FORD E SERIES 2015 4.G Manual Online

Page 81 of 360

Maintenance
MessagesAction / Description
ENGINE OIL
CHANGE SOONDisplayed when the engine oil life remaining is
between 5% and 0%.
OIL CHANGE
REQUIREDDisplayed when the oil life left reaches 0%.
OIL LIFE OK displays after you have changed
the oil.
Tire Messages Action / Description
LOW TIRE
PRESSUREDisplays when one or more tires on your
vehicle have low tire pressure.
TIRE PRESSURE
MONITOR FAULTDisplays when the tire pressure monitoring
system is malfunctioning. If the warning stays
on or continues to come on, contact your
authorized dealer.
TIRE PRESSURE
SENSOR FAULTDisplayed when a tire pressure sensor is
malfunctioning, or your spare tire is in use.
For more information on how the system
operates under these conditions refer to the
Tire Pressure Monitoring Systemin the
Wheels and Tireschapter for more
information. If the warning stays on or
continues to come on, contact your authorized
dealer as soon as possible.
80Information Displays
2015 Econoline(eco)
Owners Guide gf, 1st Printing, June 2014
USA(fus)

Page 82 of 360

Trailer Messages Action / Description
TRAILER BRAKE
MODULE FAULTDisplayed and accompanied by a single chime,
in response to faults sensed by the TBC. Refer
toTrailer towingin theTowingchapter for
more information.
TRAILER
CONNECTEDDisplayed when a correct trailer connection
(a trailer with electric trailer brakes) is sensed
during a given ignition cycle.
TRAILER
DISCONNECTEDDisplayed when a trailer connection becomes
disconnected, either intentionally or
unintentionally, and has been sensed during a
given ignition cycle. Disregard this status if
your vehicle is not equipped with a factory
installed trailer brake controller. This message
may appear when an aftermarket TBC is used
even when the trailer is connected.
WIRING FAULT ON
TRAILERDisplayed if there are certain faults in the
vehicle wiring and trailer wiring/brake system.
Refer toTrailer towingin theTowing
chapter for more information.
Information Displays81
2015 Econoline(eco)
Owners Guide gf, 1st Printing, June 2014
USA(fus)

Page 83 of 360

HEATER ONLY SYSTEM
A.Fan speed control:Controls the volume of air circulated in your
vehicle. Adjust to select the desired fan speed.
B.Temperature control:Controls the temperature of the airflow in
your vehicle. Adjust to select the desired temperature.
C.Air distribution control:Turn the control to direct airflow from the
windshield, instrument panel, or floor vents. The system can distribute
air through any combination of these vents.
•VENT:Select to distribute air through the instrument panel air vents.
•FLR:Select to distribute air through the floor vents.
•OFF:Select to turn the system off.
•MIX:Select to distribute air through the instrument panel and floor
air vents.
Select to distribute air to the windshield vents and de-mister.
Air distribution to instrument panel and floor vents turn off.
You can use this setting to defog and clear the windshield of a
thin covering of ice.
HI
LO
COOL WARMVENTFLROFF
MIX FAN
ABC
82Climate Control
2015 Econoline(eco)
Owners Guide gf, 1st Printing, June 2014
USA(fus)

Page 84 of 360

MANUAL CLIMATE CONTROL
A.Fan speed control:Controls the volume of air circulated in your
vehicle. Adjust to select the desired fan speed.
B.Temperature control:Controls the temperature of the airflow in
your vehicle. Adjust to select the desired temperature.
C.Air distribution control:Turn the control to direct airflow from the
windshield, instrument panel, or floor vents. The system can distribute
air through any combination of these vents.
•MAX A/C:Select to maximize cooling. Recirculated air flows through
the instrument panel vents, air conditioning automatically turns on,
and the fan automatically adjusts to the highest speed.
•NORM A/C:Select to turn air conditioning compressor on or off. Use
air conditioning with recirculated air to improve cooling performance
and efficiency.
•VENT:Select to distribute air through the instrument panel air vents.
•OFF:Select to turn the system off.
•FLR:Select to distribute air through the floor vents.
•MIX:Select to distribute air through the instrument panel and floor
air vents.
Select to distribute air to the windshield vents and de-mister.
Air distribution to instrument panel and floor vents turn off.
You can use this setting to defog and clear the windshield of a
thin covering of ice.
HI
LO
COOL WARMVENT
NORM
A/C
MAX
A/COFF
MIX FLR FAN
ABC
Climate Control83
2015 Econoline(eco)
Owners Guide gf, 1st Printing, June 2014
USA(fus)

Page 85 of 360

REAR FAN SPEED CONTROL (IF EQUIPPED)
Controls the volume of air circulated in the rear of your vehicle.
Adjust to select the desired fan speed or switch off.
HINTS ON CONTROLLING THE INTERIOR CLIMATE
General Hints
Note:You may feel a small amount of air from the floor air vents
regardless of the air distribution setting.
Note:To reduce humidity build-up inside your vehicle, do not drive with
the system switched off.
Note:Do not place objects under the front seats as this may interfere
with the airflow to the rear seats.
Note:Remove any snow, ice or leaves from the air intake area at the
base of the windshield.
Note:To reduce fogging of the windshield during humid weather,
adjust the air distribution control to the windshield air vents position.
Increase the temperature and fan speed to improve clearing, if required.
Heating the Interior Quickly
1 Adjust the fan speed to the highest speed setting.
2 Adjust the temperature control to the highest setting.
3 SelectFLRusing the air distribution control.
REAR
HI
LO
OFF
84Climate Control
2015 Econoline(eco)
Owners Guide gf, 1st Printing, June 2014
USA(fus)

Page 86 of 360

Recommended Settings for Heating
1 Adjust the fan speed to the center setting.
2 Adjust the temperature control to the midway point of the hot
settings.
3 SelectMIXusing the air distribution control.
Cooling the Interior Quickly
1 Adjust the fan speed toHI.
2 Adjust the temperature control toCOOL.
3 SelectMAX A/Cusing the air distribution control.
Recommended Settings for Cooling
1 Adjust the fan speed to the second speed setting.
2 Adjust the temperature control to the midway point of the
cold settings.
3 SelectNORM A/Cusing the air distribution control.
Vehicle Stationary for Extended Periods during Extreme High
Ambient Temperatures
1 Apply the parking brake.
2 Place the transmission in positionP.
3 SelectMAX A/Cusing the air distribution control.
4 Adjust the fan speed toLO.
Side Window Defogging in Cold Weather
1 Adjust the air distribution control toNORM A/C.
2 Adjust the temperature control to the desired setting.
3 Adjust the fan speed toHI.
4 Direct the instrument panel side air vents toward the side
windows.
5 Close the instrument panel vents.
Climate Control85
2015 Econoline(eco)
Owners Guide gf, 1st Printing, June 2014
USA(fus)

Page 87 of 360

SITTING IN THE CORRECT POSITION
WARNING:Sitting improperly out of position or with the
seatback reclined too far can take off weight from the seat
cushion and affect the passenger sensing system, resulting in serious
injury or death in a crash. Always sit upright against your seatback,
with your feet on the floor.
WARNING:Do not recline the seatback as this can cause the
occupant to slide under the seat’s safety belt, resulting in severe
personal injury in the event of a crash.
WARNING:Do not place objects higher than the seatbacks to
reduce the risk of injury in a crash or during heavy braking or
when stopping suddenly.
When you use them properly, the
seat, head restraint, safety belt and
airbags will provide optimum
protection in the event of a crash.
We recommend that you follow
these guidelines:
•Do not recline the seatback more
than 30 degrees from vertical.
•Sit in an upright position with the
base of your spine as far back as
possible.
•Adjust the head restraint so that the top of it is level with the top of
your head and as far forward as possible, remaining comfortable.
•Keep sufficient distance between yourself and the steering wheel.
We recommend a minimum of 10 inches (25 centimeters) between
your breastbone and the airbag cover.
•Hold the steering wheel with your arms slightly bent.
86Seats
2015 Econoline(eco)
Owners Guide gf, 1st Printing, June 2014
USA(fus)

Page 88 of 360

•Bend your legs slightly so that you can press the pedals fully.
•Position the shoulder strap of the safety belt over the center of your
shoulder and position the lap strap tightly across your hips.
Make sure that your driving position is comfortable and that you can
maintain full control of your vehicle.
HEAD RESTRAINTS
WARNING:To minimize the risk of neck injury in the event of a
crash, the driver and passenger occupants should not sit in and
operate the vehicle until the seatback is placed in its proper position.
The driver should never adjust the head restraint while the vehicle is
in motion.
The front row outboard
non-adjustable head restraints
consist of a trimmed foam covering
over the upper structure of the
seatback. Properly adjust the
seatback to an upright driving or
riding position, so that the head
restraint is positioned as close as
possible to the back of your head.
MANUAL SEATS
WARNING:Do not adjust the driver seat or seatback when your
vehicle is moving. This may result in sudden seat movement,
causing loss of control of your vehicle.
WARNING:Rock the seat backward and forward after releasing
the lever to make sure that it is fully engaged.
Seats87
2015 Econoline(eco)
Owners Guide gf, 1st Printing, June 2014
USA(fus)

Page 89 of 360

Moving the Seats Backward
and Forward (If Equipped)
Recline Adjustment
(If Equipped)
WARNING:Before returning the seatback to its original position,
make sure that cargo or any objects are not trapped behind the
seatback. After returning the seat back to its original position, pull on
the seatback to make sure that it has fully latched. An unlatched seat
may become dangerous in the event of a sudden stop or crash.
Manual Lumbar (If Equipped)
The lumbar support control is located on the inboard side of the driver
seat. Turn the control to adjust your support.
88Seats
2015 Econoline(eco)
Owners Guide gf, 1st Printing, June 2014
USA(fus)

Page 90 of 360

POWER SEATS
WARNING:Do not adjust the driver seat while the vehicle is
moving. This may result in sudden seat movement, causing loss
of control of your vehicle.
The control is located on the outboard side of the seat cushion.
Press A to raise or lower the front
portion of the seat cushion.
Press B to move the seat forward,
backward, up or down.
Press C to raise or lower the rear
portion of the seat cushion.
Recline Adjustment (If Equipped)
ABC
Seats89
2015 Econoline(eco)
Owners Guide gf, 1st Printing, June 2014
USA(fus)

Page:   < prev 1-10 ... 41-50 51-60 61-70 71-80 81-90 91-100 101-110 111-120 121-130 ... 360 next >