roof Citroen C5 2008.5 (RD/TD) / 2.G Owner's Manual

31
1
I N S T R U M E N T S a n d C O N T R O L S
Engine autodiagnostics system If this comes on, it indicates
the occurrence of a fault in
the engine management
system.
If it fl ashes, it indicates the occurrence of
a fault in the emission control system.
Maximum coolant temperature If this comes on, it indicates
that the temperature in the
cooling system is too high.
Stop the vehicle immediately
and as safely as possible.
Check the coolant level.
If the level is low, contact a CITROËN
dealer.
Fuel low
If this comes on, it indicates
that the range remaining
is approximately 30 miles
(50 km).
It may be less than this in certain
driving conditions and depending on
the engine.
The capacity of the tank is approxi-
mately 71 litres. Battery charge
If this comes on, it indi-
cates the occurrence of a
fault in the battery charging
circuit (dirty or loose termi-
nals, slack or cut alternator
belt...).
Seat belt not fastened/
unfastened *
* According to country.
This warning lamp lights
up on the instrument panel
to remind the driver and all
passengers that they must
fasten their seat belt.
It is linked to the seat belt informa-
tion given by the roof console. Seat belt non-fastening/
unfastening
This warning lamp
informs you of the
non-fastening and
unfastening of the
driver and passenger seat belts.
The illuminated positions represent
the passengers whose seat belts
are not fastened/unfastened.
Driver’s seat belt not fastened:
- The warning lamp lights up be- tween 0 and 12 mph (20 km/h).
Above 12 mph, it fl ashes ac-
companied by a sound signal for
around 120 seconds.
Front and rear passenger seat belts
not fastened:
- When the ignition is switched on, the points corresponding to
the seat positions with seat belts
not fastened remain lit up for
30 seconds.
Seat belts unfastened during the
journey:
- The point corresponding to the seat position with seat belt un-
fastened lights up between 0 and
12 mph (20 km/h). Above
12 mph, it fl ashes accompanied
by an audible signal for around
120 seconds. The audible signal
stops when the seat belt is re-
fastened or if a door is opened.

65
4
A C C E S S
Normal locking using the key

 Turn the key to the right in the
driver’s door lock to lock the ve-
hicle completely.
Locking is confi rmed by fi xed light-
ing of the direction indicators for
approximately two seconds and by
switching off of the courtesy lamp.
According to version, the exterior
mirrors fold at the same time. If one of the doors, the rear screen
or the boot is still open, the central
locking does not take place.
When the vehicle is locked, if it is
unlocked inadvertently, it will relock
automatically after thirty seconds
unless a door is opened.
When stationary with the engine
off, locking is confi rmed by fl ashing
of the interior locking control indi-
cator lamp.
The folding and unfolding of the
exterior mirrors using the remote
control can be deactivated by a
CITROËN dealer.
Deadlocking using the
remote control
 Press the closed pad-
lock to lock the vehicle
completely or press the
closed padlock for more
than two seconds to
close the windows and
sunroof automatically in
addition to locking.

 Press the closed padlock again
within fi ve seconds to deadlock
the vehicle.
Locking the vehicle
Normal locking using the remote
control

 Press the closed pad-
lock to lock the vehicle
completely.

 Press the closed padlock for
more than two seconds to close
the windows and sunroof auto-
matically in addition to locking. Deadlocking using the key

 Turn the key to the right in the
driver's door lock to lock the ve-
hicle completely and hold it in
this position for more than two
seconds to close the windows
automatically in addition to locking.

 Turn the key to the right again
within fi ve seconds to deadlock
the vehicle.
Deadlocking is confi rmed by fi xed
lighting of the direction indicators for
approximately two seconds.
According to version, the exterior
mirrors fold at the same time.
Deadlocking renders the exterior and
interior door controls inoperative.
It also deactivates the manual central
control button.
When stationary with the engine
off, locking is confi rmed by fl ashing
of the indicator lamp on the interior
locking control.
If one of the doors or the boot is open
or has not been closed correctly, the
central locking will not work.
Therefore, never leave anyone inside
the vehicle when it is deadlocked.

79
4
A C C E S S
PANORAMIC SUN ROOF (SALOON)
This sun roof provides optimum light
and visibility in the passenger com-
partment.
Sun roof closed
- Press B to fi rst notch: tilting.
- Press B to second notch: auto-
matic complete tilting.
- Press A to fi rst notch: sliding
towards rear.
- Press A to second notch: auto-
matic total sliding towards rear. Sun roof open
- Press
B to fi rst notch: closure.
- Press B to second notch: auto-
matic total closure.
Always remove the ignition key
when leaving the vehicle, even if
for a short time.
In the event of anything being
caught by the sun roof closing, you
must reverse the roof movement.
To do that, reverse the position of
the control concerned.
When the driver is operating the sun
roof, he or she must always make
sure that the passengers are not
preventing it from closing properly.
The driver must ensure that pas-
sengers use the sun roof control
correctly.
Pay special attention to where children
are when operating the sun roof.
The fi tting of a sun roof as an
accessory is prohibited.
Operation
Tilted sun roof
- Press
A to fi rst notch: closure.
- Press A to second notch: auto-
matic total closure.
Your sun roof is fi tted with a manually-
operated blind.
Anti-pinch
An anti-pinch device stops the sun
roof from closing, whether sliding or
tilting. If it meets an obstacle, it re-
opens. Reinitialisation
After a battery disconnection or if
there has been a malfunction, you
have to re-initialise the anti-pinch
function.

 move control B until the roof is in
the complete tilting position,

 keep control B pressed down for
a minimum of 1 second.

During these operations, the anti-
pinch function does not operate.

80
4
A C C E S S
GLASS PANORAMIC ROOF (TOURER)
This device comprises a tinted glass
panoramic area 1 to improve bright-
ness and vision in the passenger
compartment.
It is fi tted with an electrical blind 2
to help maintain a comfortable tem-
perature and reduce noise. Opening

 Press control A .
Pressing to the 1st notch allows you
to open the blind step by step.
Pressing to the 2nd notch allows
you to fully open the blind.
The blind stops in the closest pre-
defi ned position (11 positions) as
soon as you release the control.
Closing

 Press control B .
Press to the fi rst notch to close the
blind step by step.
Press to the second notch to close
the blind completely.
The blind stops at the nearest pre-
set position (11 positions) as soon
as you release the control. After a battery disconnection, or if
there has been a malfunction, you
have to re-initialise the anti-pinch
function:

 press control B to the 2nd notch
(fully closed),

 wait until the blind is fully
closed,

 press control B for at least 3 sec-
onds.
If the blind opens randomly during a
closing operation, and straight after
the blind stops:

 Press control B until the blind
closes fully.

During these operations, the anti-
pinch function does not operate.
In the event of anything being
caught when the blind is moving,
you must reverse the movement of
the blind. To do so, reverse the po-
sition of the control.
When the driver is operating the
blind, he or she must always make
sure that the passengers are not
preventing it from closing properly.
The driver must ensure that his
passengers are using the blind cor-
rectly.
Pay special attention to children
when operating the blind.
Anti-pinch
If the blind meets an obstacle whilst
closing, it stops and opens partially
again.
You must re-initialise the anti-pinch
function within 5 seconds of the
blind stopping:

 press control B until the blind is
fully closed (closing in steps of a
few centimetres).
SEQUENTIAL ELECTRICAL BLIND

92
V I S I B I L I T Y
5
In permanent lighting mode, differ-
ent lighting times are available:
- with the ignition off, approxi-mately ten minutes,
- in energy economy mode, ap- proximately thirty seconds,
-
with the engine running, unlimited.
Map reading lamps

 With the ignition on, press the
corresponding switch. Panoramic glass roof rear
reading lamps (Tourer)
With the key in position or with the
ignition on:

 Press the corresponding switch.
The reading lamp concerned comes
on for ten minutes.
The rear reading lamps come on:
- when the key is removed from the ignition,
- when the vehicle is unlocked.
They switch off gradually:
- when the vehicle is locked,
- when the ignition is switched on.

93
V I S I B I L I T Y
5
AMBIENT LIGHTING
Your vehicle is equipped with warm
and welcoming ambient lighting.
A soft orange light is emitted.
Operation
When starting the engine, with the
vehicle lighting on, lamps located
along the dashboard are activated. Central console
The lamps are located on the roof
console, near the front interior lamp.
They light up the central console.
DOOR LIGHTING
Door opening controls
lighting
Dashboard
Operation
These lamps are activated with the
automatic switching on of the lamps,
when the exterior light is poor. They
are deactivated when the instrument
panel goes out.
The intensity of the lighting varies along
with that of the instrument panel.

 Press buttons A to increase or re-
duce the intensity of the lighting. They are located on the front and
rear interior door opening controls.
The rear door opening controls light-
ing is deactivated if child safety is
activated.

93
V I S I B I L I T Y
5
AMBIENT LIGHTING
Your vehicle is equipped with warm
and welcoming ambient lighting.
A soft orange light is emitted.
Operation
When starting the engine, with the
vehicle lighting on, lamps located
along the dashboard are activated. Central console
The lamps are located on the roof
console, near the front interior lamp.
They light up the central console.
DOOR LIGHTING
Door opening controls
lighting
Dashboard
Operation
These lamps are activated with the
automatic switching on of the lamps,
when the exterior light is poor. They
are deactivated when the instrument
panel goes out.
The intensity of the lighting varies along
with that of the instrument panel.

 Press buttons A to increase or re-
duce the intensity of the lighting. They are located on the front and
rear interior door opening controls.
The rear door opening controls light-
ing is deactivated if child safety is
activated.

94
V I S I B I L I T Y
5
Front door storage pockets
automatic lighting
A white light is emitted to light up the
door storage pockets.
Operation
The lighting comes on automatically
when you place your hand inside
the storage pocket. It goes out a
few seconds after you remove your
hand. WELCOME LIGHTING
With the door open, this lights up the
ground next to the vehicle.
Floor lighting
In the front and the rear of the ve-
hicle, when a door is opened, this
lights up the interior of the vehicle.
The welcome lighting is made up of:
- The interior (roof) lamps.
- The fl oor lighting.
- The pavement lighting when a
door is open.
Pavement lighting

94
V I S I B I L I T Y
5
Front door storage pockets
automatic lighting
A white light is emitted to light up the
door storage pockets.
Operation
The lighting comes on automatically
when you place your hand inside
the storage pocket. It goes out a
few seconds after you remove your
hand. WELCOME LIGHTING
With the door open, this lights up the
ground next to the vehicle.
Floor lighting
In the front and the rear of the ve-
hicle, when a door is opened, this
lights up the interior of the vehicle.
The welcome lighting is made up of:
- The interior (roof) lamps.
- The fl oor lighting.
- The pavement lighting when a
door is open.
Pavement lighting

100
6
L A Y O U T
LUGGAGE COVER (TOURER)
To roll up

 Press the handle (PRESS) gently.
The luggage cover rolls up auto-
matically.
The moving part A can be folded
along the rear bench seat backrest.
To remove

 Compress the control 1 and lift
the luggage cover on the right
then on the left to remove it.
To install

 Position the left-hand end of the
luggage cover roller in its loca-
tion B behind the rear bench
seat.

 Compress the roller control 1
and put the roller in place in its
location C on the right.

 Release the control to secure
the luggage cover.

 Unroll it to its fastening on the
rear pillar. High load retaining net
(Tourer)
Hooked onto the special upper and
lower fi xings, this permits use of the
entire loading volume up to the roof:
- behind the rear seats (row 2),
- behind the front seats (row 1)
when the rear seats are folded.
When positioning the net, check that
the strap loops are visible from the
boot; this will make slackening or
tightening easier.