CHEVROLET CAMARO 1996 4.G Owners Manual

Downloaded from www.Manualslib.com manuals search engine Windshield Washer
At the top of the turn signaUmultifimction lever, there’s
a paddle with the word
PUSH on it. To spray washer
fluid
on the windshield, just push the paddle. The
washer will continue
to spray until you release the
paddle for less than a second. The wipers will clear the
window and wipe a few more times before stopping or
returning to the previous setting.
I I
A CAUl w
w
In freezing weather, don’t use your washer until
the windshield
is warmed. Otherwise the washer
fluid can form ice
on the windshield, blocking
your vision.
Cruise Control (Option)
With cruise control, you can maintain a speed of about
25 mph (40 km/h) or more without keeping your foot on
the accelerator. This can really help
on long trips. Cruise
control does
not work at speeds below about 25 mph
(40 km/h).
2-46

Downloaded from www.Manualslib.com manuals search engine When you apply your brakes, or push the clutch pedal,
if you have a manual transmission, the cruise control
shuts
off.
Setting Cruise Control
0 Cruise control can be dangerous where you
can’t drive safely at a steady speed.
So,
don’t use your cruise control on winding
roads or in heavy traffic.
slippery roads. On such roads, fast changes
in tire traction can cause needless wheel
spinning, and you could lose control. Don’t
use cruise control on slippery roads.
0 Cruise control can be dangerous on
If your vehicle is in cruise control when the optional
ASR system begins to limit wheel spin, the cruise
control will automatically disengage. (See
“ASR
System” in the Index.) When road conditions allow you
to safely use it again, you may turn the cruise control
back
on.
L
QT’TIO’’:
If you leave your cruise contirol switch on when
you’re not using cruise, you might hit
a button
and go into cruise when you don’t want to. You
could be startled and even lose control. Keep
the cruise control switch
OFF until you want
to use it.
1. Move the cruise control switch to ON.
2-47

Downloaded from www.Manualslib.com manuals search engine 2. Get up to the speed you want.
3. Push in the SET button at the end of the lever and
release
it.
4. Take your foot off the accelerator pedal.
Resuming a Set Speed
v
Suppose you set your cruise control at a desired speed
and then apply the brake or clutch pedal. This, of course,
shuts off the cruise control. But you don’t need to reset
it. Once you’re going about 25 mph (40 kmh) or more,
you can move the cruise control switch from
ON to
R/A (Resume/Accelerate) for about half a second.
You’ll go right back up
to your chosen speed and
stay there.
2-48

Downloaded from www.Manualslib.com manuals search engine Increasing Speed While Using Cruise Control
There are two ways to go to a higher speed:
0 Use the accelerator pedal to get to the higher speed.
Push the button at the end of the lever, then release
the button and the accelerator pedal. You’ll now
cruise at the higher speed.
0 Move the cruise switch from ON to R/A. Hold it
there until
you get up to the speed you want, and
then release the switch.
(To increase your speed in
very small amounts, move the switch to
WA for
less than half
a second and then release it. Each
time you
do this, your vehicle will go about 1 mph
(1.6
km/h) faster.)
Reducing Speed While Using Cruise Control
There are two ways to reduce your speed while using
cruise control:
Push in the button at the end of the lever until you
reach the lower speed you want, then release it.
To slow down in very small amounts, push the
button for less than half a second. Each time you
do
this, you’ll go 1 mph (1.6 km/h) slower.
Passing Another Vehicle While Using Cruise Control
Use the accelerator pedal to increase your speed. When
you take your foot off the pedal, your vehicle will slow
down to the cruise control speed you set earlier.
Using Cruise Control on Hills
How well your cruise control will work on hills depends
upon your speed, load and the steepness of the hills.
When going up steep hills, you may have to step
on the
accelerator pedal to maintain your speed. When going
downhill, you may have
to brake or shift to a lower gear
to keep your speed down. Of course, applying the brake
takes you out of cruise control. Many drivers find this
to
be too much trouble and don’t use cruise control on
steep hills.
Ending Out of Cruise Control
There are several ways to turn off the cruise control:
0 Step lightly on the brake pedal or push the clutch
pedal, if
you have a manual transmission ; OR
Move the cruise switch to OFF.
Erasing Speed Memory
When you turn off the cruise control or the ignition,
your cruise control set speed memory
is erased.
-9

Downloaded from www.Manualslib.com manuals search engine Lamps
The main lamp control is a knob that works these lamps:
Headlamps
0 Taillamps
Parking Lamps
License Lamps
0 Sidemaricer Lamps
0 Instrument Panel Lights
-’J$
’ I Turn the knob to this position to turn on your
headlamps and other operating lamps.
PC Turn the knob to this position to turn on your
parking lamps without your headlamps
Turn the knob
to OFF to turn off the lamps.
Headlamps On Reminder
If you turn the ignition to the OFF position and leave the
lamps on,
you will hear a chime, lasting up to five
seconds. If the lamps are still
on when you open the
driver’s door, the chime will sound again.
Daytime Running Lamps (Option)
Daytime Running Lamps (DRL) can make it easier for
others to see the front
of your vehicle during the day.
DRL can be helpful in many different driving
conditions, but they can be especially helpful in the
short periods after dawn and before sunset.
A light sensor on top of the instrument panel makes the
DRL work,
so be sure it isn’t covered.
2-50

Downloaded from www.Manualslib.com manuals search engine The DRL system will make your front turn signal lamps
come on when:
0 The ignition is on,
0 The headlamp switch is OFF, and
The parking brake is released.
When the
DIU are on, only your front turn signal lamps
will be on. The taillamps, sidemarker and other lamps
won’t be on. Your instrument panel won’t be lit
up either.
When it’s dark enough outside, your front turn signal
lamps will go
out and your headlamps will come on.
The other lamps that come on with your headlamps will
also come on.
When it’s bright enough outside, the regular lamps will
go
off, and your front turn signal lamps will come on.
As with any vehicle, you should turn on the regular
headlamp system when you need
it.
Fog Lamps (Option)
i
0 0
0
J
Use your fog lamps for better vision in foggy or misty
conditions. Your parking lamps must be on
or your fog
lamps won’t work.
2-51

Downloaded from www.Manualslib.com manuals search engine $0 To turn the fog lamps on, push the top of the fog
lamp switch. Push the bottom
of the switch to turn the
fog lamps off.
A light on the switch will come on when
the fog lamps are
on.
Interior Lamps
Instrument Panel Brightness Control
Fog lamps will go off whenever your high beams come
on. When the high beams go off, the fog lamps will
come on again.
If your vehicle is equipped with the Vehicle and Content
Theft-DeterrentIAlarm System and your fog lamp
switch is on, the fog lamps may flash, along with the
parking lamps, to indicate operation of the Vehicle
and Content Theft-DeterrenVAlarm System. See
‘Vehicle and Content Theft-DeterrentIAlarm System’’
in the Index.
This switch controls the brightness
of your
instrument panel lights. Turn the switch
to brighten or
dim the lights.
If you turn the switch all the way up,
your courtesy lamps
will come on.
3 c3

Downloaded from www.Manualslib.com manuals search engine Courtesy Lamps
When any door is opened, several interior lamps go on.
These lamps are courtesy lamps. They make it easier for
you to enter and leave your vehicle.
Courtesy lamps include the dome lamp and other lamps
throughout the interior of your vehicle.
To prevent battery rundown, your interior lamps will be
disabled about
10 minutes after the ignition is turned to
the OFF position. The
10 minute timer will be restarted
if you do any
of the following:
1. Turn the ignition on.
2. Open either door.
3. Press any button on your Remote Lock
Control transmitter.
4. Turn the interior lamp switch from OFF to ON.
5. Open the hatch.
Delayed Illumination (Option)
With delayed illumination, when you open a door, your
courtesy lamps will come on and stay
on for 25 seconds
after the doors are closed. The
25 seconds is shortened if
the ignition is turned to the RUN position or if the
power locks are activated.
To turn this feature on or off,
see “Feature Customization” in the Index.
Exit Lighting (Option)
With exit lighting, the interior lamps will come on when
you remove the key from the ignition
to help you see
while exiting the vehicle. To turn this feature on or off,
see “Feature Customization”
in the Index.
2-53

Downloaded from www.Manualslib.com manuals search engine Front Map Lamps
-1
I I
Your inside rearview mirror includes two map lamps.
Each lamp has its own switch. Use the switch closest to
the lamp to turn it on. The lamps will also go
on when a
door
is opened.
Courtesy lamps include the dome lamp and other lamps
throughout the interior
of your vehicle.
Retained Accessory Power (RAP)
Your vehicle is equipped with a Retained Accessory
Power (RAP) feature which will allow certain features
of your vehicle to continue to work up to 10 minutes
after the ignition key is turned to the
OFF position.
Your electric mirrors, power windows, and audio system
will work when the ignition key
is in the RUN or ACC
positions. Once the key is turned from
RUN to OFF,
these features will continue to work for up to 10 minutes
or until either door is opened.
Your power door unlock and remote hatch release
features will work when the ignition key
is in the RUN
or ACC positions or if either door is open. Once the key
is turned
to OFF, these features will continue to work for
up to
10 minutes. If either door is open and the ignition
key is
OFF, these features will continue to work until
both doors have been closed for about
30 seconds or
until the theft-deterrent system arms. At that time, both
the power door unlock and remote hatch release features will be disabled
to enhance the security of the vehicle.
The power door lock function will work at all times
except during Lockout Prevention (if this feature is
enabled). See “Lockout Prevention” in the Index.
2-54

Downloaded from www.Manualslib.com manuals search engine Mirrors
Inside Daymight Rearview Mirror
An inside rearview mirror is attached to your windshield.
The mirror has pivots
so that you can adjust it.
You can adjust the mirror for day or night driving, Pull
the tab for night driving to reduce glare. Push the tab for
daytime driving.
Outside Manual Adjustable Mirror
Adjust the passenger’s side outside mirror by hand so
that you can just see the side of your vehicle when you
are sitting
in a comfortable driving position.
Manual Remote Control Mirror
Adjust the driver’s side outside mirror with the lever on
the door. Adjust the mirror so that you can just see the
side of your vehicle when you are sitting in a
comfortable driving position.
2-55