AUDI ALLROAD 2000 Owners Manual

CONT
ROLS AND
EQUIPMENT---------------------
.·
Emergency closing
If you cannot close the roof with the electric
switch, you can still close the roof manually
using a crank (see right illustr ation). The
crank is located behind the fuse cover (see
page 274).
In order to access the power roof motor, re­
move the interior light (lens and housing) as
follows:
• Place the flat side of the screwdriver
found in the vehicle tool kit on the rear side
of the lens as shown in the illustration and
carefu lly pry the lens downward.
17 0 •
Then insert the screwdriver into the gap
between the light housing and the frame in
the rear on the side and carefully pry out the
housing.
To close the roof, press the manual
crank (1) into the hex socket (2) until it en­
gages. Keep pressing down and turn the
crank.
Reinst all the light housing and lens in the
reverse order.
Have the problem corrected by your autho­
rized Audi dealer. Power
roof with solar panel*
The solar panel is operated in the same way
as the power roof. The roof's solar cells sup­
ply energy for the air conditioner blower.
See page 166.
The interior trim is fixed to the solar panel
cannot be opened and closed separately.

---------------------CONTROLS
AND EQUIPMENT
Interior lights, reading lights
The dome light and the front rea ding
lights are located above the windshield.
A -Dome light
Switch positions:
0- 0ff
Center position -Door contact
switch
The light is switched on when the doors are
unlocked or when one of the doors is
opened. The light comes also on when the
key is removed from the steering lock. Interior light
delay
The light stays on for about 30 seconds after
it is activated. If one of the doors is left open
the light goes out automatically after about
10 minutes.
The light goes off as soon as you lock the car
or switch on the ignition.
1- On continuously
Note
A dimmer automatically adjusts the bright­
ness of the lights.
B - Front reading lights
�
To turn the reading lights on and off press
the switch (see symbol). --
--� J: ___ ! __
\
I
Ot.:-= � :UJ,-.
i ·��-_:]
: \
·- ------- -···----·--- --·
846·759
'
C - Rear interior light
See "Dome light" for switch positions.
D -R ear reading light
�
To turn the reading lights on and off press
the switch (see symbol).
171

CONT
ROLS AND EQUIPMENT---------------------
Ambient lighting
When you switch on the ignition, the lights
in the door handles come on automatically.
The lights above the windshield come on
when the headlights are switched on. The
center console is illumi nated from above.
You cannot manually turn these off.
17 2 Luggage
compartment light
Luggage compartment light
The light is located at the top of the luggage
compartment.
Switch positions:
0- Off
Center position -Light comes on when
the rear lid is opened.
I - Luggage compartment light on cont inu­
ously.
Delay function
See description on previous page. ---- -------------
-
Rear lid light
The light in the rear lid comes on automati­
cally when you open the lid. If you leave the
lid open for longer than 1 0 minutes, the I ight
will automatically switch off.

-------------�-------CONTROLS AND
EQUIPMEN T
Audi Homelink ® Uni versal Transm itter*
-� ....... ..
The Audi Homelink ® Un iversal Transm itter
is located on the driver's side sun visor.
This innovative feature will learn the radio
frequency codes of most current transmit­
ters used to activate garage doors, entry
door locks, estate gates, security systems,
and home or office lighting.
The Homelink ® Universal Transmitter is ca­
pable of operating up to three separately
controlled devices. The
Homelink ® operates off the vehicles
battery and charging system and has non­
volatile memory. If the battery dies or is dis­
connected, Homelink® will retain all pro­
gramming.
�W ARNING
When programming the Audi
Homelink® Universal Transm itter,
you may be operating a garage
door or estate gate. Make sure that
people and objects are out of the
way to prevent potential harm or
damage. Note
Do not
use this Audi Homelink®
Universal Transmitter with any ga­
rage door opener that lacks the
safety stop and reverse feature as
required by federal safety stan­
dards. This includes any garage door
opener model manufactured before
April 1, 1982.
A garage door opener which cannot
detect an object, signaling the door
to stop and reverse does not meet
current federal safety standards.
Using a garage door opener without
these features increases risk of seri­
ous injury or death.
For more information, call toll-free:
1 (800) 355-3515.
173

CONT
ROLS AND EQUIPMENT---------------------
I
I
I
;
f
'
.
,
· ·- --- -.. ... �-//
1 - Channel 1
2- Channel 2
3- Channel 3
A- Indicator Light
B - Optimal placement of hand-held
transmitter during training.
17 4 Initial
Programming of the
Audi HomeUnk ® Universal
Tr ansmitter
1 - Turn the ignition switch on.
2- Prepare for programming the
Homelink ® Un iversal Transm itter by
erasing the three factory default chan­
nels:
Simu ltaneously press and hold chan­
nels 1 and 3 -releasing only when the
indic ator light (A) begins to flash after
20 seconds.
3 - Hold the end of the hand-held transmit­
ter of the device you wish to train
approximately 2 inches away from the
surface of the Homelink ® channels -
. keeping the indicator light in view.
4- Using both hands, simultaneously push
the hand-held transmitter button and
one of the Homelink ® channels. Do
not release until step 5 has been com­
pleted. .
.... . ..
--�,
j � 1,)1B4B-283 .
5 - The Home link® indicator light will flash
first slowly, and then rapidly. When the
ind icator light flashes rapidly, both the
button and channel may be released .
If you wish, repeat procedures 3 through 5
to program the rema ining channels.
If a garage door opener has been pro­
grammed but does not activate with
Homelink ®, proceed to the following sec­
tion: "Training a Garage Door Equipped with
Rolling Code"

Training a Garage Door
Equip ped with Rolling Code
To train your rolling code garage door
opener to operate from your Homelink®
Universal Transmi tter, follow these steps
after completing the "Program­
ming" portion of this text (the aid of a sec­
ond person may make the training quicker
and easier):
1 - Locate and press and relaaaa the
training (or "learning") button on the
garage door opener motor head unit.
(Exact location and color of the button
may vary by garage door opener brand.)
If there is difficulty locating the training
button, reference the garage door
opener owner's manual or call toll free:
1- 800-355- 3515.
2 - Return to the vehicle and press and re­
lease the progr ammed Homelink ®
channel. Press and release the
Homelink ® channel a second time to
complete the progra mming process.
(Some garage door openers may re­
qu i· re you to do this procedure a thir d
ti me.) The
garage door opener should now recog­
nize the Audi Homelink ® Un iversal Trans­
mitter. You may use either the hand-held
transmitter or the Audi Home link® Univer­
sal Transmi tter to activate the garage door.
Oper ating the Audi HomeLink ®
Uni versal Transmitter
1 - Tum the ignition switch on.
2 - Select and firmly press and release the
appropriate channel (1, 2, or 3) to acti­
vate the trained device (e.g. garage
door, estate gate, home security sy­
stem, entry door lock, or home or office
lighting). CONTROLS
AND EQUIPMENT
Erasing the Audi HomeLink ®
Universal Transm itter's Pro­
gramming
1 - Turn the ignition switch on.
2 - Simult aneously press and hold chan­
nels 1 and 3 until the indicator light be­
gins to flash after 20 seconds.
3 - Release both buttons.
This process will erase the trained codes of
the three channels or erase the factory set
default codes.
The Audi Homelink ® Un iversal Transmitter
is now in the train (or progra mming) mode
and can be progra mmed at any time follow­
ing steps 3 through 5 in the "Progr amming"
portion of this text.
175

CONT
ROLS AND EQ
UIPMEN T---------------------
Reprogramming a Single Audi
HomeLink ® Universal Transmit­
ter Channel
If a Homelink ® channel has been pro­
grammed to activate a device, and it has
been decided to program another device us­
ing the same Homelink® channel, follow
these steps:
Press and hold the desired Homelink ®
button for approximately 20 seconds.
Do not release until step 3 has been
completed.
2 - When the indicator light begins to flash
slowly, position the hand-held transmit­
ter approximately 2 inches away from
the Homelink ® surface. Press and
hold the hand-held transmitter button.
3- The indicator light will flash, first slowly,
and then rapidly. When the indicator
light begins to flash rapidly, release
both the button and channel.
The previous device has now been erased
and the new device has been progra mmed
into Homelink ®. This procedure will not af­
fect any other programmed Homelink®
channels.
17 6 Accessories
Accessories for the Audi Homelink ® Uni­
versal Transmitter are available through vari­
ous sources.
If you would like additional information on
Homelink ®. where to purchase the
Homelink ® compatible products, or would
like to purchase the Homelink ® Home
Lighting Package, please call toll-free:
1- 800-355- 3515. Notes
This device complies with FCC rules
part 15. Operation is subject to following
conditi ons:
1 - This device may not cause any harmful
interference and
2 - This device must accept any interfer­
ence that may be received including in­
terference that may cause undesired
operation.
� WARNING
The transmitter has been tested
and complies with FCC and DOC/
MDC rules. Changes or modifica­
tions not expressly approved by
the party responsible for com­
pliance could void the user's au­
thority to operate the device.
DOC: ISTC 1763 102 264
Prince MODEUFCC ID: CB2 V94800

Sun
visors
I e4s-2e1
1
You can lift the visors out of the center
mounting {arrow 1 in illus tration) and move
them toward the door windows to protect
against side glare.
A vanity mirror is located on the back of the
sun visors.
The light for the mirror {which is located in
the roof) switches on automatically when
the mirror cover is slid open (arrow 2) and
switc hes itself off when the cover is closed .
The light also switches itself off when the
sun visor is pushed back up. There is
also a small folding sun visor lo­
cated between the sun visors for the driver
and front passenger. You can use this sun vi­
sor to cover the space about the rear-view
mi rror. CONT
ROLS AND EQUIPMENT
Sun shade*
·---� --�
For protect ion against direct sunlight, al­
ways use the sun shade whenever you
must park your vehicle exposed to the sun.
Rear doors•
The sun shade can be used to cut glare
through the rear passengers' windows.
Pull out the shade and engage it in the hooks
on the upper part of the door frame.
177

CONTROLS AND
EQUIPMENT--------------------
Rear window
Pull out the sun shade and engage it in the
retainers (arrows) located on the upper part
of the rear window frame.
17 8 Glo
ve compartment
B4B-388
Yo ur Audi has a lockable glove compar t­
ment. Only the master keys or emergency
key will lock or unlock the glove compa rt­
ment. To open the lockable glove compart­
ment, pull the handle in direction of arrow.
The light will come on when the parking I
headlights are switched on and the glove
compartment is open.
To close, press glove compartment upward
until lock engages. 1ft
WARNING
To reduce the risk of personal in­
jury in an accident or sudden stop,
always keep the glove compart­
ment closed while driving.

Coat hooks
A fold-out coat hook is located above each
rear door.
To release the coat hook, press the top part
of the hook (arrow). �W
ARNING
• The coat hooks muet only be
used for light weight clothing. Do
not leave any heavy or sharp edged
objects in the pockets which may
interfere with the side airbag de­
ployment and can cause personal
injury in an accident.
Always heed all WARNINGS in
chapter ., AIRBAG SYSTEM".
• Do not hang heavy objects on
the coat hooks, as they could cause personal injury in a sudden
stop.
• Hang clothes in such a way that
they do not impair the driver's vi­
sion. CONTROLS
AND EQUIPMENT
179