivates
automatically.
It is however advisable to deactivate it once the
defogging/demisting process is complete.
Once the internal temperature has stabilised at
the desired level, you are advised not to change
the position of the selector unless the external
temperature changes drastically.
A change in the position of the temperature
selection switch will involve a difference
between temperature inside the passenger
compartment and the air coming out of the
vents. This difference will gradually decrease as
the system works at full, stabilised speed.

107
4
D
I
A
J
BEFORE YOU DRIVE
ADJUSTABLE VENTS
These can be positioned vertically and
longitudinally using control
I.
Using control
J you can adjust the air flow.
The vents
A have these features.FIXED AIR DISTRIBUTION
VENTS
These cannot be adjusted and are designed
specifically for demisting/defrosting or cooling
certain areas.
Vents
C, D and
E have these features.

108
4
2
1
CAR STEREO
SYSTEMThe system is made up of:1) Two 38 mm Tweeters with 25 Wrms output
power installed in the dashboard.2) Two 165 mm mid-woofers with 20 Wrms
output power installed in the door panels.