CHRYSLER PT CRUISER 2008 1.G Owners Manual

INTEGRATED POWER MODULE (IPM)An Integrated Power Module is located in the engine
compartment near the air cleaner assembly. This center
contains cartridge fuses and mini fuses. A description of
each fuse and component may be stamped on the inside
of the cover.
INTEGRATED POWER MODULE (IPM)
Cavity Cartridge
Fuse Mini Fuse Description
1 40 Amp
Green Power Top
Feed —
Convertible
Only
2 20 Amp Yel-
lowAWD ECU
Feed
3 10 Amp RedCHMSL
Brake
Switch Feed
4 10 Amp RedIgnition
Switch Feed
5 20 Amp Yel-
lowTrailer Tow
Integrated Power Module Location
MAINTAINING YOUR VEHICLE 419
7

INTEGRATED POWER MODULE (IPM)
Cavity Cartridge
Fuse Mini Fuse Description
6 10 Amp Red IOD Sw/
Pwr Mir/
Ocm Steer-
ing Cntrl
Sdar/Hfm
7 30 Amp
GreenIOD Sense1
8 30 Amp
GreenIOD Sense2
9 40 Amp
Green Power Seats
10 20 Amp Yel-
lowCCN,
Power
Locks
11 15 Amp Lt
BluePower Out-
let
INTEGRATED POWER MODULE (IPM)
Cavity Cartridge
Fuse Mini Fuse Description
12 20 Amp Yel-
lowIgn Run/
Acc Inverter
13 20 Amp Yel-
lowPwr run/
Acc Outlet
RR
14 10 Amp RedIOD CCN/
Interior
Lighting
15 50 Amp Red RAD Fan
Relay Bat-
tery Feed
16 15 Amp Lt.
BlueIGN Run/
Acc Cigar
Ltr/Sunroof
420 MAINTAINING YOUR VEHICLE

INTEGRATED POWER MODULE (IPM)
Cavity Cartridge
Fuse Mini Fuse Description
17 10 Amp Red IOD Feed
CVT Mod/
Mod_Wcm
18 40 Amp
Green ASD Relay
Contact
PWR Feed
19 20 Amp
YelowPWR Amp
1 & Amp 2
Feed
20 15 Amp Lt.
BlueIOD Feed
Radio
21 10 Amp RedIOD Feed
Intrus
Mod/Siren
INTEGRATED POWER MODULE (IPM)
Cavity Cartridge
Fuse Mini Fuse Description
22 10 Amp Red IGN RUN
Hvac/
Compass
Sensor
23 15 Amp Lt.
BlueENG ASD
Relay Feed
3
24 25 Amp
NaturalPWR Sun-
roof Feed
25 10 Amp RedHeated Mir-
ror
26 15 Amp Lt.
BlueENG ASD
Relay Feed
2
MAINTAINING YOUR VEHICLE 421
7

INTEGRATED POWER MODULE (IPM)
Cavity Cartridge
Fuse Mini Fuse Description
27 10 Amp Red IGN RUN
Only ORC
Feed
28 10 Amp Red IGN RUN
ORC/OCM
Feed
29 EMPTY
30 20 Amp Yel-
lowHeated
Seats
31 10 Amp RedHeadlamp
Washer Re-
lay Control
32 30 Amp
Pink ENG ASD
Control
Feed 1
INTEGRATED POWER MODULE (IPM)
Cavity Cartridge
Fuse Mini Fuse Description
33 10 Amp Red ABS MOD/
J1962
Conn/PCM
34 30 Amp
Pink ABS Valve
Feed
35 40 Amp
Green ABS Pump
Feed
36 30 Amp
Pink Headlamp
Washer
Control
37 25 Amp
NaturalSpare
422 MAINTAINING YOUR VEHICLE

CAUTION!
•
When installing the Integrated Power Module
cover, it is important to ensure the cover is prop-
erly positioned and fully latched. Failure to do so
may allow water to get into the Integrated Power
Module, and possibly result in a electrical system
failure.
•
When replacing a blown fuse, it is important to
use only a fuse having the correct amperage rating.
The use of a fuse with a rating other than indicated
may result in a dangerous electrical system over-
load. If a properly rated fuse continues to blow, it
indicates a problem in the circuit that must be
corrected.
VEHICLE STORAGEIf you will not be using your vehicle for more than 21
days, you may want to take steps to preserve your
battery. You may:•
Disengage the mini-fuse in the Power Distribution
Center labeled IOD (Ignition Off-Draw).
•
Or, disconnect the negative cable from the battery.
MAINTAINING YOUR VEHICLE 423
7

REPLACEMENT BULBSLIGHT BULBS — InsideBulb No.
Center Console Floor Lamp ................. T37
Climate Controls ...................... 6233137
Console Gear Selector ................... PC194
Dome Light (sedan) ...................... T579
Dome Light / Sport Bar Lights (convertible) ....T904
Instrument Cluster Illumination .............. 74
Overhead Reading Light (Overhead Console) . . . T1037
Overhead Reading Light (Rearview Mirror) .....T192
Rear Cargo ............................ T906
Visor Vanity ......................... 6501966
All the inside bulbs are brass or glass wedge base.
Aluminum base bulbs are not approved and should not
be used for replacement. LIGHTS BULBS — Outside
Bulb No.
Low Beam Headlight ................... 9006XS
High Beam Headlight ................... 9005XS
Front Park/Turn Signal/Side Marker
Light ............................ 4157NAKX
Front Fog Light ......................... 9145
Center High Mounted Stop Light
(CHMSL) (Sedan) ................... 921–W16W
Center High Mounted Stop Light
(CHMSL) (Convertible) .................... LED
Rear Tail/Stop .......................... 3157
Rear Turn Signal ....................... 3757A
Backup Light ..................... 3157-P27/7W
License Light ........................... 168424 MAINTAINING YOUR VEHICLE

BULB REPLACEMENT
Headlights
CAUTION!
Do not touch the new headlight bulb with your
fingers. Oil contamination will severely shorten bulb
life.
1. Remove the headlight access cover splash shield,
located in the front wheel well opening.
2. Disconnect the electrical connector. 3. Rotate the socket to the left one quarter turn and
replace the bulb.
MAINTAINING YOUR VEHICLE 425
7

Front Park/Turn Signal/Side Marker Lights1. Remove the headlight access cover splash shield,
located in the front wheel well opening.
2. Rotate the socket to the left one quarter turn to replace
and replace the bulb.
Front Fog Lights — If Equipped1. Remove the fasteners attaching the lower splash
shield to gain access to the fog light.
2. Twist and remove the bulb from the fog light housing.
3. Disconnect the electrical connector and replace bulb.
426 MAINTAINING YOUR VEHICLE

Tail/Stop, and Rear Turn Signal Lights1. Remove the screw attaching the tail light housing and
remove the housing from the vehicle.
2. Twist the bulb socket 1/4 turn to remove it from the
housing.3. Pull the bulb out of the socket and replace.
Back Up Lights
Removing Backup Light Bulbs
MAINTAINING YOUR VEHICLE 427
7

1. To remove the backup lamp, you must take a fiber
stick and slide it along the inboard side of the lamp and
compress a spring clip to allow it to partiallypopout to
the secondary catch.
2. Fully compress the clip to get the lamp to come out
completely.
3. Remove the socket from the housing.
4. Pull the bulb out of the socket and replace.
Center High Mounted Stop Light1. Open the liftgate and remove the liftgate CHMSL
cover.
2. Remove CHMSL lens from the housing by unlatching
the two side latches.
3. Pull the bulb out of the socket and replace.
428 MAINTAINING YOUR VEHICLE