Citroen C6 2007 1.G Owner's Guide
Page 31 of 216
34
II
1
R E A R V I E W M I R R O R S
ELECTRIC EXTERIOR REAR VIEW MIRRORS (CONTINUED)
In reverse gear: adjustment of the indexed positions for the passenger’s and driver’s rear view mirrors
With the engine running:1. S e l e c t t h e ( d r i v e r ' s o r p a s s e n g e r ' s ) r e a r v i e w m i r r o r u s i n g c o n t r o l 1.2. Engage reverse gear, the mirror glass automatically positions itself to improve your vision of the pavement.3. If necessary, adjust the mirror to your preference using the electric con-trol.
Deactivation of the rear view mirror indexing function
To deactivate the function, move control 1 to the central position.
Page 32 of 216
35
II
A
W I N D O W S
After a battery disconnection or if there has been a malfunction, you have to reinitialise the anti-pinch function for each window:Lower the window fully using Lowerthe control, then close. It will rise only a few centimetres. Press repeatedly on the control until the window is fully closed.
Keep the control pressed for at least a few seconds after the window has fully closed.
WARNING
During this operation, the anti-pinch protection does not work.
Page 33 of 216
36
II
13
24
A
B
S P E E D L I M I T E R
SELECTION OF THE SPEED LIMITER
To select the speed limiter, press on button 1 to display in zone A of your instrument panel the symbol B for the speed limiter.
The last speed memorised is also displayed.
TO ADJUST THE MAXIMUM SPEED
Provided the engine is running, you can select your maximum speed, with short or long presses on:Button 3 to increase the speed or
Button 4 to decrease the speed.
Remark:
Successive presses will allow to modify the speed in steps of 1 km / h (1 m p h ) a n d a c o n t i n u o u s p r e s s i n s t e p s o f 5 k m / h ( 3 m p h ) .
ACTIVATION OF THE MAXIMUM SPEED
When the desired maximum speed is displayed, press button 2 to activate the speed limiter.
Page 34 of 216
37
II
S P E E D L I M I T E R
DEACTIVATION
To deactivate the maximum speed, press button 2.
The information “OFF” will appear in the instrument panel.
This action does not cancel the memorised speed, which remains displayed in the instrument panel.
TEMPORARY OVERRIDE OF THE MAXIMUM SPEED
The accelerator pedal has a switch at the end of its travel. By pressing the pedal hard down to activate this switch at any time you can go faster than the memorised maximum speed.
D u r i n g t h e t i m e t h e l i m i t s p e e d i s b e i n g e x c e e d e d , t h e d i s p l a y e d s p e e d fl a s h e s .
You have only to release the accelerator pedal to return belo w the maximum speed, to restore the function.Note: If during speed limitation the system cannot keep to the maximu m speed (especially on a steep descent or if y o u a c c e l e r a t e t o o h a r d ) , t h e s p e e d fl a s h e s . A d a p t y o u r s p e e d a s n e c e s s a r y .
The function will re-engage when your speed has returned below the desired maximum.
TO CANCEL THE FUNCTIONGive a long press on button 1.
Or stop the engine.Or
The speed that you chose is memorised. The information disappea rs from the instrument panel.
I f t h e r e i s a m a l f u n c t i o n , t h e m e m o r i s e d s p e e d w i l l fl a s h a n d t h e w a r n i n g l a m p “OFF” will come on permanently in the display.
Contact a CITROËN dealer.
Page 35 of 216
38
II
0
0
13
24
A
C
C R U I S E C O N T R O L
SELECTION OF CRUISE CONTROL
This driving assistance function allows you to drive at the speed of your choice without the need to action the accelerator.
Cruise control is available in the higher gears only, for speeds greater than 40 km/h (24 mph).Note: Information relating to the cruise control is displayed in zone A of your instrument panel.
To activate cruise control, press button 1 to display in zone Aof your instrument panel the symbol C for cruise control.
The cruise speed is then memorised. The cruise speed will be displayed in zone A in the instrument panel.
At the time you select the function, no cruise speed has yet been memorised.
TO SELECT A CRUISE SPEED
Accelerate to the desired speed, then give a short press on button 3 or button 4.
You can then release the accelerator pedal. The vehicle will automatically keep to that chosen speed.Note: The vehicle speed may vary slightly from that memorised.
Temporary override of the cruise speed
While cruise control is in operation, it is always possible to go above the cruise speed simply by pressing the accelerator pedal (for example to over- t a k e a n o t h e r v e h i c l e ) . T h e s p e e d d i s p l a y e d fl a s h e s . Y o u h a v e o n l y t o r e l e a s e the accelerator pedal to return to your cruise speed.Note: If during cruise control the system cannot keep to the cruise speed ( e . g . o n a s t e e p d e s c e n t ) , t h e n t h e s p e e d fl a s h e s . I f n e c e s s a r y , b r a k e t o curb your speed.
Page 36 of 216
39
II
C R U I S E C O N T R O L
These actions bring up the information “OFF” in the instrument panel.
Adjustment of the memorised speed while cruise control is in operation
To adjust the memorised speed, displayed in zone A, press:Button 3 to increase the speed or
Button 4 to decrease the speed.
Remark: Successive presses will allow to modify the s p e e d i n s t e p s o f 1 k m / h ( 1 m p h ) a n d a c o n t i n u o u s p r e s s i n s t e p s o f 5 k m / h ( 3 m p h ) .
Deactivation of cruise control with memo-rised speed
You can deactivate cruise control:Either by pressing the brake pedal or the clutch Eitherpedal.
Or by the OrESP or ASR systems being active.Or by pressing button Or2.Note: Cruise control is deactivated if the gear lever is in neutral (position N).
Page 37 of 216
40
II
ABDC
R E M O T E C O N T R O L
Note:The simultaneous use of other high frequency equipment (mobile telephones, domestic alarms, etc.) may momentar-ily hinder the operation of the remote control.
If there is a permanent fault, the Ifremote control has to be reini- t i a l i s e d . S e e “