headlight bulb ACURA CSX 2006 Service User Guide


µ
µ µ
µ
YES
NO YES
NO
22-171
B
A
07AAJ-S3MA100 HID UNIT 2P CONNECTOR
BLK
6. Connect the HID bulb test light (A) to the socket (B).
7. Do the battery terminal reconnection procedure(see page 22-68).
8. Turn the combination light (headlight) switch ON.
Replace the original HID bulb (see page
22-168).
Go to step 10.
9. Turn the combination light (headlight) switch OFF.
10. Do the battery terminal disconnection procedure (see page 22-68).
11. Disconnect the HID bulb test light from the socket.
12. Do the battery terminal reconnection procedure (see page 22-68).
13. Disconnect the HID unit 2P connector.
14. Turn the combination light (headlight) switch ON. 15. Check for continuity between the HID unit 2P
connector terminal No. 1 and body ground.
Go to step 16.
Repair an open in the wire between the HID
unit and body ground. If the wire is OK, check for
poor ground at G201 or G301.
(cont’d)
Wire side of female terminals
Does t he bul b i n t he t est l i ght come on? Is there continuity?
08/08/21 14:27:00 61SNR030_220_0173
ProCarManuals.com
DYNOMITE -2009-


Î

(#'




 )
22-17422-174 Exterior Lights
Headlight Adjustment (cont’d) Headlight Replacement
U: UP
D: DOWN
A A
D B
C
A
5. If necessary, open the hood and adjust the
headlights to local requirements by turning the
adjusters (A). A transient high tension (25,000 V) occurs at the bulb sockets or the high intensity discharge (HID)
lamps when the combination light switch is turned
ON, it may cause serious electrical shock or
electrocution if you do not observe the cautions.
Do not service the headlights assembly in wet
conditions, such as rain or snow, near a sprinkler
system, or when your hands are wet to prevent
electrocution.
1. Remove the front bumper (see page 20-146).
2. Remove the connectors (A) from the headlight assembly (B).
3. Remove the five bolts, then remove the headlight.
4. Remove the bolt (C) and the corner upper beam (D) from the headlight.
5. Install the headlight in the reverse order of removal.
6. After replacement, adjust the headlight to local requirements.
The illustration is shown from
back side of left headlight.
08/08/21 14:27:01 61SNR030_220_0176
ProCarManuals.com
DYNOMITE -2009-


Î

(#'




 )
22-17422-174 Exterior Lights
Headlight Adjustment (cont’d) Headlight Replacement
U: UP
D: DOWN
A A
D B
C
A
5. If necessary, open the hood and adjust the
headlights to local requirements by turning the
adjusters (A). A transient high tension (25,000 V) occurs at the bulb sockets or the high intensity discharge (HID)
lamps when the combination light switch is turned
ON, it may cause serious electrical shock or
electrocution if you do not observe the cautions.
Do not service the headlights assembly in wet
conditions, such as rain or snow, near a sprinkler
system, or when your hands are wet to prevent
electrocution.
1. Remove the front bumper (see page 20-146).
2. Remove the connectors (A) from the headlight assembly (B).
3. Remove the five bolts, then remove the headlight.
4. Remove the bolt (C) and the corner upper beam (D) from the headlight.
5. Install the headlight in the reverse order of removal.
6. After replacement, adjust the headlight to local requirements.
The illustration is shown from
back side of left headlight.
08/08/21 14:27:01 61SNR030_220_0176
ProCarManuals.com
DYNOMITE -2009-




(#'


 )
Headlight Front Side Marker Light
Headlight (High Beam): 60 W
Headlight (Low Beam) : 51 W
Without HID
High
Low Front Side Marker Light: 2 CP
22-177
Bulb Replacement
A
A
1. For low beam : Remove the inner fender (see page
20-171).: Without HID
2. Disconnect the 2P connector (A) from the headlight.
:
3. Turn the bulb socket 45 ° counterclockwise to remove the bulb.
4. Install a new bulb in the reverse order of removal. 1. Remove the inner fender (see page 20-171).
2. Disconnect the 2P connector (A) from the front side
marker light.
3. Turn the bulb socket 45 ° counterclockwise to remove the bulb.
4. Install a new bulb in the reverse order of removal.
(cont’d)
08/08/21 14:27:03 61SNR030_220_0179
ProCarManuals.com
DYNOMITE -2009-