CHEVROLET CORVETTE 1995 4.G Owners Manual
Page 91 of 386
Downloaded from www.Manualslib.com manuals search engine When the DRL are on, only your front turn signal lamps
will be
on. The taillamps, sidemarker and other lamps
won’t
be on. Your instrument panel won’t be lit up either.
When it’s dark enough outside, your front turn signal
lamps will go out and your headlamps will come on.
The other lamps that come on with your headlamps will
also come on.
When it’s bright enough outside, the regular lamps will
go off, and your front turn signal lamps come on.
As with any vehicle, you should turn on the regular
headlamp system any time you need
it.
Fog Lamps
Use your fog lamps for
better vision in foggy or
misty conditions. Your
parking lamps
or
low-beam headlamps must
be on or your fog lamps
won’t work.
To turn the fog lamps on, push the button. Push the
button again
to turn the fog lamps off. A light above the
button will come on when the fog lamps are on.
2-48
Page 92 of 386
Downloaded from www.Manualslib.com manuals search engine Interior Lamps Mirrors
Courtesy Lamps
When any door or the hatch is opened, the interior lamps will go on (unless it’s bright outside). The lamps will
stay
on for about 30 seconds or until you turn on the ignition.
Front Map Lamps
Your inside rearview mirror includes two map lamps.
The lamps will go on when a door is opened. When the
doors are closed and the ignition is
on, press the switch
to turn
on the lamps.
Inside Daymight Rearview Mirror
An inside rearview mirror is attached above your
windshield. The mirror has pivots
so that you can adjust
it.
You can adjust the mirror for day or night driving.
Pull
the tab for night driving to reduce glare. Push the tab for
daytime driving.
2-49
Page 93 of 386
Downloaded from www.Manualslib.com manuals search engine Power Remote Control Mirrors
The electric mirror control is on the driver’s door. To
adjust either mirror, turn the switch to LEFT (L) or
RIGHT (R). Then use the joystick to adjust the mirror.
When you are done adjusting the mirrors, move the
control back to the center to avoid accidental
adjustment.
Convex Outside Mirror
Your passenger’s side mirror is convex.
A convex mirror’s surface is curved so you can see more
from the driver’s seat.
2-50
Page 94 of 386
Downloaded from www.Manualslib.com manuals search engine Sun Visors Covered Visor Vanity Mirror
To block out glare, you can swing down the visors. You
can also swing them to the side.
With the hardtop roof removed
or the convertible top
down, you can flip the visors straight up to help reduce
wind turbulence. Pull down the sun visor and lift
the cover to expose the
vanity mirror. When the ignition is on, slide the switch
next to the mirror up to turn the lamps on. Be sure to
turn the lamps off before closing the cover.
2-51
Page 95 of 386
Downloaded from www.Manualslib.com manuals search engine Roof Panel (Coupe)
Until you are sure you can remove the panel alone, have
someone help you.
Removing the Roof Panel
2. Remove the ratchet from the console.
1. Park on a level surface, set the parking brake firmly
and shift an automatic transmission into PARK
(P).
Shift a manual transmission into REVERSE (R).
Lower both windows, turn the ignition key to LOCK
and move both sunshades to the side.
2-52
Page 96 of 386
Downloaded from www.Manualslib.com manuals search engine 3. Use the ratchet to loosen the front bolts. Don’t
remove them. They’ll stay in place when loose. 4. The two rear bolts are on the roof, one above each
seat. You’ll see three bolts on each side. Loosen the
middle one. (The ratchet won’t work for the other
two.) The bolts will stay in the roof panel.
5. Stand on one side of the vehicle and have your
helper stand on the other side. Together,
lift the front
of the panel up. Then move forward and lift the
panel off the vehicle.
2-53
Page 97 of 386
Downloaded from www.Manualslib.com manuals search engine Storing the Roof Panel
1. Open the rear hatch and look for the two brackets in
the rear area. The brackets are below the courtesy
lamps.
2-54
Page 98 of 386
Downloaded from www.Manualslib.com manuals search engine 2. Store the roof panel with its top up and its rear
pointing forward. Slide the rear corners of the roof
panel into the brackets and push forward.
NOTICE:
Don’t lift the front edge of the roof panel higher
than eight inches
(200 mm) when the corners are
in the brackets. If you do, you could damage the roof panel.
3.
4.
5.
6.
Lower the front of the roof panel, centering it over
the latch pin.
Pull the release toward
you and press down on the
roof panel.
Push the release forward until it latches.
Gently lift up on the roof panel to be sure it is locked
in place.
2-55
Page 99 of 386
Downloaded from www.Manualslib.com manuals search engine Installing the Roof Panel 3. Lower the roof panel onto the vehicle, rear edge first,
and place the rear guide pins into the holes in the
roof opening.
4. Lower the front of the roof panel, and align the front
guide pins.
5. Tighten the rear bolts part way.
I
_____~~
NOTICE:
If you tighten bolts that are improperly started,
the threads can become stripped. Be sure all bolts are properly started before you tighten them.
1. Park on a level surface, set the parking brake firmly
and shift an automatic transmission into
PARK (P).
Shift a manual transmission into REVERSE (R).
Lower both windows, turn the ignition key to LOCK
and move both sunshades to the side.
2. If the roof panel is stored in the rear area, remove it
by reversing the steps under “Storing the Roof
Panel” above.
6. Use the ratchet to start the front bolts. If the bolts are
hard to start, tighten the rear bolts some more.
Holding down the panel on the outside will also
help.
7. Fully tighten the rear bolts, then the front bolts.
If you hear a popping noise when you drive, the bolts
may not be tight enough. Be sure to tighten them
securely.
Page 100 of 386
Downloaded from www.Manualslib.com manuals search engine Storage and Compartments
Center Console
You can use the door key to lock and unlock the
console. Don’t leave the key in the lock, or it could be
damaged when the driver sits down.
To use the storage area, push the button on the front end
of the console and lift. Your roof
panel or hardtop wrench
is stored inside the
console.
2-57