CHEVROLET TRACKER 1995 Owner's Manual
Page 21 of 354
Driver Position
This part describes the driver’s restraint system.
Lap-Shoulder Belt
The driver has a lap-shoulder belt. Here’s how to wear it
properly.
1. Close and lock the door.
2. Adjust the seat (to see how, see “Seats” in the Index)
so you can sit up straight.
-
3. Pick up the latch plate and pull the belt across you.
Don’t let it get twisted.
The shoulder belt may lock if you pull the belt across
you very quickly.
If this happens, let the belt go back
slightly to unlock it. Then pull the belt across you
more slowly.
4. Push the latch plate into the buckle until it clicks.
Pull up on the latch plate to make sure it is secure.
If the belt isn’t long enough, see “Safety Belt
Extender” at the end
of this section.
Make sure the release button on the buckle
is
positioned so you would be able to unbuckle the
safety belt quickly if you
ever had to.
1-14
ProCarManuals.com
Page 22 of 354
5. To make the lap part tight, pull down on the buckle
end
of the belt as you pull up on the shoulder belt. The lap part of the
belt should be worn low and snug on
the hips, just touching
the thighs. In a crash, this applies
force to the strong pelvic bones. And you'd be less likely
to slide under the lap belt. If
you slid under it, the belt
would apply force at your abdomen. This cou€d cause
serious or even fatal injuries. The shoulder belt should go
over the shoulder and across the chest. These
parts of the
body are best able to take belt restraining forces.
The safety belt locks if there's a sudden stop or crash, or
if you pull the belt very quickly out of the retractor.
ProCarManuals.com
Page 23 of 354
@ What’s wrong with this?
1 A: The shoulder belt is too loose. It won’t give nearly
as much protection this way.
ProCarManuals.com
Page 24 of 354
What’s wrong with this?
A: The belt is buckled in the wrong place.
ProCarManuals.com
Page 25 of 354
&; What's wrong with this?
L
A: The shoulder belt is worn under the arm. It should
be
worn over the shoulder, at all times.
ProCarManuals.com
Page 26 of 354
@ What’s wrong with this?
A: The belt is twisted across the body.
ProCarManuals.com
Page 27 of 354
Safety Belt Use During Pregnancy
Safety belts work for everyone, including pregnant
women. Like all occupants, they are more likely to be
seriously injured if they don’t wear safety belts.
A pregnant woman should wear a lap-shoulder belt, and
the lap portion should be worn as low
as possible
throughout the pregnancy.
To unlatch the belt, just push the button on the buckle.
The belt should
go back out of the way.
Before you close the door, be sure the belt is out of the
way. If you slam the
door on it, you can damage both the
belt and
your vehicle.
1-20
ProCarManuals.com
Page 28 of 354
The best way to protect the fetus is to protect the
mother. When a safety belt is worn properly, it’s more
likely that the fetus won’t be hurt in a crash. For
pregnant women,
as for anyone, the key to malung
safety belts effective is wearing them properly.
Right Front Passenger Position
The right front passenger’s safety belt works the same
way as the driver’s safety belt. See “Driver Position,”
earlier in this section.
When the shoulder belt is pulled out all the way, it will
lock. If it does, let it
go back all the way and start again
Rear Seat Passengers
It’s very important for rear seat passengers to buckle up!
Accident statistics show that unbelted people in the rear
seat are hurt more often in crashes than those who are
wearing safety belts.
Rear passengers who aren’t safety belted can be thrown
out of the vehicle in a crash. And they can strike others
in the vehicle who are wearing safety belts.
1-21
ProCarManuals.com
Page 29 of 354
Lap-Shoulder Belt
The rear seats have lap-shoulder belts. Here’s how to
wear one properly.
1. Pick up the latch plate and pull the belt across you.
Don’t let it get twisted.
The shoulder belt may lock
if you pull the belt across
you very quickly.
If this happens, let the belt go back
slightly to unlock
it. Then pull the belt across you
more slowly.
2. Push the latch plate into the buckle until it clicks.
Pull up
on the latch plate to make sure it is secure.
When the shoulder belt is pulled out all the way, it
will lock.
If it does, let it go back all the way and
start again. If the belt is not long enough, see “Safety
Belt Extender” at the end
of this section. Make sure
the release button on the buckle is positioned
so you
would be able to unbuckle the safety belt quickly if
you ever had to.
3. To make me lap part tight, pull aown on the buckle
end
of the belt as you pull up on the shoulder part.
1-22
ProCarManuals.com
Page 30 of 354
force to the strong pelvic bones. And you’d be less
likely to slide under the
lap belt. If you slid under it, the
belt would apply force at your abdomen.
This could
cause serious
or even fatal injuries. The shoulder belt
should
go over the shoulder and across the chest. These
parts
of the body are best able to take belt restraining
forces.
The safety belt locks
if there’s a sudden stop or a crash,
or if you pull the belt very quickly out of the retractor.
The lap
part of the belt should be worn low and snug on
the hips, just touching the thighs. In a crash, this applies
ProCarManuals.com