Citroen C ZERO 2011 1.G Owner's Guide
Page 31 of 164
1
Monitoring
29
Service indicator
When the ignition is switched on, press
button A
several times in succession until
the ser vice indicator is displayed in the desired
units.
This point can be indicated in one of two ways:
- the miles (km) remaining,
- the time remaining to the next ser vice.
Operation
1.
The screen indicates that 620 miles
(1 000 km) or 1 month remain before
the next service.
2.
The screen indicates that the date for
the ser vice has been exceeded.
Every time the ignition is switched on,
the ser vice spanner is displayed for a
few seconds to remind you that a ser vice
should be carried out as soon as possible.
3.
Once the ser vice has been carried out,
the distance or the number of months to
the next ser vice is displayed again.
System which informs the driver when
the next ser vice is due in accordance with
the manufacturer's ser vicing schedule.
The point at which the next ser vice is due
is calculated from the last ser vice indicator
zero reset.
System for manual adjustment of the brightness
of the instruments and controls in relation to
the exterior brightness.
With the lighting on or off, press button A
to
select the function, then hold down to change
the intensity of the lighting of the instruments
and controls in "day" or "night" mode.
The intensity of the lighting increases each time
button A
is pressed.
When the lighting reaches the maximum
setting, press again to change to the minimum
setting.
When the lighting reaches the required
intensity, release button A
.
The setting is saved when you release button A
and retained when the ignition is turned OFF.
Lighting dimmer
Page 32 of 164
i
i
i
Monitoring
30
This function gives an estimate of the number
of miles (km) that your vehicle can still cover,
based on the recent conditions of use (driving
style, use of heating, air conditioning...).
Range indicator
When the remaining range falls to a low level,
"- - -"
is displayed in the instrument panel.
The display of "---"
, indicating that
the ser vice date has arrived, comes on
automatically after a cer tain time and
distance travelled. The screen then
indicates the time remaining before
the next ser vice is due.
Resetting the service indicator to zero
After each ser vice, the ser vice indicator should
be rest to zero.
The procedures is as follows:
)
Switch off the ignition (switch in the LOCK
or ACC position).
)
Press the reset button A
several times in
succession until the ser vice indicator is
displayed.
)
Press and hold the reset button for a few
seconds until the spanner flashes
.
)
Press the reset button while the spanner is
flashing to change the display from "---"
to
"CLEAR"
.
The distance (or time) remaining before
the next ser vice is due is displayed. The range can be displayed in miles or
kilometres.
To change the units, refer to the
"Distance recorder" section.
Page 33 of 164
2
i
!
Access
31
System which permits central unlocking or locking of the vehicle using the door lock or from a distance. It is also used to start the vehicle, as well as
providing protection against theft.
Remote control key
Unlocking the vehicle
Unfolding the key
)
First press button A
to unfold the key.
Unlocking using the remote
control
)
Press the open padlock to unlock
the vehicle.
Locking the vehicle
Unlocking is confirmed by the interior lighting
which comes on for approximately 15 seconds
and the direction indicators which flash twice
.
The door mirrors unfold at the same time.
Unlocking using the key
)
Turn the key to the right in the driver's
door
lock to unlock the vehicle.
Locking is confirmed by the interior lighting,
which comes on for about 15 seconds and
the direction indicators, which flash twice
.
On the other hand, the door mirrors are not
unfolded (see § "door mirrors").
Normal locking using the remote
control
)
Press the closed padlock to lock
the vehicle.
Locking is confirmed by the direction indicators
which come on once
.
The door mirrors unfold at the same time.
Normal locking using the key
)
Turn the key to the left in the driver's door
lock to lock the vehicle.
Locking is confirmed by the direction indicators,
which flash once
.
On the other hand, the door mirrors are not
unfolded (see § "door mirrors").
The vehicle will lock itself again
automatically after thir ty seconds
unless a door or the boot is opened.
This function avoids inadvertent
unlocking.
The passenger's door lock barrel does
not lock or unlock the other doors and
the boot.
Page 34 of 164
Access
32
Folding the key
Anti-theft protection
)
First press button A
to fold the key.
Electronic engine immobiliser
The key contains an electronic chip which has a
special code. When the ignition is switched on,
this code must be recognised to permit star ting.
This electronic engine immobiliser locks the
engine management system a few moments
after the ignition is switched off and prevents
star ting of the engine by anyone who does not
have the key.
In the event of a malfunction and if your vehicle
does not start, contact a CITROËN dealer as
soon as possible.
Remote control problem
In the event of a remote control malfunction,
you can neither unlock nor lock your vehicle.
)
First of all, use the key in the driver's door
lock to unlock or lock your vehicle.
)
Then, contact a CITROËN dealer to check
the operation of the remote control and
replace the battery if necessary.
Page 35 of 164
2
!
Access
33
Lost keys
Visit a CITROËN dealer with the vehicle's V5 registration document and your personal
identification documents.
The CITROËN dealer will be able to retrieve the key code and the transponder code
required to order a replacement key.
Remote control
The high frequency remote control is a sensitive system; do not operate it while it is in your
pocket as there is a possibility that it may unlock the vehicle, without you being aware of it.
Do not repeatedly press the buttons of your remote control out of range and out of sight of
your vehicle. You run the risk of stopping it from working.
The remote control does not operate when the key is in the ignition, even when the ignition
is switched off.
Locking the vehicle
Driving with the doors locked may make access to the passenger compar tment by
the emergency services more difficult in an emergency.
As a safety precaution (with children on board), remove the key from the ignition when you
leave the vehicle, even for a shor t time.
Anti-theft protection
Do not make any modifications to the electronic immobiliser system; this could cause
malfunctions.
When purchasing a second-hand vehicle
Have the key codes memorised by a CITROËN dealer, to ensure that the keys in your
possession are the only ones which can star t the vehicle.
Page 36 of 164
i
!
Access
34
1.
Driver's electric window switch.
2.
Passenger's electric window switch.
3.
Rear right electric window switch.
4.
Rear left electric window switch.
5.
Deactivating the passenger and rear
electric window switches.
Electric windows
Operation
Deactivating the passenger and
rear electric window switches
)
For the safety of your children, press switch 5
to prevent operation of the passenger and rear
electric windows irrespective of their position.
When the button is pressed down, the switches
are deactivated.
When the button is raised, the switches are activated.
System which opens or closes a window manually or automatically. It is fitted with a deactivation system to prevent misuse of the rear controls.
The electric window switches
remain operational for approximately
30 seconds after the ignition is
switched off.
The windows can no longer be opened
or closed after the driver's door is
closed. With the ignition on:
)
Press the switch gently to open or pull it
gently to close. The window stops as soon
as the switch is released.
- Automatic one-touch mode
(driver's side)
)
Press the switch fully to open. The
driver's window opens completely when
the switch is released.
)
Pressing the switch again stops the
movement of the window.
Always remove the key from the ignition when leaving the vehicle, even for a
shor t time.
In the event of contact during operation
of the windows, you must reverse the
movement of the window. To do this,
press the switch concerned.
When the driver operates the passenger electric window switches, they must
ensure that no one is preventing correct
closing of the windows.
The driver must ensure that passengers
use the electric windows correctly.
Be aware of children when operating
the windows.
Page 37 of 164
2
!
Access
35
Doors
From outside
)
After unlocking the vehicle using the
remote control or the key, pull the door
handle.
From inside
)
Pull the front or rear door control to open
the door.
If the doors are locked, opening the driver's
door does not unlock the other doors.
- opening the driver's door unlocks the other
doors,
- the front passenger or rear doors must
then be unlocked manually using the front
locking control before they can be opened.
If a door or the boot is not closed
correctly, this warning lamp comes
on in the instrument panel until the
door in question or the boot is closed.
Opening
Closing
Locking/unlocking from
the inside
)
Press the button on the driver's door
towards the front to lock and towards the
rear to unlock the vehicle completely.
The buttons on the front and rear
passenger doors only lock /unlock the
door in question.
Page 38 of 164
Access
36
Boot
Opening
)
After unlocking the vehicle using the remote
control or the key, press the handle A
and
open the tailgate.
)
Pull the handle B
downwards to guide the
tailgate down,
)
release the handle and press the exterior
sur face of the tailgate gently to close it.
Closing
Page 39 of 164
2
i
Access
37
Charging fl aps
)
Pull control A
locate at the bottom of the
dashboard, driver's side, to release the
charging flap,
)
open the flap on the right of the vehicle,
)
press latch B
to open the socket cover.
Normal charging
)
Pull control C
located alongside the driver’s
seat, outer side, to release the flap,
)
open the flap on the left of the vehicle,
)
press latch D
to open the socket cover.
Fast charging
For more information on charging
procedures, refer to the "Practical
information" section of this document.
Page 40 of 164
Comfort
38
Front seats
Manual adjustments
1.
Adjustable head restraint
2.
Adjustment of the backrest angle
Operate the control lever and adjust
the position of the backrest to the front or
to the rear.
3.
Adjustment of the driver's seat height
Raise or lower the control lever the number
of times required to obtain the desired
position.
4.
Forwards-backwards adjustment of
the seat position
Lift the control bar and slide the seat
for wards or backwards.