tow bar CITROEN C2 DAG 2007 Owners Manual

1
4
3
2
86
III
R E A R S E A T S
The function 3 is available on all models. The other functions are available depending on the version of your vehicl e.
Fore and aft adjustment
From the boot, it is possible to modify the loadspace by slidi ng the seats.
Push down control 2 and adjust to the desired position.
At the front of the seat, it is also possible to adjust knee room.
Raise the bar located under the seat and adjust to the de sired position (several positions).
Rear head restraints
The rear head restraints have two positions:A stowed position for when the seat is not occupied.A deployed position to provide passenger safety, by raising th em to their locking point.
To raise them, pull them upwards to their maximum height, pressin g the unlocking button.

Foldable backrest
It can be folded either totally or partially.
Lower the head restraint against the backrest, then pivot control 3 towards the rear of the vehicle.
The backrest also has a vertical position to optimise the bootsp ace.
When you reposition the backrest, make sure that it locks in place .
Folded (fully-folded position)
To facilitate this manoeuvre, slide the front seat as far forward as possible, using the fore/aft slide control.
Move the rear seat as far forward as possible using control 2, fold the backrest using control 3, then lift control 4.
The seat goes automatically to the fully-folded position.
Reposition the front seat. The rear seat in the fully-folded position will adapt automatically to the position of the front seat.
When restoring the seat to its original position, check that there is nothing obstructing the anchoring points to ensure that it latches properly.

A
119
V
Roof bars
For your safety and to avoid damage to the roof, you should use roof bars that are tested and approved by AUTO-MOBILES CITROËN for the design of your particular vehicle.For your safety and to avoid damage to the roof, you should use safety and
Recommendations:Spread the load evenly, avoiding overloading on one side.Position the heaviest weight as low down as possible.
Tie the load down securely and add warning signs if it is protruding.
Drive conservatively, as the vehicle will be more vulnerable to si de winds.The stability of your vehicle may be altered.
Remove the roof rack or roof bars when you are not using them.
When you are using a towbar, remove the jack from its stowage i n the spare wheel. Keep the jack to hand in the passenger compartment.





S A F E T Y R E C O M M E N D A T I O N S
Towbar
We recommend you to have this device fi tted by a CITROËN Deale r, who will be acquainted with your vehicle’s tow-ing capability and with the procedures necessary for installing a safety item of this kind.
Dimensions (in metres)
A: 0,71
Do not exceed the maximum permitted load.
For the maximum distributed load on the roof bars: see the chapter “General”.

124
V
T O W I N G – L I F T I N G
Towing with wheels on the ground
Towing eye fi xings are located at the front and at the rear of the vehicle.
To access them:Carefully lift the access cover.
Release it by pressing on the lower part.
A lug keeps the cover attached to the bumper, so that it do es not become lost.
The ignition key must be in position M to retain steering.
Use a bar with attachments to the towing eyes as above.


Movable towing eye
The towing ring is detachable and can be fi tted either at the front or at the rear of the vehicle. It is stowed in the toolkit which is to be found either under one of the front seats or in the repair aerosol kit located in the boot.
When the engine is not running, the steering and the bra king are no longer assisted.
If you are towing another vehicle, the latter must be free-wheeling (gearbox in neutral).
ADVICE
Towing at low speed over a very short distance is authorised in exceptional cases depending on the regulations in force.
Otherwise, it is necessary to have your vehicle transported on a recovery truck.
TOWING REQUIREMENTS
Place the selector on position N (neutral).