CHEVROLET TRACKER 1996 Owners Manual

Instrument Panel -- Your Information Svstem
2-56
ProCarManuals.com

A. Defroster
B. Rear Defogger (Option)
C. Turn Signal/Multifunction Lever
D. Power Mirror Control (Option)
E. Air Vent
E Instrument Panel Brightness Control
G. Hazard Switch
H. Fuse Block
I. Instrument Cluster
J. Ignition Switch
K. Horn
L. Windshield Wipermasher Lever
M. Cruise Control ON/OFF Button (Option)
N. Rear Window Wiper Button (Option)
0. Rear Window Washer Button (Option)
P. Comfort Controls
Q. Cigarette Lighter
R. Shift Lever
S. Parking Brake Lever
T. Coinholder/Bin
U. Audio System
V. Transfer Case Shift Lever
W. Ashtray
X. Glove Box
2-57
ProCarManuals.com

Instrument Panel Cluster
Your instrument cluster is designed to let you know at a glance how your vehicle is running. You’ll how how fast you’re
going, about how much fuel you have left, and many other things you’ll need to know to drive safely and economically.
2-58
ProCarManuals.com

Speedometer and Odometer
Your speedometer lets you see your speed in both miles
per hour (mph) and kilometers per hour
(h/h). Your
odometer shows how
far your vehicle has been driven,
in either miles (used in the United States) or kilometers
(used
in Canada).
Your Geo’s odometer is tamper-resistant.
If you can see
silver lines between the numbers, someone probably
has
tried to turn it back. The numbers may not be true.
You may wonder what happens
if your vehicle needs a
new odometer installed.
If possible, the new one is to be
set to the same reading
as the old one. If it can’t be, then
it’s set at zero. Then a label is attached on the driver’s
door to
show the old reading and when the new one
was installed.
Trip Odometer
The trip odometer can tell you how far your vehicle has
been driven since you last set the trip odometer to zero.
To set the trip odometer to zero, press the knob.
Tachometer
I
=2
xl OOOrpm
The tachometer shows
engine speed in thousands
of revolutions per minute
(rpm). You can use it while
driving
to select correct
shift points. The tachometer
may not return to zero when
the engine is not running.
I NOTICE: I
Do not operate the engine with the tachometer in
the red area, or engine damage may occur.
2-59
ProCarManuals.com

Warning Lights, Gages and Indicators
This part describes the warning lights and gages that
may be on your vehicle. The pictures will help you
locate them.
Warning lights and gages can signal that something is
wrong before it becomes serious enough to cause an
expensive repair or replacement. Paying attention to
your warning lights and gages could also save you or
others from injury.
Warning lights come on when there may be or is a
problem with one of your vehicle’s functions. As you
will see in the details on the next few pages, some
warning lights come on briefly when
you start the
engine just
to let you know they’re working. If you are
familiar with this section, you should not be alarmed
when this happens.
Gages can indicate when there may be or is a problem
with
one of your vehicle’s functions. Often gages and
warning lights work together to let you know when
there’s
a problem with your vehicle. When
one of the warning lights comes
on and stays on
when you
are driving, or when one of the gages shows
there may be a problem, check the section that tells YOU
what to do about it. Please follow this manual’s advice.
Waiting to
do repairs can be costly -- and even
dangerous.
So please get to know your warning lights
and gages. They’re a big help.
Safety Belt Reminder Light
When the key is turned to
ON or STAFtT, a light will
come on for about eight
seconds to remind people to
fasten their safety belts.
Unless the driver’s safety
belt is already buckled, a
chime will also sound.
2-60
ProCarManuals.com

Air Bag Readiness Light
There is an air bag readiness light on the instrument
panel, which shows AIR
BAG. The system checks the
air bag’s electrical system for malfunctions. The light
tells you if there is an electrical problem. The system
check includes the air bag sensors, the air bag modules,
the wiring and the crash sensing and diagnostic module.
For more information on the air bag system, see “Air
Bag” in the Index.
AIR
BAG
You will see this light flash
for a few seconds when you
turn your ignition to
ON or
START. Then the light
should go out. This means
the system is ready.
If the
air bag readiness light doesn’t come on when you
start your vehicle, or stays on, or comes on when you
are driving, your
air bag system may not work properly.
Have your vehicle serviced right away.
Charging System Light
This light will come on
briefly when you turn on the
ignition, but the engine is
not running, as a check to
show you it is working.
Then it should go out when
the engine starts.
If the light stays
on or comes on while you are driving,
you
may have a problem with the electrical charging
system. It could indicate that you have a loose generator
drive belt
or another electrical problem. Have it checked
right away. Driving while this light
is on could drain
your battery.
If you must drive a short distance with this light on, be
certain to
turn off all your accessories, such as the radio
and air conditioner.
2-61
ProCarManuals.com

Brake System Warning Light
Your Geo’s hydraulic brake system is divided into two
parts.
Xf one part isn’t working, the other part can still
work and stop you. For good braking, though, you need
both parts workmg well.
If the warning light comes on, there could be a brake
problem. Have your brake system inspected right away.
If the light comes on while you are driving, pull off the
road and stop carefully.
You may notice that the pedal is
harder to push. Or, the pedal may go closer to the flow.
It may take longer to stop. If the light is still on, or if the
anti-lock brake system warning light is flashing, have
the vehicle towed for service. (See “Anti-Lock Brake
System Warning Light” and
“Towing Your Vehicle”
in the
Index.)
BRAKE
United States Canada
This light should come on when you turn the ignition
key to
STAFtT. If it doesn’t corne on then, have it fixed
so it will be ready to warn you if there’s a problem.
I
/i CAUTION:
---
Your brake system may not working properly
if the brake system warning light is on. Driving
with the brake system warning light on can lead
to an accident. If the light is still on or if the
anti-lock
brake system warning light is flashing
after you’ve pulled
off the road and stopped
carefully, have the vehicle towed
for service.
When the ignition is on, the brake system warning light
will also come on when you set your parking brake. The
light will stay on if your parking brake doesn’t release
fully. If it stays on after your parking brake is fully
released, it means you have
a brake problem.
2-62
ProCarManuals.com

Anti-Lock Brake System Warning
Light (Option)
ABS
With the anti-lock brake
system, this light will come
on when you start your
engine and it will stay
on for three seconds.
That’s normal.
If the light flashes when you’re driving, you don’t have
anti-lock brakes and there could be a problem with your
regular brakes. Pull off the road and stop carefully.
You
may notice that the pedal is harder to push. Or, the pedal
may go closer to the floor. It may take longer to stop.
Have the vehicle towed for service. (See
“Towing Your
Vehicle” in the Index.)
Your regular brake system may not be working
properly if the anti-lock brake system warning light
is flashing. Driving with the anti-lock brake system
warning light flashing
can lead to an accident. After
you’ve pulled
off the road and stopped caremy,
have the vehicle towed for service.
If the anti-lock brake system warning light stays on
longer than normal after you’ve started your engine, turn
the ignition
off. Or, if the light comes on and stays on
when you’re driving, stop as soon as possible and
turn
the ignition off. Then start the engine again to reset the
system.
If the light still stays on, or comes on again
while you’re driving, your Geo needs service. If the
light
is on but not flashing and the regular brake system
warning light isn’t on,
you still have brakes, but you
don’t have anti-lock brakes.
The anti-lock brake system warning light should come
on briefly when you turn the ignitiorrkey to ON- If the
light doesn’t come on then, have it fixed so it will-be
ready to warn you
if there is a problem.
2-63
ProCarManuals.com

Anti-Lock Brake’ System Active
Light (Option)
ABS
ACTIVE
When your anti-lock system
is adjusting brake pressure
to help avoid
a braking skid,
the
anti-lock brake system
active light will
come on.
Engine Coolant Temperature Gage
This gage shows the engine
coolant temperature. If the
gage pointer
moves to the
H (red) side, your engine is
I/
Slippery road conditions may exist if this light comes
on, so adjust your driving accordingly. The light will
stay on for a few seconds after the system stops
adjusting brake pressure. It
means that your engine coolant
has overheated and
you should stop your vehicle and turn off the engine as
soon as possible.
In “Problems on the Road,” this manual shows what to
do. See
“Engine Overheating” in the Index.
The anti-lock brake system active light also comes on
briefly when you turn the ignition key to ON. If the light
doesn’t come on then, have it fixed so it will be there to
tell you when the system is active.
2-64
ProCarManuals.com

Malfunction Indicator Lamp
(Service Engine Soon Light)
SERVICE
ENGINE
SOON
Your Geo is equipped with
a computer which monitors
operation of the fuel,
ignition and emission
control systems.
This system is called OBD I1 (On-Board
Diagnostics-Second Generation) and is intended
to
assure that emissions are at acceptable levels for
the life
of the vehicle, helping to produce a cleaner
environment.
(In Canada, OBD I1 is replaced by
Enhanced Diagnostics.) The SERVICE ENGINE
SOON
light comes on to indicate that there is a problem and
service
is required. Malfunctions often will be indicated
by the system before any problem is apparent, which
may prevent more serious damage to your vehicle. This
system is also designed to assist your service technician
in correctly diagnosing any malfunction.
NOTICE:
If you keep driving your vehicle with this light
on, after
a while, your emission controls may not
work as well, your fuel economy may not be as
good and your engine may not run as smoothly.
This could lead to costly repairs that may not be
covered
by your warranty.
This light should come on, as a check to show you it is
working, when the ignition is on and the engine
is not
running.
If the light doesn’t come on, have it repaired.
This light will also come on during a malfunction in one
of two ways:
0 Light Flashing -- A misfire condition has been
detected, A misfire increases vehicle emissions and
may damage the emission tontrol system on your
vehicle. Dealer or qualified service center diagnosis and service is required.
0 Light On Steady -- An emission control system
malfunction has been detected
on your vehicIe.
Dealer or qualified service center diagnosis and
service may be required.
2-65
ProCarManuals.com