Citroen BERLINGO FIRST DAG RHD 2009 1.G Owner's Manual

Page 101 of 123

97PRACTICAL INFORMATION-

Fuse N° Rating Functions

1 10 A Pre-heat unit (diesel) - Brake and clutch switches -
Reversing lights.

2 15 A Fuel pump.

3 10 A ABS control unit.

4 10 A Engine control unit.

5 - Not used.

6 15 A Front fog lamps.

7 20 A Headlamp wash pump.

8 20 A Fan assembly relay - Engine control unit.

9 15 A Left-hand dipped beam.

10 15 A Right-hand dipped beam.

11 10 A Left-hand main beam.

12 10 A Right-hand main beam.

13 15 A Horn.

14 10 A Front and rear windscreen wash pumps.

15 30 A Oxygen sensor - Air fl ow sensor.

16 30 A Air pump relay.

17 30 A Front windscreen wiper.

18 40 A Air conditioning fan.
Engine compartment fuse box
To gain access to the box in the en-
gine compartment (next to the bat-
tery), unclip the cover.
After carrying out work, close the
cover very carefully.

Page 102 of 123

PRACTICAL INFORMATION98 -
ECONOMY MODE FUNCTION
After the engine has stopped, with
the key in the "accessories" position,
certain functions (windscreen wiper,
electric windows, courtesy lights,
audio equipment, etc.) can only be
used for a combined duration of ap-
proximately thirty minutes, to prevent
discharging the battery.
Once the thirty minutes are over, a
switching to economy mode mes-
sage appears on the multi-function
display and the active functions are
put on standby.
These functions are reactivated au-
tomatically next time the vehicle is
driven.
In order to resume the use of these
functions immediately, the engine
must be started and left to run for a
few minutes.
The time available to you will then be
double the duration for which the en-
gine is left running. However, this pe-
riod will always be between fi ve and
thirty minutes.
BATTERY

It is advisable to disconnect the
battery if the vehicle is not to be
used for a period of more than
one month.
Before disconnecting the bat-
tery, you must wait 2 minutes
after switching off the igni-
tion.
Never disconnect a terminal when
the engine is running.
Never charge a battery without fi rst
disconnecting the terminals.
Close the windows and the roof be-
fore disconnecting the battery.
After every reconnection of the bat-
tery, switch on the ignition and wait
1 minute before starting to allow the
electronic systems to be initialised. If
slight diffi culties are experienced af-
ter this, please contact a CITROËN
dealer. A fl at battery prevents the
engine from starting.
To start the vehicle from
another battery:
- Connect the red cable to the posi-
tive (+) terminals of the two bat-
teries,
- Connect one end of the green or black cable to the negative (-) ter-
minal of the slave battery,
- Connect the other end of the green or black cable to an earth
point on the broken down vehicle
as far as possible from the bat-
tery (for example, right-hand en-
gine mounting).
Operate the starter, let the engine run.
Wait for the engine to return to idle,
then disconnect the cables.
To charge the battery using a
battery charger:
- Disconnect the battery,
- Follow the instructions for use
given by the battery charger man-
ufacturer,
- Reconnect starting with the nega- tive (-) terminal,
- Check that the terminals and connectors are clean. If they are
covered with sulphate (white or
greenish deposit), disconnect
them and clean them.

Page 103 of 123

99PRACTICAL INFORMATION-
Making the connections
A1: -
A2: - Digital control (manufacturer)
A3: - Digital control (manufacturer)
A4: - Audio equipment multiplexing (manufacturer)
A5: -
A6: (+ve) Accessories
A7: (+ve) Permanent
A8: (-ve) Earth
B1: (+)
B2: (-)
B3: (+) Front right speaker and tweeter
B4: (-) Front right speaker and tweeter

B5: (+) Front left speaker and tweeter
B6: (-) Front left speaker and tweeter

B7: (+)
B8: (-)
FITTING SPEAKERS
The factory-fi tted equipment allows
the fi tting of:
- 35 mm diameter tweeters in the fascia,
- 165 mm diameter speakers in the front doors.
FITTING AUDIO EQUIPMENT
Your vehicle is equipped with certain
factory-fi tted audio equipment:
- roof aerial,
- coaxial aerial cable,
- basic interference suppression,
- supply to front speakers and tweeters,
- two 8-way connectors.
Contact a CITROËN dealer
before fi tting audio equip-
ment or speakers in your ve-
hicle.

Page 104 of 123

PRACTICAL INFORMATION100 -
SNOW SCREEN *
The snow screen is installed on the
lower part of the front bumper to pre-
vent the accumulation of snow at the
radiator cooling fan.
Remove the snow screen:
- when the exterior temperature is higher than 10 °C,
- when towing,
- for speeds higher than 75 mph (120 km/h).
FITTING

 Offer up the snow screen facing
the front bumper.

 Put it in place positioning the low-
er clips A in the bumper.

 Press the snow screen at each
upper clip B .
REMOVAL

 Press the two upper clips B and
pull the snow screen.
*
As an accessory or according to country.

Page 105 of 123

101PRACTICAL INFORMATION-
Without lifting (four wheels on
the ground)
You must always use a towbar. By lifting (two wheels only on
the ground)
It is preferable to lift the vehicle by
the wheels.
TOWING YOUR VEHICLE
From the front or the rear
Attach the towbar to the towing eye. Never use the radiator cross-
member.
When towing another vehicle,
it must freewheel.
Place the gearbox in "neutral".
Failure to observe this instruction
may result in damage to certain brak-
ing components and the absence of
braking assistance when the engine
is started again.

Page 106 of 123

PRACTICAL INFORMATION102 -
TOWING A TRAILER, CARAVAN, BOAT, ETC.
We recommend the use of original
CITROËN towbars and their har-
nesses that have been tested and ap-
proved from the design stage of your
vehicle and that the fi tting of the towbar
is entrusted to a CITROËN dealer.
If the towbar is not fi tted by a CITROËN
dealer, it is imperative that it is fi tted
using the electrical pre-equipment
installed at the rear of the vehicle, in
accordance with the manufacturer's
instructions.
Your vehicle is primarily designed for
transporting people and luggage but it
may also be used for towing a trailer.
Driving with a trailer subjects the tow-
ing vehicle to more signifi cant stress
and its driver must be particularly
careful.
Air density decreases with altitude,
thus reducing engine performance.
Above 1 000 metres, the maximum
towing load must be reduced by 10 %
and so on for every 1 000 metres of
altitude. Driving advice
Tyres: Check the tyre pressures of
the towing vehicle and of the trailer,
observing the recommended pres-
sures.


Braking: Towing increases the brak-
ing distance.

Lights: Check the electrical signalling
on the trailer.

Side wind: Take into account the
increased sensitivity to side wind.

Cooling: Towing a trailer on a slope
increases the temperature of the
coolant.
As the fan is electrically controlled,
its cooling capacity is not dependent
on the engine speed.
On the contrary, use a high gear to
lower the engine speed and reduce
your speed.
The maximum towing load on a long
slope depends on the gradient and
the outside temperature.
In all cases, pay attention to the coolant
temperature.
In certain cases of particularly arduous
use (towing the maximum load on a
steep gradient in high temperatures),
switching off the air conditioning per-
mits the recovery of engine power
and therefore an increase in the tow-
ing capacity.
If the warning light comes on, stop
the vehicle and switch off the engine
as soon as possible.

Distribution of loads: Distribute the
load in the trailer so that the heaviest
items are as close as possible to the
axle and the nose weight approaches
the maximum permitted without ex-
ceeding it.

Page 107 of 123

103PRACTICAL INFORMATION-
ACCESSORIES
These accessories and parts, hav-
ing been tested and approved for
reliability and safety, are all adapted
to your vehicle. A wide range of rec-
ommended accessories and original
parts is offered. The fi tting of electrical equip-
ment or accessories which
are not recommended by
Automobiles CITROËN may
result in the failure of your vehicle's
electronic system. Please note this
specifi c warning. You are advised
to contact a representative of the
Marque to be shown the range of
recommended equipment and ac-
cessories.
Depending on the country in which
the vehicle is sold or operated, it is
compulsory to have a high visibility
safety jacket, warning triangle and
replacement bulbs available in the
vehicle.
Screenwash, interior and exterior
cleaning and maintenance products,
replacement bulbs, ...
Anti-theft alarm, window engraving,
fi rst aid kit, high visibility safety jack-
et, rear parking assistance, warning
triangle, ...
Audio equipment, hands-free kit,
speakers, CD changer, navigation, ...
Regardless of the audio and telemat-
ic equipment offered on the market,
the technical constraints linked with
the fi tting of equipment of these fami-
lies of products mean that the spe-
cial features of the equipment and
its compatibility with the capacities
of the your vehicle's standard equip-
ment must be taken into account.
Please contact a CITROËN dealer
for information before fi tting such
equipment. Front mud fl aps, rear mud fl aps,
15/17 inch alloy wheels, wheelarch
trim, leather steering wheel, ...
Range of professional equipment
Load retainers (all models).
Loading roller.
Towbar, towbar harness: trailer
towbar which must be fi tted by the
CITROËN network. Separation partitions and grilles,
smooth, non-slip wooden protective
fl oor.

Protective grilles. Installation of
radiocommunication transmitters
Before installing accessory radio-
communication transmitters with an
external aerial on your vehicle, you
are advised to contact a representa-
tive of the CITROËN marque.
The CITROËN Network will inform
you of the specifi cations (frequency
band, maximum output power, aerial
position, specifi c installation condi-
tions) of the transmitters which can be
fi tted, in accordance with the Motor
Vehicle Electromagnetic Compatibility
Directive (2004/104/CE).
Range of comfort, leisure and
maintenance equipment Front seat covers compatible with
air bags, bench, rubber mats, car-
pet mats, snow chains, blind, tailgate
bicycle carrier, roof bars (max load
120 kg), transverse roof bars (max
load 100 kg), ...
To prevent the mat from becoming
caught under the pedals:
- ensure that the mat and its fi xings
are positioned correctly,
-
never fi t one mat on top of another.

Page 108 of 123

TECHNICAL DATA104 -
EXTERIOR DIMENSIONS (IN MM)

Page 109 of 123

105TECHNICAL DATA-
Light van Ludospace

L1 4 137

L2 4 437

H 1 796 to 1 819 1 810


A 2 693

B 836

C 608

D 570 550

E 1 440 1 440 or 1 452

F 1 960

G 1 420 1 420 or 1 436

I 1 724

Page 110 of 123

TECHNICAL DATA106 -
INTERIOR DIMENSIONS (IN MM) AND VOLUMES (IN M3) LIGHT VAN

L1 L2

J 1 155

K 1 320

M 1 190

N 1 190

O 568

P 1 340 1 640

m 3
3.25 3.6

Page:   < prev 1-10 ... 61-70 71-80 81-90 91-100 101-110 111-120 121-130 next >